How to test a EZGO controller. Connect the battery pack negative post to the negative of the meter probe. Connect the battery pack positive post to the positive of the meter probe. Switch on and then put the gear in forward, and then put the positive of the meter probe on the solenoid’s battery side.
Full Answer
What kind of engine does an EZGO marathon golf cart have?
It was a 9 hp – 295 cc engine that just performed great and was used in all Marathon models. Though with the demand for more power apparent in golf carts and utility vehicles, it was soon to be replaced with a 350 cc version introduced in the Medalist model golf cart. The Ezgo Medalist Model Golf Cart (1993 -1995)
How do I know what model of EZGO golf cart I have?
Alot of the newer carts will have stickers on the factory body to help you distinguish your model. You can also take a look at the pictures and images below to help determine what you have. These are the most popular Ezgo golf cart models offered over the years. So you own a Ezgo golf cart do ya…
How do you test a Pulser coil on an EZGO golf cart?
How to test a pulser coil on an EZGO golf cart A voltmeter can be used to test the pulser coil or the igniter of a golf cart. This will tell you if the coils are damaged or there is some other larger problem hidden underneath the golf cart. Check the user manual to know the exact location of the pulser coil under the seat.
How to troubleshoot the controller of an EZGO?
Follow these steps to troubleshoot the controller of an EZGO: When the cart is to be serviced or the controller needs troubleshooting, the maintenance switch under the seat needs to be flipped. Flip the switch and turn the tow maintenance mode on. Now, take the negative battery cable (black) and disconnect it.
How do I test my EZGO Marathon controller?
Connect the negative probe to the controller's M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor.
How do you test a controller on a golf cart?
To test a club car precedent controller, connect a voltmeter between the negative terminal of your cart's battery and the M terminal on the controller. Then push the pedal down and look for a clicking noise from the solenoid. Your batteries should read as full.
How do I troubleshoot my EZGO controller?
Check your connections Check out all the wires and make sure the connections are firm. Sometimes the problem can be as simple as some loose wiring and all you need to do is make sure everything is plugged in tight. Also check for any breaks or corrosion in your wires that signify it may be time to replace them.
How do I check the speed controller on my electric golf cart?
1:142:12How to bench check curtis controller and golf cart motor - YouTubeYouTubeStart of suggested clipEnd of suggested clipThen you go over here. And you take your battery string whatever battery string you have. And youMoreThen you go over here. And you take your battery string whatever battery string you have. And you just hook it up to that negative and then just tap that positive first make sure because you don't
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
How can I test my speed controller?
0:395:30Testing controller for blown mosfetts - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe start by connecting one of the probe to the ground wire of the controller. And you take theMoreWe start by connecting one of the probe to the ground wire of the controller. And you take the positive probe.
How do I fix my golf cart controller?
Steps to repair the controller are: Check the wires and cables that go to the controller. If the wires look like they have corroded, scrub them. Check if they are still intact and if not, simply replace them. Check the solenoid and if the solenoid is not working, replace it too.
How do you bypass a golf cart controller?
1:594:09electric golf cart, simple Motor and controller bypass key hotwire direct ...YouTubeStart of suggested clipEnd of suggested clipSo let's just go ahead and bypass the solenoid by putting one alligator clip on that bolt.MoreSo let's just go ahead and bypass the solenoid by putting one alligator clip on that bolt.
Where is the reset button on a ezgo golf cart motor?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
Where is the speed sensor located on electric golf cart?
Typically, the speed sensor can be found on the backside of the motor. When removing the speed sensor, unplug all the cables that are on the backside of the motor. To do this, use a socket to take off the connector pigtail. Then, remove its plastic housing over the sensor.
How do I test my EZGO speed sensor?
The EZGO speed sensor can be tested by ensuring that the three-pin plug from the sensor is connected.Keep a wire-piercing probe over the output wire. This is usually green in color.Raise one of the wheels of the EZGO golf cart and give it one full rotation using your hand.Note the voltage reading of the cart.
What is the purpose of a golf cart pulser coil?
The purpose of the Pulser coil is to give ignition signals to the engine and ignition system. The resistance categorizes pulser coils.
How to remove coil from flywheel?
To remove the coil, the flywheel needs to be detached. Use a balance styled puller and attach the same to the threaded holes. Now add some pressure and let the puller do its job by removing the flywheel.
Is the Ping G25 adjustable?
Is the Ping G25 driver adjustable? The Ping G25 driver is adjustable. It’s possible to do four adjustments using the hosel adapter of the driver apart from the stated loft setting and...
When was the Ezgo Marathon Golf Cart made?
The Ezgo Marathon Model Golf Cart (1975 -1993 ) With great success and production numbers thus far for the company, the introduction of the Marathon model golf cart was bringing in a whole new era of golf carts and technology.
When was the first Ezgo golf cart made?
The first gas model Ezgo golf cart was produced in 1971. 1971 was great year for a lot of things with gas combustible engines. Ezgo was no exception. This was a milestone for them as it stood up until then all were strictly electric vehicles. Using a 175cc model 17-CES 1PG two cycle Robin version.
When did Billy and Ezgo leave Ezgo?
In the 1960’s they sold out to current owners Textron Company. The two brothers continued to work with Ezgo and Textron until 1978. Then Billy and a handful of employees decided to leave Ezgo to purchase Club Car at the time was located in Texas.
When did Ezgo golf carts start being battery powered?
All Ezgo golf carts where battery powered until 1971 when they introduced the first gas engine sourced from Fuji. To date they have produced millions of Gas or Electric vehicles most of which still in service today throughout the world.
When did Ezgo use the EC25?
The EC25-2PG engine model was used until 1988. Then in 1989 they used the EC25-3PG 244cc two stroke Robin engine model but only until 1993. In between then they developed another great little engine which was Ezgo’s first four stroke.
What engine did the EC25-DS have?
In 1976 they came out with a six head bolt model EC25-DS 244cc two stroke Robin engine also made by Fugi. This engine also had an internal starter/generator.
History of the E-Z-GO Golf Cart
EZGO was started by two brothers, Billie and Beverly Dolan, in 1954. Later on, they sold the company to the current owners, Textron Company. Both brothers continued to work with Textron until 1978. Currently, E-Z-GO headquarters is based in Augusta, Georgia.
List of EZGO Golf Cart Models
The 2Five model is an LSV designed to be street legal and comes with a title of ownership. This model is ready to make your life easy and fun. The 2Five golf cart is excellent for beach communities, side streets, and residential areas. The model offers balanced convenience, safety, and environmental responsibility.