First, you turn the key, press the pedal, and listen for a click. If nothing happens, it’s most likely an electrical issue. On gasoline carts, check the battery that turns the engine over to make sure it is charged.
Full Answer
Can you replace the solenoid on a Yamaha G16 gas golf cart?
Second opinion] Yes you can! I have a Yamaha g16 gas golf cart and I just ordered and replaced the solenoid. Now the solenoid is just clicking when I press on the pedal. read more.
How to fix a Yamaha G29 golf cart pedal switch problem?
In the G29 Yamaha golf cart, the pedal switch could be the issue. You should check it thoroughly. One quick way to do this is to press the pedal right up to the floor and remove your foot in a quick motion allowing the pedal to spring back to its original position in one stroke. Sometimes, this action can sort out the issue.
What are the most common problems with a G16 golf cart speed controller?
The most common problems with a G16 golf cart speed controller is overheating and voltage issues. Overheating: This is a major problem, and the reasons for the same are excess power or improper wires. Voltage issues: If the accelerator is pressed and the voltage level does not increase, then there is a problem with the battery voltage.
How to test the Yamaha G16 speed controller?
To test the Yamaha g16’s speed controller, check the voltage reading while pressing the accelerator. Test other components such as the batteries, the charger, and the solenoid for their smooth functioning. If any of these components do not work as expected, then you need to replace them.
Why does my Yamaha golf cart not move?
The main cause of a Yamaha golf cart clicking but not moving, is a faulty controller or solenoid. The battery has to be checked first to see if it's delivering the right voltage while in the idle state as well as when the pedal is pressed.
Where is the reset button on a Yamaha golf cart motor?
Expose the motor (you'll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected. Once you've pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run.
Why does my golf cart not accelerate?
Bad Solenoid If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.
Why does my gas golf cart not move?
The main reason why a EZGO gas golf cart will not go forward is because of a locked up brake, or a faulty solenoid and accelerator. A defective Run/Tow or Forward/Reverse switch can also cause a EZGO to not move forward.
Why did my golf cart suddenly stop working?
If the connections from the solenoid have become loose or if there is some other loose contact, the cart might behave in this manner. It can also be caused by a faulty motor or a faulty key switch. If the micro-switch is faulty, it can also cause the cart to suddenly stop midway.
How do you test a Yamaha solenoid on a golf cart?
Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. But, if there is no such sound, it means that either there is no low side voltage or there is a problem with the solenoid. Use a voltmeter and engage the solenoid.
How do you adjust the governor on a Yamaha g16 golf cart?
Locate the cable nut that holds the cable to the throttle lever for a clutch cable governor. Adjust the main cable nut, holding it in place with the screwdriver. Turning the nut counter-clockwise will make the cable longer, allowing the cart to go faster. Turning the nut clockwise will reduce the vehicle's top speed.
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
How do I reset my Yamaha golf cart?
Identify your main battery supply (usually the largest battery) on your motor. Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor.
How do you troubleshoot a gas golf cart?
InstructionsCheck the gas tank to make sure there is enough fuel for operation. ... Remove the oil dipstick and check that the oil level is at or just above the add or fill maker. ... Inspect the battery of the golf cart. ... Examine the wiring and switches. ... Remove the air filter from the engine to access the carburetor.
Where are the fuses on a Yamaha golf cart?
Yamaha Golf Cart Fuse Box Location The fuse box in a 2014 Yamaha golf cart is located on the left side of the controller. The wires are tied to the roof drain. In a G2 electric cart, the fuses are present on the rear inner fender. This is on the front of the driver's side of the cart.
Why won't my Yamaha golf cart go forward or reverse?
The reason why your Yamaha G1 Golf cart is not moving forward is because a faulty solenoid. If your golf cart moves forward but not in reverse, you need to replace your solenoids.
Why won't my gas golf cart go forward or reverse?
If the power from the battery pack is not reaching the motor, then the Club Car golf cart won't move forward or reverse. In such cases, there are a few components in between the two that need to be checked. The solenoid is one major component. Check if the resistor between the two big terminals on the solenoid is hot.
Where is the solenoid located on a Yamaha golf cart?
0:065:38Replace Solenoid in Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipCart um your solenoid could be located in a bunch of different places but almost always underneathMoreCart um your solenoid could be located in a bunch of different places but almost always underneath the seat.
What are the symptoms of a bad solenoid in a golf cart?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
How do you check if a solenoid is working?
Do your best to listen for a “click” noise. If the click is strong and loud, it most likely means the solenoid has enough power and is working properly. If the clicking you are hearing is quiet or repetitive, it may be that your solenoid is not strong enough or does not have enough power from the battery.
How do you test a Yamaha golf cart motor?
4:0210:28Testing 36 volt golf cart motor with 12 volt battery - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou're going to take the negative. And put it on the a1. Again i'm going to take the jumper cableMoreYou're going to take the negative. And put it on the a1. Again i'm going to take the jumper cable from a2 to s1 you're going to take the positive cable from the jumper.
How do you bypass a solenoid on a golf cart?
To bypass the solenoid of your golf cart, simply connect both the large side wires of terminals of the solenoid. And after making the connection, attempt to start the cart. If you fail to start, this is an indication that there is no problem with your solenoid.
How to test Yamaha G16?
To test the Yamaha g16’s speed controller, check the voltage reading while pressing the accelerator. Test other components such as the batteries, the charger, and the solenoid for their smooth functioning. If any of these components do not work as expected, then you need to replace them.
Why is my Yamaha golf cart controller so hot?
The primary reason why a Yamaha golf cart controller gets too hot is because of overuse. When the golf cart is used for long periods of time, the controller can start overheating. The driving surface might also be a cause of heating. If driving on a straight and soft surface, the problem of heating should not occur.
What to do if your golf cart controller does not increase?
If it does not increase, then there is a problem with the controller or the batteries. Examine the batteries and check if they are dead. If dead, replace them. Examine the controller, as discussed in the previous sections. Remember to always consult a mechanic to have your golf cart controller repaired.
What are the problems with a Yamaha G22?
Yamaha G22 also faces similar problems like G9 and G16. Overheating, battery faults, wiring issues, voltage issues are some problems that might occur with your Yamaha G22. To avoid these problems, test the golf cart’s major components connected to the controller regularly.
Why is it important to troubleshoot a golf cart controller?
Troubleshooting the controller is extremely important for the golf cart’s smooth functioning. Generally, controllers face major issues only when there is a problem with wires or defects on the controller itself, such as marks or cracks.
How to troubleshoot a G9 controller?
Here are some easy steps for troubleshooting the G9 controller: Check the controller’s body to locate any major defects such as cracks, scratches, or black marks. If these are found, then replace the controller immediately. If no major defects are found, then check the wiring.
Why is my golf cart not heating?
If driving on a straight and soft surface, the problem of heating should not occur. But, if driven on uneven or steep surfaces , there are chances of heating. Another reason could be the brakes. It is essential to check if the brakes are dragging while the golf cart controller is driven.