Golf-FAQ.com

gas golf cart intermittent whining noise when gas pedal is pressed

by Clark Howe Published 1 year ago Updated 1 year ago

If you can hear a whining noise coming from your golf cart, then it could be because of damaged motor bearings, or the fluid oil needs to be replaced. The whining noise could be caused by the input shaft bearings. These are pretty easy to change and are available in most of the shops.

Golf Cart Making Whining Noise
The whining noise could be because of damaged motor bearings or an indication of needing fluids/oil. As a solution, you can check the fluid levels throughout your cart and change them if the fluid is too thick or the fluid level is too low, to make sure the whining noise goes away.
Apr 9, 2021

Full Answer

Why does my golf cart make a whining noise?

One of the commonly noticed golf cart sounds is a whining noise. If you can hear a whining noise coming from your golf cart, then it could be because of damaged motor bearings, or the fluid oil needs to be replaced. The whining noise could be caused by the input shaft bearings.

What are the symptoms of an electric golf cart not starting?

On a gas golf cart, the most common symptom is the starter failing to engage – so the engine doesn’t turn over – while all you hear a series of very futile clicking sounds. On an electric golf cart, the most common symptom is the solenoid is not delivering electricity to the controller when the vehicle’s ignition is turned on.

What does your car sound like when the gas pedal is pressed?

It sounds like a whining or grinding sound (sounds like its fron right under the driver seat) but only if the gas pedal is pressed. Lay off the gas, and coast, and it stops after aout a second. Press the gas, and it comes back. Only after I hit 25 MPH and above...nothing below.

Is there such a thing as a no go situation in golf carts?

The Intermittent “No Go” Situations in Gas and Electric Golf Carts. Starting with gas golf carts, the first thing to determine is whether or not the motor is turning over when the pedal is pressed.

What would make a whining noise when accelerating?

A whining noise while accelerating it can causes by several things, including low levels of steering fluid, the steering pump, a leak in the pump, the alternator, wheel bearings, loose or worn belts, the transmission, and the exhaust.

Why does my golf cart squeal when I accelerate?

The five most common reasons a golf cart squeaks include bad rubber bushings, front and rear spring failure, slipping belts, loose parts rubbing together, and problems with your wheels.

Why does my engine sound like its whining?

Whirring or Whining Whirring and whining noises often vary as the engine runs fast or slow, and they can indicate a number of different problems, including a failing water pump, a bad power steering pump, low power steering fluid, a failing alternator, or problems with the air-conditioning system.

What does whirring noise mean?

Definition of 'whirr' When something such as a machine or an insect's wing whirrs, it makes a series of low sounds so quickly that they seem like one continuous sound. [...] Whirr is also a noun. [...] whirring uncountable noun [with supplement]

Why does my golf cart make a whining noise?

Golf Cart Making Whining Noise The whining noise could be because of damaged motor bearings or an indication of needing fluids/oil. As a solution, you can check the fluid levels throughout your cart and change them if the fluid is too thick or the fluid level is too low, to make sure the whining noise goes away.

When I press the gas it makes a noise?

If you're hearing a noise while operating your gas pedal, there are a few items that could cause this including a vacuum leak, exhaust system leak or even a problem with the gas pedal or throttle cable itself on your Mazda Tribute.

Can low power steering fluid cause whining noise?

If you notice a squealing or whining noise whenever the wheels turn, there is a strong possibility that it is due to low power steering fluid. The power steering system uses a pump so the fluid can flow for smooth steering.

What causes transmission whine?

Transmission Whine Transmission whines can be a simple filter swap, or they could be the end of days for your transmission. These transmission whine sounds can be caused by a clogged filter or low fluid. If the filter gets too clogged, it will start to whine while it attempts to pass the fluid through the filter.

What causes a high pitched whining noise in car?

Possible causes include worn-out brake pads, faulty brake calipers, not enough or no lubrication on the brake parts or simply low-quality brake pads and/or brake rotors. Special tools are sometimes needed to locate the source of a noise, such as Electronic Ear Sensors.

How do you fix a squeaky cart wheel?

0:152:02How to fix a squeaky wheel - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou know this is a really simple fix. So buy can of wd-40 bought this at Fred Meyer. I paid a littleMoreYou know this is a really simple fix. So buy can of wd-40 bought this at Fred Meyer. I paid a little more than I would like for it. But when you need it you need it.

How do you lubricate a golf cart?

0:572:10Club Car Golf Carts - Lubrication Schedule - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou're going to want to actually feet see how the grease comes out of there fitting. Watch when IMoreYou're going to want to actually feet see how the grease comes out of there fitting. Watch when I push this see how it comes out you want to be able to see grease coming out of the fitting.

How do I stop my golf cart brakes from squeaking?

To fix squeaky brakes on your golf cart, apply anti-squeal grease on the pads and replace the clips. With prolonged use, the brake pads of golf carts usually emit a squeaky noise while applying the brakes. This can be one way of alerting you to replace the brake pads.

Where are the grease fittings on EZ Go golf cart?

Grease is a type of lubricant that is used to reduce the friction between two surfaces of your EZ Go golf cart. It is often used in golf carts to keep them running smoothly and to prevent them from overheating. Grease fittings are located on the front and rear of the golf cart, near each wheel bearing.

Why does my golf cart make a whining noise?

If you can hear a whining noise coming from your golf cart, then it could be because of damaged motor bearings, or the fluid oil needs to be replaced .

Why does my golf cart beep?

In some cases, beeping sounds are heard when you are trying to reverse the golf cart. This is one of the most common problems faced by cart owners. This beeping sound may also be heard during a normal drive but most people have reported hearing it when the vehicle is being reversed.

How to stop a buzzer from buzzing?

Try identifying the wires connected and disconnecting one of them. This should disconnect the buzzer from the cart and thus stop the buzzing noise.

What could have gone haywire in my F&P switch?

The buzzer wires could have gone haywire or may have gone into the F&P switch. This may need to be replaced for the issue to be solved.

Why does my controller beep?

If all these efforts fail, you could try checking the batteries or the motor. If either of these has shorted out or has had a malfunction , then the beep sound may be heard. Checking the battery pack and the controller can give you a good idea of whether the issue originates from them or not.

Why are my brakes tight?

Excess tension in the brake cables could also cause overloading of the brakes. Verify that the brake cables are not overloaded and are free to work efficiently. Sometimes the brake pedals become tight and do not function normally during a run.

Does changing fluid help noise?

Normally, changing the fluid can help make the noise go away. For example, the users of EZYGO RXV tried changing the fluid to 85-140 which was recommended by EZ-GO and found that this fixed their noise issues.

Why does my golf cart make a grinding noise?

If your golf cart is making a grinding noise while running, the issue could be due to the bearings. The grinding noise is very irritating, and the problem is generally with one of the physical or mechanical parts.

Why does my golf cart beep?

Golf carts are designed to carry a specific load for a distance. Replacing the tires may put them under a great deal of pressure for their torque. If all of these efforts fail, you can inspect the batteries or the motor. If any of these have malfunctioned, then you may hear the beeping sound.

What to check for when replacing golf cart tires?

You may need to check wheel bearings, friction modifiers, and bolts to make sure they are tight. You may also need to inspect the tire bottoms because, sometimes, a click might turn out to be as simple as an item stuck in the tread of the tire. In case of replacement, consider quality golf cart tires at Golf Cart Garage.

Why does my washing cart make a buzzing noise?

If the buzzing noise is coming right after you washed your cart, it could be because of the water getting under the floorboards. The best solution is to let the water dry well before using the cart.

Why does my F&R switch beep?

In most cases, a damaged solenoid could be causing the issue of beeping noise. Replacing the bad or damaged solenoid is one way of solving the beeping noise. Sometimes, the buzzer wires could be going into the F&R switch. Replacement of this may help to solve the issue.

How long does it take for a bearing to go bad?

This is because, once bearings start to go bad, they often fail almost entirely and can become almost unusable in just a few hours.

Why is there water in my F&R switch?

However, you may also have some water left in your F&R switch, or it could be because of water on the battery wires. This water-related danger is one you need to take very seriously. Instead of attempting without any precaution, we suggest that you arrange a visit to a cart specialist.

What does it mean when you hear a humming noise when you step on the gas pedal?

There's a humming/whining noise when stepping on gas pedal and immediately stops when letting off the gas. The sound is loudest around the front passenger area. Someone recorded a video with the same exact sound that I'm hearing. They never posted about whether they found what was wrong or not.

Can a V6 water pump go out?

V6 or I4 - replace the water pump, now or if you have a timing belt replacement (for the V6) coming up. It may not be the problem but if the W.P. goes out you could overheat the engine & blow a head gasket.

Does idle pulley sound like RPM?

It looks like the sound varie s without RPM changes -- idle pulleys and water pump will be rotating at the same speed regardless of accelerator. I think the fact that it only happens when you apply power suggests transmission noise, unfortunately. That's the place where you're applying stress when the throttle is opened up.

Why does my golf cart make clicking sounds?

On a gas golf cart, the most common symptom is the starter failing to engage – so the engine doesn’t turn over – while all you hear a series of very futile clicking sounds.

What are the symptoms of a bad solenoid on a golf cart?

In addition, the spring that pulls the pinion back to its resting position could wear down leaving the starter engaged continuously. (Starters are supposed to get the flywheel moving, then back out of position – disengage.)

What does it mean when a golf cart solenoid goes bad?

Technically, in fact, a solenoid is a shape – a shape in which the length of something coiled is longer than the diameter of the coils. In engine starters, this refers to the smaller motor ...

How to check ohms of a cable?

Once you’ve disconnected the cables safely – using your multimeter – use the voltmeter on the ohms setting and touch each large terminal with the probes with the key turned off. You should get a zero reading.

Why does my solenoid wear out?

Like any switch that relies on wiring, the solenoid could also just wear out due to overheating. This might cause it to fail to retrieve the pinion gear.

What does a solenoid do when you turn the ignition?

Step by step, it looks like this: When you turn the ignition key, a small amount of electricity goes to the solenoid. The solenoid uses that small amount of juice to close two heavy-duty contacts that allows a large jolt of electricity to pass through the starter. The solenoid also sends a pinion gear forward, which is the device ...

Why do starter contacts wear out?

Secondly, the contacts could begin to wear out from overheating or exposure to high levels of current. This needs to be fixed right away if possible, because this causes continuous use of the starter. If not caught in time, the solenoid and the starter will both need replacement.

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9