- Loosen the nut attached to the governor arm with a 7/16” wrench to turn the shaft.
- Push the governor arm to the back of the cart and grasp it with your hand.
- Turn the governor shaft in the counter-clockwise direction until it cannot be turned further.
- Retighten the nut and let go off your hold on the governor arm.
- This method also helps to slow down the cart.
How do you take the governor off a golf cart?
- Locate the governor arm mounted on top of the rear axle case underneath the cart.
- Loosen the adjusting locknut on the end of the governor spring.
- Retighten the adjusting locknut.
How to disconnect the governor on golf carts?
Procedure
- Remove the cable connection from the carburetor. ...
- Now, remove the other end of the cable connected to the governor. ...
- Locate the gas pedal that is fitted to the governor and remove the connection.
- Re-route the gas pedal to the carburetor.
- Remove the bolt present on the shaft of the gas pedal.
- Slide the shaft upwards so that the gas pedal has more play.
How to adjust the governor on a Yamaha golf cart?
Yamaha G29 Governor Adjustment
- Remove the rear inspection panel from the golf cart. The spring accelerated governor is right below this panel.
- Use a 10mm wrench and tighten the nut a little by moving it in to expose the threaded rod a little more. ...
- Take the cart for a test drive to check for the desired speed.
How to remove Governor on a club car golf cart?
How Do I Adjust The Governor On My Club Car
- How far down does your gas pedal go before the starter engages? If more than 1", you need to adjust the throttle rod under the cart. ...
- You will need to look at the carb closely on this one. First, remove the cover of the black box. ...
- Install your tach on the dash somewhere. ...
- Governor removal. ...
How does governor work on golf cart?
How Does a Golf Cart Governor Work? A golf cart governor is a mechanical device that helps in controlling the maximum speed of the cart when it moves on flat ground. This device prevents the engine RPMs from increasing beyond the recommended specifications.
How do you adjust the governor on an ezgo gas golf cart?
1:327:10Simple Adjusting of an E Z Go Golf Cart Governor - YouTubeYouTubeStart of suggested clipEnd of suggested clipThere should be five screws in most models the engine is in the front of golf carts underneath thisMoreThere should be five screws in most models the engine is in the front of golf carts underneath this panel take off the plastic cover and set it aside with the seats.
Can you adjust the speed on a Club Car golf cart?
0:131:31Club Car Precedent Speed Increase SUPER EASY!!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. AndMoreIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. And if you turn it that way or clockwise it speeds things up. Very.
How do you make a gas golf cart go faster?
How to Make Your Gas-Powdered Golf Cart Faster [Updated, 2022]1 Use A Better Golf Cart Battery.2 Increase Torque.3 Upgrade the Golf Cart Motor.4 Install a Torque Converter.5 Install a Higher-Performance Clutch.6 Tweak The Governor.7 Install A Cold Air Intake.8 Get Bigger Golf Cart Tires.More items...•
How do you adjust the governor on a Club Car gas golf cart?
If you find this rod, then your governor can be easily adjusted by accessing the cart's inner workings. Simply adjust the cable coming from this metal protrusion, turning the nut counterclockwise to make the cable longer, effectively adjusting the cart's governance to increase the overall speed.
Where is the governor on a golf cart?
0:101:28Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell a golf cart's governor located is actually down in the motor. Compartment. Some of them theseMoreWell a golf cart's governor located is actually down in the motor. Compartment. Some of them these electric ones nowadays. Actually the governor isn't a true governor. It is a control speed.
How do you remove a speed limiter from a golf cart?
0:040:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo the farther you bend that normally the faster it goes and then that's it basically when you wantMoreSo the farther you bend that normally the faster it goes and then that's it basically when you want to return your heart you just bend that back down and go back to normal speed.
How do you remove the speed limiter on a electric golf cart?
Basically, an electric speed governor can be controlled by a tiny metal rod that's located by the clutch of your golf cart. First things first: The electric speed governor is connected to a cable. You can adjust your speed by rotating the nut in a counterclockwise rotation.
How can I make my electric golf cart go faster without upgrading?
How to Make an Electric Golf Cart Faster Without UpgradesWash Your Cart Properly. ... Inspect the Batteries. ... Refill the Battery Water. ... Check the Gas Pedal and Linkage. ... Measure the Tire Pressure. ... Charge Up Your Battery Unit. ... Lighten Up Your Cart's Weight.
Why is my gas golf cart running slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
How fast can a golf cart go without a governor?
A typical electric cart without an upgraded speed control tops out around 12 mph.
How fast can a gas golf cart go?
19 mphYes, electric golf carts are the fastest on the market. The have a top speed of 25 mph and gasoline golf carts usually have a top speed of 19 mph.
How to find the governor on a golf cart?
Locate the golf cart’s governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor. Use a screwdriver—or in some cases a wrench—to loosen the tension on the governor’s springs. You have now adjusted the governor for faster speed.
Who is the writer of GolfCarCatalog.com?
GolfCarCatalog.com – “Adjusting Your Golf Cart’s Governor”. Writer Bio. Richard Kalinowski began writing professionally in 2006. He also works as a website programmer and graphic designer for several clients.
Can a golf cart be a nuisance?
In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds. Luckily, you don’t have to stick with these standard speeds. Golf cart speed is often controlled by a device called a governor, and you can adjust the governor on a golf cart relatively easily to make the cart faster.
Can golf carts be adjusted manually?
By Richard Kalinowski. Governors limit the speed of golf carts but can be adjusted manually. In theory, golf carts make it easier for players to get across the course, saving their much-needed energy for the game. In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds.
How to adjust EZ Go cart governor?
To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.
How to raise the top speed of a golf cart?
To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly. If you cannot find this spring, you likely have a newer model that is more difficult to adjust, though this is rare. Lift up the seat. Remove the seat cousins, which hide the engine.
How to make a golf cart go faster?
Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.
How to get a cart to move faster?
1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.
How fast can a golf cart go?
Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.
How many screws are in a golf cart engine?
There should be five screws in most models. The engine is in the front of golf carts, underneath this panel. Take off the plastic cover and set it aside with the seats. ...
How to change the speed of a car?
Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...
What are the governors on a Yamaha golf cart?
The three types of governors in Yamaha models include spring adjustment, clutch cable, and spark regulation governors.
How to make a golf cart go faster?
To make a golf cart go faster, you can also consider installing a new engine. Always consult the owner's manual for the Yamaha golf cart model you have. Every model has limits to how fast it can physically go without engine damage or failure resulting. To make a golf cart go faster, you can also consider installing a new engine.
