Why does my EZGO gas golf cart click but not start?
EZGO Gas Golf Cart Clicks but Won’t Start The reason why a Gas Golf Cart Clicks but won’t start is because the connector to and from the solenoid is either loose or corroded. Check the wiring for any damage or corrosion. If you find any then you’ll need to replace it.
What does the solenoid do on an EZGO gas golf cart?
The solenoid can be defined as the primary or the most basic electrical switch present in the EZGO gas golf cart. Its main function is to enable the flow of electricity from the battery into the motor.
Why are the pedals on my EZGO RXV stuck?
The EZGO RXV is very sensitive, and if the pedals are not in its right resting position it could create an issue. Check and see if there is anything that’s causing the pedals to get stuck. Debris and grass tend to clog the pedals over time and it needs to be cleaned periodically.
What are the different types of speed controllers on EZGO golf carts?
The EZGO golf cart retains two different types of speed controllers: the Drive Control System (generally found on older models prior to 1994) and the Precision Drive System (PDS).
What would cause a gas golf cart not to fire?
First, try this: turn the key switch on, hit the accelerator, and check for a clicking noise. If you don't hear clicking, it's time to take a look at your cart's batteries. Make sure the battery is fully charged and the terminals are cleaned and secure. Next, see how the water level in the battery is holding up.
Where is the reset button on an ezgo golf cart?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
Why does my golf cart not accelerate?
Bad Solenoid If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.
How do you test a gas solenoid on a club car?
Set your multimeter to ohms and insert a probe on each large terminal with the key off and the cart direction switch in the neutral position. Press on the accelerator with the cart's movement control in the forward position, and the key is turned on. A click should be heard first from the solenoid.
Where is the motor reset button on a club car?
First, you'll want to reset your motor. Get out your handy screw driver and work to uncover the motor itself. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor.
How do I know if my EZGO controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
Where is the speed sensor located on a Club Car golf cart?
The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.
How do you troubleshoot a gas golf cart?
InstructionsCheck the gas tank to make sure there is enough fuel for operation. ... Remove the oil dipstick and check that the oil level is at or just above the add or fill maker. ... Inspect the battery of the golf cart. ... Examine the wiring and switches. ... Remove the air filter from the engine to access the carburetor.
How do you test a potentiometer on a golf cart?
There are two terminals on a potentiometer. Switch your multimeter to ohms and place one contact on each of the terminals. It should read 0 when the accelerator is not depressed, and then rise as you push the pedal down. If your readings are erratic or out of the normal range, it is time to replace the potentiometer.
How do I know if my Club Car controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
How do you test a golf cart Ignitor?
Testing Your IgnitorPark your cart and put bricks behind the wheels to keep it from moving.Open up your cart engine and attempt to identify the ignitor using your cart engine schematic.Trace the ignitor back to the pulsar to see where they are connected together on your cart.More items...
How do you check the solenoid on a EZ Go golf cart?
This can Also be tested by putting a test lead on each small terminal and pressing the gas pedal. The meter should read 36 V when the gas is pressed. If this voltage does exist when the gas pedal is pressed then the solenoid should click and engage.
What is an EZGO golf cart?
Your EZGO golf cart is probably a more integral part of your life than you realize. If you live in a residential neighborhood or gated community, chances are that you use your golf cart for a wide variety of purposes beyond simply golfing―to take a trip to the nearby grocery store, to drive a mile or two to the country club or tennis courts down the road, to act as a makeshift hunting vehicle during hunting season, or even to fetch your mail in rainy or snowy weather.
What is the recommended tire pressure for an EZGO cart?
The standard recommended pressure of an EZGO cart’s tires ranges from 18 to 22 PSI. Be sure to inspect your tires regularly, too, and replace them as necessary. If your cart is driving slower than usual or making strange noises “down there,” it could very well just be a sign of low tire pressure.
What does the Ezgo manual say about battery replacement?
The EZGO manual says that, “First, a battery that performs poorly and is outside of the manufacturer’s specification should be identified in order to replace it under the terms of the manufacturer’s warranty.”. This means that every manufacturer retains its own unique requirements, specs, and timelines.
Why is it important to keep a golf cart in good shape?
Therefore, it is very important to keep your golf cart in great shape at all times, and learning how to troubleshoot can mean the difference between diagnosing and quickly fixing problems, or having your cart break down.
How many cycles does a golf cart battery take?
Your golf cart’s battery needs to mature completely before it can operate at its maximum levels. This can take as many as 100 full charge cycles, so be patient if the brand new golf cart you just purchased isn’t quite living up to its battery expectations.
What happens if the voltage is not equal to the voltage on a solenoid?
If it is not equal, then the solenoid has a wiring problem. oYou should also put the positive probe on the opposite post of the solenoid and read the voltage there. The voltage should have three or more volts below the battery’s own reading. If not, then you should get the resistor replaced as soon as possible.
Why is my golf cart foot pedal so smooth?
If you are having issues with the smoothness of your foot pedal, it may simply be due to the air quality of your surroundings and should eventually fix itself. If your golf cart is a few months or years old, the stickiness may be due to constant pressure.
Why won't my EZGO golf cart start?
EZGO golf carts may not start due to a transmission problem, corroded battery terminals or a faulty wiring coming from the ignition. Transmission Problem For safety reasons, many EZGO golf carts won’t start if its transmission is not in the Park position. Check and make sure the gear is in the Park position.
Why won't my EZGO RXV move?
Brake Problems: Many times the reason your RXV won’t move is because of brake problems. The RXV is designed to be disabled when there is a problem with the break. Many times, the wiring that connects the brakes to the controller gets loose or is damaged. This can disable your EZGO RXV.
Why does my golf cart make a clicking noise?
When you press your golf cart pedal you should hear a clicking noise, if you don’t hear a clicking noise there might be a problem with the solenoid. To make sure your solenoid is functioning properly check it with a voltmeter. If you hear a click then you need to check its power with the voltmeter.
Why is my golf cart ignitor failing?
The most common reason for a failed ignitor is a bad voltage regulator. Therefore, when you replace or fix the ignitor on your golf cart, make sure you also check the voltage regulator and see if it needs to be replaced. There have also been cases where the battery has switch polarity for some reason.
How to check if golf cart battery is corroded?
Also, make sure the golf cart is turned off. Start checking the battery by twisting the battery connector back and forth and then try and start the golf cart. If the golf cart almost starts or starts successfully then it’s highly likely that the battery terminals are corroded.
What to do if replacing ignition wire doesn't work?
To check the continuity of the ignition wire you’ll need to use an ohmmeter or a continuity tester. To do this, set the switch to off and set your ohmmeter to X1.
What happens when a golf cart is not working?
When the speed controller malfunctions or does not work properly, the cart will move but with several breaks in between. The golf cart will not be able to move at a steady or constant speed and that is one of the first warning signs ...
Why won't my golf cart work?
The golf cart will not function if the transfer of electric current is disrupted. Current gets disrupted when the solenoid gets worn out or damaged. When you press the pedal, the solenoid gets activated and compounded into a metallic contact plate.
Why is my golf cart not moving?
The golf cart will not be able to move at a steady or constant speed and that is one of the first warning signs of a problem with the speed controller of the vehicle. Here are a few things you can do to fix the issues associated with your speed controller.
What happens if oxygen sensor is damaged on Yamaha G29?
Therefore, if the oxygen sensor is damaged, the engine of the Yamaha G29 golf cart will be oblivious to any information about the air-fuel mixture. This will, invariably, cause acceleration problems.
How does a speed controller work on a golf cart?
Once you do this, the brake should release and the cart will start accelerating once again. The speed controller works towards regulating the speed of the golf cart. There are instances when the speed controller fails but the vehicle will still start and move ahead.
Why is my golf cart solenoid not working?
If you encounter a problem with the solenoid of your golf cart, then you must know that it could be because of a faulty speed controller. To check the condition of your vehicle’s solenoid, you will be required to take a reading of the voltage and check if it is the same as the reading from the battery.
What is the function of a golf cart solenoid?
Its main function is to enable the flow of electricity from the battery into the motor. When you press the gas pedal and hear a sound that resembles a tap, you must know that the solenoid has been activated. The golf cart will not function if the transfer of electric current is disrupted.
Why is my golf cart speed controller not working?
There are many reasons behind a speed controller malfunction. The most common problem that happens in the controller has aged due to infrequent use. These are just some of the issues that could be affecting your vehicle's acceleration. If you have trouble finding the issue of your golf cart accelerator, don't be afraid to take it to the mechanic.
Why is my golf cart not accelerating?
When your electric golf cart does not accelerate, the first thing you need to keep in mind is that it is not a regular vehicle like your car . That's why the methods and solutions you use to get your car to start are not the same as the solutions you can apply to your cart.
What happens if your golf cart doesn't accelerate?
Bad Solenoid. If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.
How does a golf cart solenoid work?
The golf cart speed controller and solenoid are both controlled by the accelerator. The pedal is connected to the potentiometer. That means when you are pressing the pedal for acceleration, you are actually going through the potentiometer by pushing a rod. The potentiometer works as a communicator and tells the speed controller how much voltage it ...
Why does my golf cart not click?
This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid.
How to tell if a golf cart won't start?
The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting. When the contacts weld together, the power to the starter never stops ...
How to tell if a golf cart is bad?
Symptoms Of A Bad Solenoid 1 The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. 2 The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting. When the contacts weld together, the power to the starter never stops and will result in destroying the starter, the wiring, or the flywheel. 3 The relay clicks and works sometimes, and sometimes it doesn’t. This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. 4 The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid. 5 The golf cart solenoid clicks, but nothing happens. This will sometimes be the result of burned contacts or contacts no longer coming in contact with each other as shown in the illustration at the bottom of this page. This can also be the result of not enough voltage amps reaching the solenoid control connection due to a low battery.
How to check if a gas cart battery is charged?
First, you turn the key, press the pedal, and listen for a click. If nothing happens, it’s most likely an electrical issue. On gasoline carts, check the battery that turns the engine over to make sure it is charged. On Electric carts, the battery pack should be checked for a full charge.
What to do if a gas cart key switch fails?
There should be a reading or continuity between any combination. If this is a gasoline cart, set the switch to “ON” and take a reading between the terminals. There should be continuity. If the key switch fails any of these tests, it’s worn out and should be replaced.
What causes a car to start when the spark plug is replaced?
If it sputters and tries to start, then the likely culprit is the fuel pump followed by the carburetor. The fuel pump on most gasoline powered carts usually has three hoses going to it.