How do you extend golf clubs?
How much does it cost to lengthen golf clubs?
Most irons, putters, and woods can have length added to the existing shaft.
Can standard golf clubs be lengthened?
Does lengthening a golf club make it more upright?
What happens if golf clubs are too short?
How long should I extend my golf clubs?
How do I extend my golf irons?
What happens when you lengthen a golf club?
Does lengthening a golf club change the lie angle?
How does club length affect distance?
Do you need longer golf clubs if you are tall?
Does 1 degree lie angle make difference?
Does lengthening a golf club shaft affect accuracy?
Accuracy. As a general rule, lengthening any club's shaft will reduce your accuracy with that club. The longer the club, the more difficult it becomes to hit the ball solidly. This is especially true when the ball is on the ground rather than on a tee, since hitting the ball fat is more likely.
Who is Mike Southern?
He is the author of the instructional golf book "Ruthless Putting" and edited a collection of swashbuckling novels. Southern was trained in electronics at Forsyth Technical Community College and is also an occasional woodworker.
Lengthening Effects
Lengthening a club gives you a longer swing and, potentially, a faster swing speed. The increased speed will translate into more distance if you hit the ball squarely. But the added weight may cost you some control and make it more difficult to hit the club's sweet spot. Longer shafts also become more flexible.
Trim the Shaft
After you've decided to trim the shaft, consider whether to trim the tip or the butt end. Remove the grip with a blade if you're cutting from the butt end. Use a hooked blade on a graphite club to avoid damaging the shaft. To trim from the tip, heat the ferrule with a heat gun to loosen the glue, then cut the ferrule off the shaft.
Lengthen a Club
Extend your steel or composite shaft up to 2 inches by adding a piece onto the butt end of your club. Use the same material from which the shaft is made -- use a graphite extension piece for a graphite shaft, for example.
Install a New Shaft
To avoid cutting the shaft or adding an attachment, purchase a new shaft at your desired length. Cut the ferrule and remove the clubhead from the old shaft as you did before trimming the tip. If you wish to keep the original grip, use an air compressor to separate it from the old shaft, then pull the grip off.
How does length affect golf?
Increasing the length of a shaft has the following effect: 1 The dynamics of the shaft. The flex of the shaft changes if you lengthen or shorten the shaft. 2 The swing-weight and balance will change effectively requiring the golfer to make adjustments to the swing. 3 The lie-angle will change by forcing the golfer to stand closer or further from the ball at the address. 4 And finally the real “kicker”, control.
Why is distance important in golf?
Distance may be important, but will not win you games unless you can control the direction and flight of the ball. Control and accuracy should and will be the factor that lowers the handicap and improves the all-around performance on the golf course.
Who is Nick Lomas?
Nick Lomas is the founder of GolfSpan, an avid golfer, not quite a pro but has over 15-years of experience playing and coaching golfers from all over the world. His mission is to bring the golfing community a better experience then it comes to choosing the right golf gear, and finding the right set up for your game.
What does it mean when your golf club is flat?
Flat Lie Angle. There is a risk of slicing the ball when your angle is too flat. This means that the angle between the shaft and the ground is smaller. Once your club is too flat for your swing, the toe of your golf club will have a lower range than the heel when it should be leveled.
Why does my golf club slice?
There is a risk of slicing the ball when your angle is too flat. This means that the angle between the shaft and the ground is smaller. Once your club is too flat for your swing, the toe of your golf club will have a lower range than the heel when it should be leveled. Slicing happens because of such reasons.
What does a club fitter do?
A club fitter can do this for you where they will place a piece of tape on the iron’s sole, and once this produces a mark on the ground, it will determine what adjustments need to be made to your golf club.
How to increase swing weight?
Swingweight can easily be increased by using lead tape placed at the clubhead. Lengthening a club softens the shaft a fraction while increasing the swing weight of the club. Each time you add length like half an inch will also add three swing weight points.
Why is a lie angle important?
The Advantage Of Having A Correct Lie Angle For Your Golf Clubs 1 Since golfers have different build and swing types, having a correct lie angle will help you in getting an accurate swing. 2 This is important in determining ball flight patterns, it will lessen the inaccuracy as well. Some beginners tend to have incorrect posture, so they can follow the right swing even while having an incorrect lie angle. 3 It will lessen your mis-hits.
How to tell if a golf club is too long?
Below you’ll find common signs that indicate the clubs you’re using are too long: 1 You have to stand up almost completely straight. 2 You’re unable to move your lower body using proper swinging mechanics 3 The ball often flies off to the left and too high. 4 The club’s shaft feels very weak 5 You’re constantly hitting the ball with the toe of the golf club.
How to measure golf clubs?
Measuring Your Clubs in Five Steps 1 Use a forty-eight-inch sturdy straight edge aluminum ruler. A tape measure is too flimsy and won’t give you an accurate measurement even if it is pressed against the club’s shaft. If you don’t currently own an aluminum yardstick, you can easily find one at a local home improvement store. 2 Don’t use your workbench to measure the golf clubs. A better alternative is to stand and place the club in its correct position at address. The sole of the club should be completely flat on the ground. 3 The straight edge should be placed so that the corner is touching the ground. The club should remain in address at this time with the ruler squaring up against the hosel. The hosel is the portion of the club where the clubhead is connected to the shaft. 4 The straight edge should be pressed as close as possible to the shaft. Now, read the measurement at the bottom of the grip cap. This should tell you the length of the shaft.
How tall should a golf iron be?
Height Recommendations for Irons. Here you’ll find the standard recommended measurements for golf clubs based on height: Six feet, six inches and taller-add two inches to the standard length of the club. Six feet, five inches-add one and a half inches to the standard length of the club.
How long is a golf driver?
On average, most golfers use a driver that’s forty-four inches in length, however, a club shaft up to forty-eight inches in allowed for competitions.
How long is a putter?
Putter: The standard length of a putter is thirty-four inches, however, the length of a putter is measured much differently than irons. It often depends on the putter’s construction. A center-shafted model is not measured to the bottom of the hosel like other clubs.
How long is a nine iron club?
Iron: The one iron club is a little over forty inches in length. Each iron falls half an inch with each size until you reach the nine iron which measures in at a little over thirty-six inches. Differences in irons can also occur due to shaft material. Typically, steel shafts are one inch shorter than graphite shafts.
Series Navigation
Extending a golf shaft is a useful technique to have if you are buying used clubs, or if you are experimenting with different club lengths. If you know how to cut a golf shaft or how to extend it, you don’t ever have to worry about purchasing the correct length of clubs on Ebay or other used club marketplaces.
Materials Needed
Extension (You could also use an old golf shaft)#N#Make sure you purchase the right size extension. You need to know the “butt diameter” of the shaft that you are extending, and purchase the extension that matches. Here is a database of shafts.
About the Author: Zach Gollwitzer
Hey!! I'm Zach, the founder of The DIY Golfer. I created this site in 2015 while playing D1 collegiate golf to help myself understand the game of golf better and improve as a player. Fast forward a few years, and it has become much more than a journal.
Custom Fit Golf Clubs For You
Are you an avid golfer, or are you just getting into the sport and loving it? No matter the case, our golf professionals at Totally Driven are here to help you find the perfect golf clubs for your swing pattern.
So, How Much Does Height Matter?
Somewhat surprisingly, the height of each individual golfer does not play into the length of club shaft as much as you may think. The factor that is most important in this process is your golf stance and how far that puts your wrists from the floor.
How Do We Take That Into Account?
At Totally Driven, we use state-of-the-art technology and golf professionals to help you find the optimal fit for your golf clubs. Whether you are looking to have a single club fitted or your entire bag, we will get the measurements needed to determine every aspect of your clubs.
Contact Totally Driven Today
If you are in the Twin Cities area and searching for a team of golf professionals to custom-fit your golf clubs, so they are perfect for you, contact Totally Driven today. With our state-of-the-art facility and technology, we are able to breakdown every aspect of your swing and project the best measurements for your golf clubs.
