What to do if your EZGO RXV won’t move?
Replacing the brake will be the solution; try it. Replacing the RCM unit has produced the desired results in 2010 EZGO RXV golf carts which had the same ‘clicks but won’t move’ problem. A bad drive motor could also be causing trouble. To find this out, you have to check the battery pack voltage.
Why won’t my EZGO golf cart move?
There are several reasons why your EZGO golf cart won’t move though you can hear the click from the solenoid. Some of the common reasons are as follows: The battery pack is not able to crank up sufficient power when the pedal is pressed. The high current circuit could be faulty.
Why does my EZGO TXT slow down when accelerating?
Why EZGO TXT/RXV golf cart hesitates when accelerating The speed controller often misbehaves, which causes this problem. The speed controller manages the speed of the cart. When this function starts showing the problem, the cart starts to act up and stall.
What kind of engine does the EZGO RXV have?
I have a 2009 EZGO RXV with a Kawasaki engine. When starting out I get it's squealing - not from starter belt as I can run in neutral with no issue. When starting out on hill it seems to be squealing and slipping until finally catching.
How do I know if my EZGO controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
How do you check the EZGO inductive throttle sensor?
Identify the six- or 10-pin connector and carefully pull it out so that you can measure the pins. Put the key in the “On” position in your Run/Tow switch on the cart. Switch the F/R switch into a forward position to test your cart. Place your voltimeter testing pins on the throttle pins to see how much voltage you get.
How do you test a solenoid on a EZGO TXT golf cart?
This can Also be tested by putting a test lead on each small terminal and pressing the gas pedal. The meter should read 36 V when the gas is pressed. If this voltage does exist when the gas pedal is pressed then the solenoid should click and engage.
How do I know if my golf cart solenoid is bad?
Press on the accelerator while the key is turned on and the cart is in forward.The solenoid needs to be replaced IF the voltmeter shows a full battery voltage without a click.If your voltmeter stays at 0, the problem stems from somewhere else in your cart.
How do you test a EZGO pedal switch?
There are multiple switches on an EZGO golf cart and the following step-wise guide can help you test all of them. What is this?...How to Test EZGO Micro SwitchStep 1 – Access the Micro Switch. ... Step 2 – Connect a Voltmeter. ... Step 3 – Check for Continuity. ... Step 4 – Reset the Switch.
Where is the reset button on a ezgo golf cart motor?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
How do you test a solenoid on a EZGO RXV golf cart?
How to check?Remove the controller cover and then take a voltmeter.Connect the red wire to the battery negative terminal.Now, take the probe and put on the controller side a large terminal. ... Now, check the supplier side large terminal. ... Now start the cart and see if there is a clicking sound.More items...
How do you know if your golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
How do you test a gas solenoid on a golf cart?
Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. But, if there is no such sound, it means that either there is no low side voltage or there is a problem with the solenoid. Use a voltmeter and engage the solenoid.
What are symptoms of bad solenoid?
As a result, the common signs of a bad starter solenoid include:Engine Doesn't Crank or Start. ... No Clicking Noise When Trying to Start the Engine. ... Starter Spins Without Fully Engaging the Flywheel (Rare) ... Engine Cranks Slowly (Rare) ... Test the battery. ... Check That Power is Getting to the Starter Solenoid.More items...•
What happens when a solenoid fails?
But a faulty solenoid that fails to make adequate electrical contact inside can also produce this tell-tale sound causing the battery to have low voltage unable to provide enough power to start your engine.
Will a bad solenoid click?
When the starter motor solenoid engages, you should hear a clicking sound. If you hear a clicking sound but the starter motor isn't moving, the solenoid could be engaging but not receiving enough battery power. If there's no sound, the starter solenoid is likely malfunctioning or you might have a dead car battery.
How do you test a inductive throttle sensor on a golf cart?
Take a digital multimeter and set it to the volts reading. Place the positive probe of the meter on the white wire terminal of the ITS. Release the accelerator pedal slowly. The reading should be in the 0.45V to 0.53V range when the micro-switch gets activated.
How do I test my EZ GO speed sensor?
The EZGO speed sensor can be tested by ensuring that the three-pin plug from the sensor is connected.Keep a wire-piercing probe over the output wire. This is usually green in color.Raise one of the wheels of the EZGO golf cart and give it one full rotation using your hand.Note the voltage reading of the cart.
What causes golf cart hesitation?
In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.
Where is the speed sensor on a golf cart?
The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.
How to check if a 1996 Ezgo golf cart has batteries?
Here’s a recap of how to check if the batteries in your 1996 EZGO RXV golf cart are in proper shape or not. Use a good quality DVM. Tape the meter to the pack mains. Check the voltage when the cart is idle.
Why is my 1997 EZGO not moving?
A minor thing like over-tightening of a stud can lead to the 1997 EZGO RXV golf cart not moving. The F/R switch has a stud and if you apply more pressure it could get over-tightened and the contact will not touch the switch. Once you adjust this, your golf cart will start moving smoothly.
Why an EZGO Clicks but Won’t Move?
A EZGO golf cart can click but not move due to a faulty solenoid, or damage to the wires connecting the ITS coil to the controller.
What parts of a golf cart are faulty?
Other parts in the cart that could cause the problem are the controller, the ITS sensor, motor, solenoid, the Rotary F/R switch and bearings. Any of these could be faulty and can cause trouble. The service manual comes in handy if you are to check these parts.
What voltage should a cart battery be?
The important thing to note is that if your cart has a battery pack rated at 36 V, it must indicate 38.22 V when fully charged. Make sure that this is happening.
Why is my cart left in the off position?
Some cart owners may fix a hidden switch that is left in the OFF position to prevent thefts. Check if your cart has one. Check all the connections to confirm that there are no loose wires or if some cable is hot and not functioning as it should be. Sometimes these actions are enough to solve the issue.
What is a Project X HZRDUS shaft?
What is the Project X HZRDUS Black Fairway Wood shaft? Project X HZRDUS Black Fairway Wood shaft is a low spin golf shaft design. It comes with enhanced firmness over the entire length of the shaft....
Why does my EZGO golf cart hesitate?
The main reason why an EZGO Gas golf cart hesitates while accelerating, is because of a dirty carburetor. A dirty carburetor causes this hesitation. Regular cleaning can prevent this problem. Check the rubber boot and clean if you spot any dirt. In case it has worn out too much, you can replace the carburetor.
What happens when you press down the gas pedal on a gas cart?
The solenoid gets pressed down to a thin plate. After repeated use of the cart and pressing down of the gas pedal, the pressure creates small electric arcs on the thin plate. This restricts the current from flowing.
Why do golf carts stall when accelerated?
If a golf cart runs in reverse, but stalls when running forward and accelerating, this indicates a faulty f/r switch.
How to check for leaks in golf cart?
You can check for any leaks by following these steps: Crank up the golf cart and check every seal for leakage. You can also spray wd40 at the clutch to find leaks. When the cart becomes hot, the voltage also drops. So, make sure you provide enough voltage to the batteries so the cart can run.
How to check if a cart is stalling?
You can easily check that. Run your cart for a few feet and feel the temperature. The same loose ends can also cause the cart to stall. Check every connection inside the battery for proper connection.
Why does my golf cart stall?
The most common reason why your golf cart is stalling is due to a bad solenoid or a faulty speed controller. Batteries have lost charge. Faulty ignition. Problem with the direction switch. Faulty speed controller. Bad solenoid. The solenoid wears out every time the gas pedal is pressed down. The solenoid gets pressed down to a thin plate.
Why does my cart stutter?
If you change the battery, change the charger as well; otherwise, the battery will keep running down. If your cart seems to run fine for a few feet, and then it stutters, it is most likely the batteries. If it is not the battery, then check if it is the speed controller or the resistor.
Why won't my EZGO RXV move?
Brake Problems: Many times the reason your RXV won’t move is because of brake problems. The RXV is designed to be disabled when there is a problem with the break. Many times, the wiring that connects the brakes to the controller gets loose or is damaged. This can disable your EZGO RXV.
Why Won’t My EZGO Golf Cart Start?
EZGO golf carts may not start due to a transmission problem, corroded battery terminals or a faulty wiring coming from the ignition.
How to unclog a golf cart muffler?
To unclog it, simply make a fire and remove your muffler and put it there.
Why does my golf cart make a clicking noise?
When you press your golf cart pedal you should hear a clicking noise, if you don’t hear a clicking noise there might be a problem with the solenoid. To make sure your solenoid is functioning properly check it with a voltmeter. If you hear a click then you need to check its power with the voltmeter.
Why is my golf cart ignitor failing?
The most common reason for a failed ignitor is a bad voltage regulator. Therefore, when you replace or fix the ignitor on your golf cart, make sure you also check the voltage regulator and see if it needs to be replaced. There have also been cases where the battery has switch polarity for some reason.
What do you need to troubleshoot a golf cart?
While both types of golf cart are different, there are two things you need to troubleshoot whether you have a gasoline or an electric golf cart; the fuse and ignition.
Why is my voltmeter not turning?
If you get a full pack voltage in the voltmeter but the motor isn’t turning it means there is something wrong with the Forwards/Reverse Switch and it needs to be fixed or replaced by a certified technician.
How does a golf cart solenoid work?
The golf cart speed controller and solenoid are both controlled by the accelerator. The pedal is connected to the potentiometer. That means when you are pressing the pedal for acceleration, you are actually going through the potentiometer by pushing a rod. The potentiometer works as a communicator and tells the speed controller how much voltage it ...
Why is my golf cart speed controller not working?
There are many reasons behind a speed controller malfunction. The most common problem that happens in the controller has aged due to infrequent use. These are just some of the issues that could be affecting your vehicle's acceleration. If you have trouble finding the issue of your golf cart accelerator, don't be afraid to take it to the mechanic.
Why is my golf cart not accelerating?
When your electric golf cart does not accelerate, the first thing you need to keep in mind is that it is not a regular vehicle like your car . That's why the methods and solutions you use to get your car to start are not the same as the solutions you can apply to your cart.
What happens if your golf cart doesn't accelerate?
Bad Solenoid. If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.