1992 Yamaha G-9 engine runs great but cart does not move in forward or reverse. Tightened accelerator cable as this has been the problem in the past when the cart does not move when gas pedal is depressed but it didn't work this time. Occasionally the cart will begin to move but less than a few inches and stops.
Full Answer
Why won’t my G29 Yamaha golf cart start?
Check if the Tow/Run switch is working fine in your G29 Yamaha golf cart. Replace if faulty. The problem could also be with the controller. Some experts think that faulty batteries are the main reason for G29 Yamaha golf carts not moving when started. With the batteries, there can be multiple issues. Keeping them charged to the full is important.
How do I know if my G9 Yamaha golf cart solenoid needs replacing?
Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced. You must be careful while doing this crude test; there could be sparks when the two terminals touch. You must test the battery voltage as well. The reading should be above the rating of the battery.
What kind of battery does a Yamaha G9 golf cart take?
If you have decided to replace the batteries, then Group 24 battery is recommended for the G9 Yamaha golf carts. The solenoid can be checked using an old screwdriver to jump the terminals. Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced.
Why does my Yamaha G16 golf cart keep running?
You might have loose wiring in the engine of your Yamaha G16 golf cart if it keeps running. You can check by following the following steps.
What causes a golf cart to stop running?
Check the batteries. Sometimes, one or both of the batteries could be dead making the cart cut off. Ensure that both the batteries are working fine and have enough water and electrolytes. If the batteries are dead, then replacing them will solve the issue.
How do you keep a Yamaha golf cart running?
Yamaha G16 golf cart won't stay runningCheck for a malfunctioning fuel line, fuel pump, or pickup tube in the carburetor, or if there is a problem with the gas tank. ... Check the battery posts and cables. ... Check the brushes on the stator. ... Check the fuel compression when the cart is in forward, reverse, and neutral modes.
How do I make my Yamaha golf cart idle?
0:523:44How to get your club car to idle - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe black wires gonna be on the bottom half down here you can't see it but just disconnect it onceMoreThe black wires gonna be on the bottom half down here you can't see it but just disconnect it once you disconnect that you're gonna have to get your flat-head screwdriver and turn up the idle.
What does a Yamaha golf cart stop switch do?
If your car won't start and you don't hear the solenoid click, the problem could be either this switch or the key switch. This is a replacement accelerator micro (stop) switch for use with gas and electric G14-G22 model Yamaha golf carts. As a safety mechanism, this switch kills the car when the pedal is released.
How can I make my Yamaha g9 golf cart faster?
0:291:37How to make your Yamaha Gas Golf Cart go faster. 2007-2018 - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou can bend the spring make it go a little faster.MoreYou can bend the spring make it go a little faster.
Can you make a gas golf cart idle?
Push the throttle cable toward the throttle valve body on the engine from the gas pedal position. Screw the throttle cable back in place on both the gas pedal and the throttle valve body on the engine. The golf cart will idle rather than shut off.
How do you make a Yamaha golf cart go faster?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How do you speed up a Yamaha electric golf cart?
0:452:57Yamaha G29/DRIVE Governor Speed Increase | ASK DAVE | Golf Cart ...YouTubeStart of suggested clipEnd of suggested clipCompartment. The throttle cable pulls the spring-loaded governor and the bolt on top that goesMoreCompartment. The throttle cable pulls the spring-loaded governor and the bolt on top that goes through the governor will determine just how much that cable can pull to speed up the engine.
How do you take the governor off a Yamaha golf cart?
General InstructionsDetach the cable from the carburetor. The cable is about the width of a straw. ... Follow the disconnected cable up to the governor. ... Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ... Using your wrench, remove the bolt on the gas pedal shaft.
Where is the micro switch on a Yamaha golf cart?
In a golf cart, you're going to find a large number of these switches throughout its build. For example, there is a micro switch located on the accelerator pedal. This switch activates when you push the pedal and sends a signal to the solenoid.
Where is the reset button on a Yamaha golf cart motor?
Expose the motor (you'll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected. Once you've pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run.
Where is the reset button on a Yamaha gas golf cart?
It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
What to do if your G9 golf cart is not clicking?
If you find your G9 Yamaha golf cart not starting nor clicking, check the key components for damage. If you find the parts to in good condition, check the brushes in the starter/generator.
How to check solenoid on G9 Yamaha?
The solenoid can be checked using an old screwdriver to jump the terminals. Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced. You must be careful while doing this crude test; there could be sparks when the two terminals touch.
Why is my Yamaha golf cart not moving?
The main cause of a Yamaha golf cart clicking but not moving, is a faulty controller or solenoid. The battery has to be checked first to see if it’s delivering the right voltage while in the idle state as well as when the pedal is pressed. There can be other reasons for the Yamaha golf cart not moving though you hear the click.
Why is my solenoid not clicking?
The reason why the solenoid is not clicking could be that it is faulty or has no grounding. Experts recommend checking all wiring and cable connections to rule out this possibility. Batteries on your G16 Yamaha golf carts should raise sufficient power to reach the solenoid and the starter/generator.
How to troubleshoot a G9 controller?
Here are some easy steps for troubleshooting the G9 controller: Check the controller’s body to locate any major defects such as cracks, scratches, or black marks. If these are found, then replace the controller immediately. If no major defects are found, then check the wiring.
Why is my Yamaha golf cart controller so hot?
The primary reason why a Yamaha golf cart controller gets too hot is because of overuse. When the golf cart is used for long periods of time, the controller can start overheating. The driving surface might also be a cause of heating. If driving on a straight and soft surface, the problem of heating should not occur.
What to do if your golf cart controller does not increase?
If it does not increase, then there is a problem with the controller or the batteries. Examine the batteries and check if they are dead. If dead, replace them. Examine the controller, as discussed in the previous sections. Remember to always consult a mechanic to have your golf cart controller repaired.
What are the problems with a Yamaha G22?
Yamaha G22 also faces similar problems like G9 and G16. Overheating, battery faults, wiring issues, voltage issues are some problems that might occur with your Yamaha G22. To avoid these problems, test the golf cart’s major components connected to the controller regularly.
How to test Yamaha G16?
To test the Yamaha g16’s speed controller, check the voltage reading while pressing the accelerator. Test other components such as the batteries, the charger, and the solenoid for their smooth functioning. If any of these components do not work as expected, then you need to replace them.
Why is it important to troubleshoot a golf cart controller?
Troubleshooting the controller is extremely important for the golf cart’s smooth functioning. Generally, controllers face major issues only when there is a problem with wires or defects on the controller itself, such as marks or cracks.
Why is my golf cart not heating?
If driving on a straight and soft surface, the problem of heating should not occur. But, if driven on uneven or steep surfaces , there are chances of heating. Another reason could be the brakes. It is essential to check if the brakes are dragging while the golf cart controller is driven.