E-Z-Go gas cart Starter/Generator and Voltage Regulator. When the solenoid is energized through the logic switches (Key Switch and Accelerator Switch), current flows from B+ through the solenoid, to F2 of the Starter/Generator, though the field winding to F1, through the strap, to A2, through the armature to A1 to ground.
Full Answer
Which EZ-GO golf cart do I have?
Which Model Do I Have? Most EZ-Go golf carts will have the model name somewhere on the cart; however, in general, if your cart was manufactured between 1976-1993, you have a Marathon. If the model was manufactured in 1994-1995 it will be a Medalist.
Where can I buy EZGO RXV parts?
The Golf Cart Tire Supply carries thousands of EZ-GO Golf Cart Accessories and Parts for all EZ-GO model golf carts including EZGO TXT Accessories, EZGO RXV Accessories, EZGO TXT Parts , EZGO RXV Parts and more at the best prices online!
What does the EZGO controller do?
Acceleration: The controller controls the speed of the vehicle. It also regulates the speed when you apply full throttle to the cart. Battery health maintenance: The controller makes sure that the battery is working well and is not overloaded. Parameter setup: The controller operates the EZGO cart as efficiently as it controls the speed parameters.
What is the forward/reverse switch on an EZGO golf cart?
The Forward/Reverse switch carries the brunt of transmitting power from the battery to the motor. Over time it can become worn out and its contacts can burn. If this is the case you’ll need to have a certified technician to replace it with a new one that is made specifically for the EZGO TXT Golf Cart.
How does a golf cart electrical system work?
The electric motor receives electric current through the electrical system to move faster or slow down. When the electric motor receives the electric current, it turns the wheel to get the golf cart to move. The more current it produces, the faster it turns!
How do I know if my EZGO charger is working?
Use your voltmeter to test the positive end of the charger handle. Press the other end to the negative line coming in (near the fuse). This is just one last check to be sure, since often the handle of the E-Z-Go Powerwise Charger is where people tend to have issues.
What does EZGO controller do?
Known as the heart of the EZGO golf cart, the controller's core objective is to control the speed of the golf cart. It is a needed component in a AC and brushless DC motor. Without the controller, the golf cart will not work.
How do you test a EZ Go golf cart control box?
Check Power Output From the Controller Connect the negative probe to the controller's M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery.
Should I leave my golf cart plugged in all the time?
Manufacturers suggest leaving your golf cart plugged in all of the time while using an auto battery charger, as it will keep the batteries fully charged and always available. If batteries are not charged for prolonged storage, they may damage over time and deliver less capacity.
How do I know if my golf cart is charging?
1:564:02How Do I Read My Golf Cart Charger? | ASK DAVE - YouTubeYouTubeStart of suggested clipEnd of suggested clipOff if you're using a more modern style charger like this one you'll find led indicator lights toMoreOff if you're using a more modern style charger like this one you'll find led indicator lights to show that charging is in progress depending on the make.
How do I know if my speed controller is bad on my golf cart?
When your golf cart's speed controller isn't operating correctly, your cart will show it by running erratically or failing to drive at one constant speed. If your cart starts showing these symptoms, the first thing you should look at is your speed controller.
What controls the speed on a golf cart?
Essentially, your golf cart's speed controller sends its current and battery voltage to its motor. This process depends on your golf cart's input device, which includes its throttle. That's how your golf cart's speed controller lets you operate its acceleration rate, as well as its deceleration rate.
How do you change the speed on a EZGO electric golf cart?
Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.
Why does my ezgo golf cart not move?
The main reason why a EZGO gas golf cart will not go forward is because of a locked up brake, or a faulty solenoid and accelerator. A defective Run/Tow or Forward/Reverse switch can also cause a EZGO to not move forward.
Where is the reset button on a ezgo golf cart motor?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
How do I test my EZGO sensor?
Take a digital multimeter and set it to the volts reading. Place the positive probe of the meter on the white wire terminal of the ITS. Release the accelerator pedal slowly. The reading should be in the 0.45V to 0.53V range when the micro-switch gets activated.
How can I tell if my golf cart charger is bad?
Bad Charger: IN GENERAL, if the charger kicks on, but doesn't charge fully or kicks off soon after, this is likely a charger issue. If the charger makes a loud clicking noise, this is likely a battery charger issue.
Why is my EZGO charger not working?
Some reasons why an EZGO RXV golf cart will not charge could be because of a dirty charging port, loose or broken wire, a blown-out fuse or a problem with the auxiliary contact. Clean the charging port so that it's free of dust and dirt accumulation. Sometimes, dust and dirt can prevent proper charging.
How does EZGO battery charger work?
In the case of an E-Z-GO Powerwise charger, the logic board is actually powered by the DC voltage from the golf car. If there is no voltage in the batteries, the logic board does not even activate. In a normal situation, the logic board gets its current from the cart through the small red wire in the DC power cord.
How do you troubleshoot a golf cart charger?
1:103:54Golf Cart Charger Troubleshooting Guide | ASK DAVE - YouTubeYouTubeStart of suggested clipEnd of suggested clipTest good first off the most common issue when a charger doesn't engage is dead batteries golf cartMoreTest good first off the most common issue when a charger doesn't engage is dead batteries golf cart chargers start automatically by receiving voltage from your cart.
What is an EZGO golf cart?
Your EZGO golf cart is probably a more integral part of your life than you realize. If you live in a residential neighborhood or gated community, chances are that you use your golf cart for a wide variety of purposes beyond simply golfing―to take a trip to the nearby grocery store, to drive a mile or two to the country club or tennis courts down the road, to act as a makeshift hunting vehicle during hunting season, or even to fetch your mail in rainy or snowy weather.
What is the recommended tire pressure for an EZGO golf cart?
The standard recommended pressure of an EZGO cart’s tires ranges from 18 to 22 PSI.
What does the Ezgo manual say about golf cart batteries?
The EZGO manual says that, “First, a battery that performs poorly and is outside of the manufacturer’s specification should be identified in order to replace it under the terms of the manufacturer’s warranty.” This means that every manufacturer retains its own unique requirements, specs, and timelines. The less you procrastinate on troubleshooting your golf cart, the easier it will be to get faulty items repaired or replaced.
How many cycles does a golf cart battery take?
Your golf cart’s battery needs to mature completely before it can operate at its maximum levels. This can take as many as 100 full charge cycles, so be patient if the brand new golf cart you just purchased isn’t quite living up to its battery expectations.
How to tow a sandbox?
You should also make sure to raise the drive tires off the ground.The next step is to make sure that all your switches are in order. Flip the Tow / Run switch into “Run” when troubleshooting battery problems, or on “Tow” if you are taking a look at other issues, such as with the speed controller. Make sure that your key switch is turned ON; next, place the Forward / Reverse selector on FORWARD and place the pedal switch so that it is fully accelerating.
How to reset a golf cart motor?
This panel door is generally secured with several screws . Carefully remove them with a screwdriver. Then reset your cart’s motor; most golf cart electric motors contain a special button designed to reset the motor by behaving like a tiny circuit breaker.
Why is my golf cart foot pedal so smooth?
If you are having issues with the smoothness of your foot pedal, it may simply be due to the air quality of your surroundings and should eventually fix itself. If your golf cart is a few months or years old, the stickiness may be due to constant pressure.
Why Won’t My EZGO Golf Cart Start?
EZGO golf carts may not start due to a transmission problem, corroded battery terminals or a faulty wiring coming from the ignition.
Why won't my EZGO RXV move?
Brake Problems: Many times the reason your RXV won’t move is because of brake problems. The RXV is designed to be disabled when there is a problem with the break. Many times, the wiring that connects the brakes to the controller gets loose or is damaged. This can disable your EZGO RXV.
How to unclog a golf cart muffler?
To unclog it, simply make a fire and remove your muffler and put it there.
What to do if replacing ignition wire doesn't work?
To check the continuity of the ignition wire you’ll need to use an ohmmeter or a continuity tester. To do this, set the switch to off and set your ohmmeter to X1.
Why does my golf cart make a clicking noise?
When you press your golf cart pedal you should hear a clicking noise, if you don’t hear a clicking noise there might be a problem with the solenoid. To make sure your solenoid is functioning properly check it with a voltmeter. If you hear a click then you need to check its power with the voltmeter.
Why is my golf cart ignitor failing?
The most common reason for a failed ignitor is a bad voltage regulator. Therefore, when you replace or fix the ignitor on your golf cart, make sure you also check the voltage regulator and see if it needs to be replaced. There have also been cases where the battery has switch polarity for some reason.
What do you need to troubleshoot a golf cart?
While both types of golf cart are different, there are two things you need to troubleshoot whether you have a gasoline or an electric golf cart; the fuse and ignition.
What is an EZGO golf cart?
EZGO golf carts are known for their quality design and reliability since all the way back in the 1950s - and are the golf cart brand of choice for many of the most prestigious golf courses in the world! While EZ-GO golf cars are great for the golf course, they can be used and enjoyed in many other ways for all sorts of other driving activities, recreation and light transportation. These golf carts can handle many terrain types, and can be modified and customized to become even more capable than they are from the factory! EZGO vehicles are designed and manufactured by Textron, an award winning manufacturer responsible for the performance specialty vehicle brands: Arctic Cat, Jacobsen, Cushman and Textron GSE - all of which are leaders in the respective industries they serve.
Can you upgrade an EZGO golf cart?
If you're looking to upgrade your cart with new EZGO golf cart accessories, you have come to the best place to do it! As long as EZGO golf carts have been around, aftermarket companies have been creating high-quality EZGO accessories for each and every model!
How does a pedal box work?
Basically, when you press down on the pedal, a metal rod is inserted into the sensor coil in the pedal box, changing the inductance of the coil, which reduces the voltage signal sent through it . This varying voltage signal tells the controller how much current the driver wants passed to the motor.
What is the purpose of having the solenoid engaged?
The purpose of having the solenoid engaged is to send current through the solenoid mains from battery B+ to controller B+.
What is the use of meter neg. probe on the B terminal?
With meter neg. probe on the B- terminal, use the positive lead to probe the white wire in the controller main molex connector.
What is a micro switch?
The micro switches are simple 2 wire on/off switches. They open and close mechanically.
Why do no go carts have to be up off the floor?
Anytime you are testing a no go cart it must be up off the floor in the rear because it may start unexpectedly while testing which may cause body and property damage.
Where to stop when you find battery pack voltage?
Stop at the point where you find the battery pack voltage and the problem will be between there and the last place checked that didn't have it.
Can you disconnect a switch with a multimeter?
With the multi-meter set to continuity or ohms you can disconnect both sides of the switch and connect it to the meter. The meter will show the connection making and breaking. If not check meter settings and test a different switch. Once you are certain your test method is correct retest the switch in question.
What year was the EZ Go golf cart made?
The last two numbers of the manufacturer’s code is the model year of your EZ-GO golf cart manufactured from 1979 & up (it's the first two numbers if manufactured from 1976-1978).
Where is Freedom RXV on EZ Go?
On many of the newer EZ-GO's, they will have the words "TXT", "Freedom TXT", "RXV" or "Freedom RXV" listed on the side of your golf cart.
Can you add videos to your watch history?
Videos you watch may be added to the TV's watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
