- Obtain the proper measuring tool. You will need at least a 48-inch ruler/measuring stick/tape measure in order to measure the length of your golf clubs.
- Position the golf club. The face of the golf club should be laying flat on a flat surface so that the face is parallel to the ground.
- Place the measuring stick directly behind the golf club. ...
What is the standard length for a golf club?
What Is the Standard Length of a Golf Club?
- Rules of Golf. The rules regarding golf club construction are found in Appendix II of the Rules of Golf, published by the United States Golf Association.
- Graphite Vs. Steel. ...
- Drivers. In a 2010 “Golf Digest” article, PGA Tour player Bubba Watson said the typical off-the-rack driver is 45.5 inches long.
- Irons and Hybrids. ...
What is the average size of a golf club?
The standard length of a driver for men used to be 43.5 inches with a steel shaft and 44 inches for a graphite shaft. However, in the 21st century a standard driver is considered to be 45 inches. Most male golfers are wielding drivers that measure 45 to 48 inches, the maximum allowed under the United States Golf Association's Rules of Golf.
What length golf clubs do you need?
- 3-wood
- 4- and 5-hybrids
- 6- to 9-irons
- Pitching wedge
- Sand wedge
- Driver
- Putter
How to size golf clubs for better performance?
- Swing the clubs Swinging a standard-length club is an essential step in fitting golf clubs. ...
- Apply tape to the bottom of your clubs This step determines where your club will make contact with the ground. ...
- Identify your handicap Finally, identifying your handicap will allow you to match with the right club type. ...
How long should my golf clubs be for my height?
Using the ratio of every 6" of height there should be a 1" change in length then there should be a 1 ½" difference between their 5-irons. For example, recommend 36.5" for the lady and 38" for the man (or 36.75" / 38.25").
How do I know what length my irons should be?
For example, for a golfer that stands 6'2” and has a wrist-to-floor of 39”, the recommendation for proper club length would be 1/2” longer than standard length.
How do you know if your golf clubs are too long?
The most common way to tell if your clubs are too long is that your back will be too upright, the toe of your club will be off the ground at address, and you will often make contact towards the toe of the club.
How do you know if your golf clubs are too short?
6 Signs Your Golf Clubs are Too ShortYou need to bend too much at the waist before swinging.You also have to bend your knees pre-swing.You keep hitting the ball with the golf club's heel.The swing path is in to out.The tempo is too quick.The ball tends to veer off to the right.
How to measure club length?
Calibrate the club length measuring apparatus. Turn on the machine and move the grip support assembly to the left until it reaches the end of the apparatus. Put the calibration rod into the machine, resting the right end of the rod against the 60-degree sole plate of the clubhead support.
How to rock a golf club back and forth?
Ensure the clubhead rests against the clubhead support, with the sole touching the 60-degree sole plate. The grip should rest in the grip support. Gently rock the club back and forth to be sure it’s not being constrained and can move naturally.
How to measure golf club?
To measure a golf club, start by laying it on a flat, horizontal surface, like a table or countertop . Then, turn the bottom of the club head so it's at a 60-degree angle to the surface you're measuring the club on. Finally, use a tape measure to measure from the end of the grip to the point where the bottom of the club head meets the flat surface. ...
How to read scale on a scuba diver?
Slide the grip support until it touches the grip, then read the scale. Move the grip support to the right until the butt plate is gently touching the end of the grip. Step back from the scale and read the digital value. ...
Where is the sole on a golf club?
The sole is the bottom of the club head. You may need to rest the sole against a plate to ensure it sits at the proper angle. Measure from the end of the grip to the end of the sole. Use a tape measure to find the length in inches between the end of the grip and the farthest point that the sole contacts the horizontal surface.
Which plane should golf clubs be measured on?
Clubs should be measured on a horizontal, rather than vertical, plane to get the most accurate results. ...
How does a lengthened golf club work?
A longer distance can be achieved with a lengthened club if you have the ability to swing it with the same force and speed that you did with a shorter club . This increases the ball’s velocity upon impact, and you can hit it farther. Flex: The flex of the shaft will be altered. This happens for a few reasons.
What happens if you play too long in a golf club?
If the club is too long for you, then you’re spending extra time during ramp up which is the amount of time spent during your initial downswing. You want a balance between your abilities, ramp up, and momentum while cutting through the wind with as little resistance as possible.
Why are golf clubs made the way they are?
The reason clubs are made the way they are is to gather momentum as you swing down. If your club is too short, you’re going to build momentum while having resistance, meaning you will push too hard against the wind and not just swing naturally. There’s not enough weight to the club.
Why do you have to swoop on your golf club?
Because the club is longer, you have to swoop on your downward swing, causing the force of your wood – if you’ve hit it correctly – to be applied to the bottom of the ball and send it upwards. A wood without enough length just doesn’t cut it. You’d be sending the ball higher but with almost no distance.
When shortening a golf club, do you have to remove the crown?
When you shorten a golf club, you have to remove the crown, and safely disconnect the shaft from the head.
Why is my driver heavier than my wedge?
That’s because the head is a little heavier to account for the extra force it takes to send your ball as far as it goes. During your driver shot, you should send the ball farther than any other point in your round of golf.
Does golf club length matter?
Golf club length matters a ton. If you’re holding proper form, where your back and arms are straight and your core is engaged when you swing, then you’re doing all that you can on that front. When you swing the club, it’s supposed to effortlessly collide with the ball and send it flying.
What size ruler do you need for golf club reading?
For this, you need a ruler of 48 inches or greater. You can use a measuring tape. However, the flexibility of the tape can hamper the entire procedure. For best readings use a golf club measuring ruler. Now, if you got the ruler in your hands, we can proceed. Follow these steps one after another: Step 1.
How long should a golf club be?
According to USGA the length of a golf club should not exceed 48 inches. So, the length can be either 48 inches or lower. Within this limitation, you can get club sizes of any length depending on your height or style of play.
What is the best length for putters?
For putters. Analyzing the posture and wrist-to-floor measurement, 32-35” can be a good length for putters that most golfers will be comfortable with. Longer putters will cause several problems in your gameplay. It will restrict you from being close to the ball and miss targets in most cases.
What happens if you lie your golf club higher than the heel?
Placing the club with its toe higher than the heel will lessen your club length measurement. Number 2: If you do the opposite which means if the heel is higher above the ground than the toe then your club length will increase.
How long was the driver's club in the 1970s?
Manufacturers have invested in research and understanding user psychology to get the correct length of the club. During 1970s-80s, the drivers had 43 inches of length. For 5-woods it was even lesser, just 41 inches. The reason behind the shifts in club length is the mindset of the golfers.
Where is the ruler on a putter?
The ruler method can be used for putters. Instead of the heel, the ruler is placed beside the center of the putter. This means your ruler must be placed along the shaft to the ground. The ruler must be placed behind the club, and the final reading must be taken from the edge of the grip cap.
Can custom fitters get the job done faster?
Club lengths might vary person to person, so it’s better to take expert opinion and support. Custom fitters can get the job done faster and easier.
What does a professional club fitter do?
Professional club fitters take a number of factors into consideration as they assess the club specification requirements of each golfer. Specifically as it pertains to club length, they will look at a couple of static measurements, and they will also conduct a “dynamic” fitting assessment:
Why is wrist to floor measurement important?
The reason it is so pervasive in club fitting is because it adds an additional layer to the measurement, which improves its accuracy.
How important is shaft length in golf clubs?
The length of the shaft in your driver is extremely important, as it plays a big role in determining how fast you can swing the club, the club’s path and angle of attack and, ultimately, how well you’re able to make center-face contact.
Why is playing with clubs too short bad?
Playing with clubs that are either too short or too long can cause a golfer to change their stance or swing in ways that could negatively affect the outcome. It can lead to subconscious swing compensations that can result in inconsistent ball striking.
What happens if a golfer has a short club?
If a player has clubs that are too short, they will usually bend over too much from the waist in their address position. Conversely, clubs that are too long will require the player to stand too erect. Both of these subconscious adjustments could potentially make their swing motion less effective than it should be.
What is the most important factor in creating distance with the driver?
However, studies have shown that the single most important factor in creating distance with the driver is not the length of the shaft, but rather the golfer’s ability to hit the ball on the sweet spot of the club face. So, while shaft length is important in generating distance, there is a point of “diminishing returns.”.
Why are golf clubs not fitting?
Having golf clubs that are not properly fitted for length can be a major contributor to inconsistent performance. For the same reasons that someone who is 6’ 5” wouldn’t walk into a men’s clothing store and buy a suit off the rack, golfers need to make sure that the golf clubs that they buy are suited to their body type and size.
How tall is a golf club?
Manufacturers usually make clubs to account for golfers anywhere between 4’8” to 6’7” inches tall. The second measurement is wrist-to-floor distance. This is done by standing on a flat surface with your arms relaxed and pointing down. You then measure the distance between the ground and the line where your wrist meets your hand.
What factors affect the size of a golf club?
Here’s another factor that affects the appropriate golf club size. The angle and the grip size of the club are as important as the height and wrist-to-floor measurements . However, this means more to serious professional golfers than to someone just starting out.
Why do manufacturers make golf tables?
Manufacturers create such tables to help everyone from beginner golfers to pro golfers choose the right club size for their play. Here’s how your size affects the dimensions of your needed golf club size and why it matters. Last but not least, the grip size should also be determined for the club to fit perfectly in your hands.
What is the difference between men's and women's golf clubs?
The difference between men’s and women’s clubs is generally noticeable on the grip. Men’s golf clubs have larger grips and are also about 2.5 cm longer than women’s golf clubs. Kids’ clubs are even smaller than women’s for the most part. Knowing what type of golf club you need is the first step in determining the appropriate size.
What is plus and minus golf clubs?
The adjustments on a size chart are made with reference to the standard clubs. Therefore, the plus and minus values show how much shorter or longer your golf club should be compared to the standard, according to your measurements, ...
What is the second measurement of a grip?
The second measurement is the length of your middle finger from the tip to its base. When you have these two measurements, you can then find the appropriate grip size on a manufacturer’s size chart. Note that we only use the middle finger as an example as it applies to most people.
Can you play golf with an off size club?
Because there are plenty of variations, it’s unsurprising that a lot of people sometimes play with off-size clubs. Most pros recommend that even beginners should opt for a perfectly sized golf club in order to have the best learning experience.
Why Is Choosing the Right Club Length Crucial?
There are several reasons why you should measure your golf club length. For starters, if you play with a club that’s too long or too short, you could end up changing your swing or stance in a way that could impact the outcome negatively. It can also result in inconsistent ball striking when you subconsciously make compensations for your swing.
Components of Club Length
When it comes to choosing the best driver and irons, there are several factors that you should consider. Here’s a quick overview of the components of club length.
Methods to Measure Club Length
Here’s an interesting fact according to the Telegraph Trusted Source The secret to mastering golf: play with your other hand Scientists say swapping hands boosts swing control and accuracy, with technique used by top players such as Jordan Spieth and Phil Mickelson www.telegraph.co.uk ; playing with your other hand helps you to master golf.
Ideal Club Length Chart
There’s no standard length of golf clubs which gives clubmakers the freedom to make golf clubs that they assume would be appropriate. You should, however, note that while there is no ideal club length, the USGA has placed a limitation on the maximum length; 48 inches.
Final Thoughts
To sum it up on how to measure golf club length, the ideal length varies based on the player’s height. We have highlighted 2 simple methods that you can use to measure your ideal length, but if for a more thorough fitting, we recommend that you contact a professional.
How to measure wrist for golf club?
Step 2. Stand with your hands hanging loosely by your side. Have your assistant measure the distance from where your wrist hinges to the ground, going straight down. This is your wrist-to-floor measurement. Step 3. Use the "Golf Club Measurement Guide" (see Resources).
What is the average size of a golf club for women?
As a result, the standard size of golf club for women is shorter in length and is designed for women that are between 65-inches (5'5") and 69-inches (5'9") tall. For women who are shorter than 5'5", golf manufacturers produce a "petite" golf club that is both shorter and lighter than the standard length club.
How much shorter are ladies golf clubs than men?
Ladies' standard-sized golf clubs run approximately 1-inch shorter than men's clubs.
