In the case of an E-Z-GO Powerwise charger, the logic board is actually powered by the DC voltage from the golf car. If there is no voltage in the batteries, the logic board does not even activate. In a normal situation, the logic board gets its current from the cart through the small red wire in the DC power cord.
Full Answer
When did EZ Go Stop Making 2-cycle golf carts?
The E-Z-GO company officially stopped producing its 2-cycle golf carts in 1991, when the 4-cylinder carts were introduced. However, for a few years, these engines were produced in limited availability in some golf carts and utility vehicles.
How do I know what model of EZGO golf cart I have?
Alot of the newer carts will have stickers on the factory body to help you distinguish your model. You can also take a look at the pictures and images below to help determine what you have. These are the most popular Ezgo golf cart models offered over the years. So you own a Ezgo golf cart do ya…
What kind of engine does an EZGO marathon golf cart have?
It was a 9 hp – 295 cc engine that just performed great and was used in all Marathon models. Though with the demand for more power apparent in golf carts and utility vehicles, it was soon to be replaced with a 350 cc version introduced in the Medalist model golf cart. The Ezgo Medalist Model Golf Cart (1993 -1995)
When should I replace the coil on my EZGO golf cart?
If outside the range, the coil should be replaced. Pulser coils can be fried, and the only way to start a EZGO golf cart is by replacing the coil. You can test the coil and use follow the below steps to remove and install a new one.
How does EZGO fuel pump work?
The fuel pump has several nozzles on it to accept the vacuum line, and both the Fuel In and Fuel Out lines. Inside the pump, there are several diaphragms which use the pulsing action created by the vacuum of the crankcase pressure to draw fuel from the storage tank and push it onward to the carburetor of the golf cart.
What does 2 stroke golf cart mean?
There are two fundamentally different kinds of gas engines that have been used in gas golf carts over the years: A 2-cycle (also called a 2-stroke, which requires a certain amount of special 2-cycle oil to be mixed with the gas, either in the tank or injected into the fuel by means of a pump) and a 4-cycle engine ( ...
How does a golf cart gas pedal work?
How Does An Electric Golf Cart Accelerator Work? The golf cart speed controller and solenoid are both controlled by the accelerator. The pedal is connected to the potentiometer. That means when you are pressing the pedal for acceleration, you are actually going through the potentiometer by pushing a rod.
How does a gas golf cart reverse work?
How does reverse work on a golf cart? Golf carts have a button or lever that allows you to switch between forward and reverse gears. The reverse switch is found below the driver's seat, and can be activated by pulling the handle left or right. Once pulled, the golf cart will start moving in reverse.
How fast does a 2-stroke golf cart go?
Although, new gasoline and electric golf cart versions of Yamaha all have the same top speed. The top speed of both versions of Yamaha golf carts is 19 mph (31 kph). The fastest electric golf cart that Club Car has on offer is the Villager 2+2 LSV that goes 23 mph. The fastest gasoline Club Car only goes 19 mph.
How does a 2-stroke engine work?
Two-stroke engines work by combining more functions into one piston-movement; during the upwards movement of the piston (compressing the air/fuel/oil mixture) in the combustion chamber, underneath the piston a fresh mixture of air/fuel/oil is drawn in the hermetically closed crankcase.
How does a gas golf cart start and stop?
The system controls automatic start and stop of the starter motor and engine by feeding back the output frequency of the alternator. When installed on an off-road utility vehicle, this system, will allow the operator to conveniently start and stop the engine by depressing or releasing the accelerator pedal.
How do you start a gas powered golf cart?
0:112:14How To Start a Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipForward neutral and reverse okay so what we do is we take the key. We move it to on we don't goMoreForward neutral and reverse okay so what we do is we take the key. We move it to on we don't go anywhere we're actually on a slight hill.
Why does my golf cart not accelerate?
The main reason why a golf cart won't accelerate is because of bad solenoid, weak battery or faulty speed controller.
Why won't my gas golf cart go forward or reverse?
The problem could be with either the Run/Tow switch or Forward/Reverse switch or both. Check the switches to ensure that they aren't stuck midway. If they are, getting them released should help. However, if they show signs of wear and tear, you must get them replaced.
How does a gas golf cart forward reverse switch work?
0:379:43Golf Cart Forward and Reverse Switch Direction Selector Tutorial - YouTubeYouTubeStart of suggested clipEnd of suggested clipThat is brand new it simply cables connect to the bright copper colored contacts. And the switchMoreThat is brand new it simply cables connect to the bright copper colored contacts. And the switch rotates through a hand action and that changes the polarity.
Why does my ezgo golf cart not move?
Why an EZGO Clicks but Won't Move? A EZGO golf cart can click but not move due to a faulty solenoid, or damage to the wires connecting the ITS coil to the controller. EZGO golf cart owners often assume that the batteries on their carts are fine and look for other reasons when faced with issues.
How to tell if a golf cart is a 2-cycle or 4-cycle?
One of the easiest ways to determine if an engine is a 2- or 4-cycle is by the number of spark plugs. One spark plug defines a 2-cycle engine, while a 4-cycle engine has four spark plugs. When reassembling one of these 2-cycle ...
How many spark plugs are needed for a 2 cycle engine?
One spark plug defines a 2-cycle engine, while a 4-cycle engine has four spark plugs. When reassembling one of these 2-cycle engines, the most important thing to keep in mind is to not overbore the cylinders to a larger diameter. After compressing the springs into the cylinder, one cannot rotate the cylinder.
What years did the Marathon golf cart come out?
Marathon (1975 to 1993) The Marathon model golf cart brought in a new era and technology. The model was a great success. Its particular features included a metal body with a front plastic nose part, individual seating, and no handles.
What is the Freedom RXV?
The Freedom RXV model comes with upgraded features, such as independent front suspension, a spacious dash, and an automatic parking brake. The RXV golf cart model provides efficient performance and a host of upgraded features.
For the 295cc or a 350cc twin-cylinder OHC engine. 1991 – Present
Tools required: Ratchet with 6″ extension, 10mm socket, 10mm socket wrench, flat blade screwdriver, and a feeler gauge. Note: if the screw (C) has a square head instead of a flat blade slot, this takes a tool designed just for this purpose.
For the Kawasaki FJ400 401cc 4-cycle Single Cylinder 1996 – Present
Tools required: Ratchet with 6″ extension, 10mm socket, 3mm hex wrench, feeler gauge.
When did Ezgo golf carts start being battery powered?
All Ezgo golf carts where battery powered until 1971 when they introduced the first gas engine sourced from Fuji. To date they have produced millions of Gas or Electric vehicles most of which still in service today throughout the world.
When was the first Ezgo golf cart made?
The first gas model Ezgo golf cart was produced in 1971. 1971 was great year for a lot of things with gas combustible engines. Ezgo was no exception. This was a milestone for them as it stood up until then all were strictly electric vehicles. Using a 175cc model 17-CES 1PG two cycle Robin version.
When was the Ezgo Marathon Golf Cart made?
The Ezgo Marathon Model Golf Cart (1975 -1993 ) With great success and production numbers thus far for the company, the introduction of the Marathon model golf cart was bringing in a whole new era of golf carts and technology.
When did Billy and Ezgo leave Ezgo?
In the 1960’s they sold out to current owners Textron Company. The two brothers continued to work with Ezgo and Textron until 1978. Then Billy and a handful of employees decided to leave Ezgo to purchase Club Car at the time was located in Texas.
When did Ezgo use the EC25?
The EC25-2PG engine model was used until 1988. Then in 1989 they used the EC25-3PG 244cc two stroke Robin engine model but only until 1993. In between then they developed another great little engine which was Ezgo’s first four stroke.
What engine did the EC25-DS have?
In 1976 they came out with a six head bolt model EC25-DS 244cc two stroke Robin engine also made by Fugi. This engine also had an internal starter/generator.