Golf carts have reverse as a standard function. On a gas cart when you flip the reverse lever, the engine does not run backwards to go in reverse, but a series of gears will change the direction. In an electric golf cart, flipping the reverse switch will cause the motor to run backwards for reverse.
Full Answer
How do I switch between forward and reverse on a golf cart?
Golf carts have a button or lever that allows you to switch between forward and reverse gears. The reverse switch is found below the driver’s seat, and can be activated by pulling the handle left or right.
Why won’t my gas golf cart work in forward or reverse?
A surprisingly common problem with gas-powered golf carts is that they fail to work in forward or reverse. Why Won’t My Gas Golf Cart Work in Forward or Reverse? Most of the time golf carts won’t work in forward or reverse due to the shift cable being broken, electrical issues, ignition switch issues, or a too low idle speed.
How do I know if my golf cart has regenerative braking?
Regen Carts – “Golf Carts with regenerative braking systems.” 1 If you have a Run / Tow or Run / Maint. ... 2 If your golf cart motor has wires coming out the end and has a speed sensor it is a Regen Motor. 3 If your golf cart has a toggle switch for the Forward / Reverse Selector you have a regen cart More items...
What does the forward micro switch do on a golf cart?
The forward micro switch is what engages the activation circuit. So, when getting the cart in reverse, make sure that it closes. If the cart continues in the forward direction, then the issue is with the micro switch and not the controller that needs to be replaced.
How does reverse work on electric golf cart?
How does reverse work on a golf cart? Golf carts have a button or lever that allows you to switch between forward and reverse gears. The reverse switch is found below the driver's seat, and can be activated by pulling the handle left or right. Once pulled, the golf cart will start moving in reverse.
Why does my golf cart not go in reverse?
The simplest and most likely cause of reverse problems in a golf cart is a malfunctioning F&R switch. This switch – which stands for forward and reverse – is common on most golf carts and makes it easier for you to go forward and in reverse without requiring a lot of complex machinery or levers.
How does a forward reverse switch work on golf cart?
0:379:43Golf Cart Forward and Reverse Switch Direction Selector Tutorial - YouTubeYouTubeStart of suggested clipEnd of suggested clipThat is brand new it simply cables connect to the bright copper colored contacts. And the switchMoreThat is brand new it simply cables connect to the bright copper colored contacts. And the switch rotates through a hand action and that changes the polarity.
Why won't my ezgo golf cart go forward or reverse?
A EZGO golf cart may not go forward or reverse because of a malfunctioning microswitch, solenoid, or ignition switch. Loose or corroded cable connections or a faulty controller can also cause the golf cart to not move. Malfunctioning microswitch.
Why won't my Yamaha golf cart go forward or reverse?
The reason why your Yamaha G1 Golf cart is not moving forward is because a faulty solenoid. If your golf cart moves forward but not in reverse, you need to replace your solenoids.
Where is the reset button on a Club Car golf cart?
Identify your main battery supply (usually the largest battery) on your motor. Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor.
How does a golf cart transmission work?
1:143:28How a golf cart CVT slip drive clutch works - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd the rear drive clutch actually separates it widens causing the belt to drop down into the clutchMoreAnd the rear drive clutch actually separates it widens causing the belt to drop down into the clutch.
How do you test a forward forward switch on a golf cart?
Place your foot on the car's brake, insert the key, and put the forward-reverse key in the forward position. If you see that the solenoid charges up pushing the pedal, then your forward reverse switch is working fine. As you put your Golf Cart in the forward mode, check your multimeter for full voltage.
How do you test a golf cart switch?
Testing a Club Car Ignition SwitchFind the back and red wires on the back of your battery pack.Connect the black wire to the negative terminal and the red to the positive.Keep the cart turned off while you work on it.Check the wires with a probe meter while the cart is off – only one wire should have a charge.More items...
Does an electric golf cart have a transmission?
The 48 volt golf cars ( Club Car & Yamaha) uses 1/3 less amperage than the 36 volt system and are more efficient. Unlike your automobile, electric carts do not have a transmission or clutch.
How does an electric golf cart throttle work?
Just like the gas-powered car throttle, the throttle is an inductive sensor. It pushes the acceleration lever to send electricity to the solenoid and speed controller and drives the motor.
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
Where is the reverse switch on a golf cart?
If the golf cart starts beeping the minute you turn the key to the right, it's in reverse. To switch between forward and reverse, you need to locate the switch which is generally down the front side of the seat between the driver's and the passenger's lower legs.
How do you test the speed controller on a EZ Go golf cart?
Connect the negative probe to the controller's M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor.
How do you reverse in golf?
0:120:50How to shift into reverse on a Volkswagen - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd then up there is reverse again neutral position press down left and then up and there you haveMoreAnd then up there is reverse again neutral position press down left and then up and there you have reverse. One more time with a clutch depressed.
Where is the solenoid on a ezgo golf cart?
0:498:12How to Replace Golf Cart Solenoid Coil | Install - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis is not from one of the resistor set okay we've got this we've got the car let's get startedMoreThis is not from one of the resistor set okay we've got this we've got the car let's get started cylinder is located under this black box here on the passenger side of the car.
Loose Cables
Loose power cable connections are the primary culprit in the failure of traditional mechanical rotary style forward reverse switches. Power cables are the thicker, usually 6-gauge, cables that connect the forward reverse switches to the starter generator, in the case of 2-cycle gas golf carts.
OEM 6 Gauge
For most golfing applications 6-gauge cabling is adequate to the task of carrying two golfers and their two golf bags around the course, stopping every 200 yards or so while they play their next shot.
Upgrades
The larger diameter tires require more current (amps) to simply get the cart rolling. Added passengers mean more pay load demanding still more amps through the electrical system. Add a hilly or mountainous terrain and the amp draw just keeps getting higher.
Sepex Controllers
Many modern golf carts have an electronic speed controller that handles the forward and reverse switching function internally. These carts have a toggle switch of some design to change direction rather than the older mechanical rotary forward reverse switches common to many golf carts.
What is a regen golf cart?
If your golf cart motor has wires coming out the end and has a speed sensor it is a Regen Motor. If your golf cart has a toggle switch for the Forward / Reverse Selector you have a regen cart.
What motor do you have if you don't have wires?
If you do not have wires coming out the end of the motor or speed sensor you have plain motor or Series motor system. If your golf cart has a handle and throw lever for the Forward / Reverse Selector you have a Series Motor. Lastly if you are under the golf cart and you see two different sets of threaded anchor bolts but all are ...
