How do you fix a golf cart accelerator?
Open up your cart hood and find the wires connected to your controller. Check to make sure each of these wires is properly screwed down and held in place. Inspect all other wires throughout your engine and accelerators. Tighten the connections on these wires to ensure that they run smoothly.
How do you disassemble a Yamaha golf cart?
0:538:59Drive ones from 2007 up to 2016. You do have to remove the top or top supports. To be able to removeMoreDrive ones from 2007 up to 2016. You do have to remove the top or top supports. To be able to remove the front or rear body section from the cart.
How do you adjust the throttle cable on a Yamaha golf cart?
Yamaha G16 throttle cable adjustment Adjust the throttle cable from the governor to the carburetor by turning the governor lever in the counterclockwise fully. Ensure that the carburetor throttle valve is open fully. If not, turn the adjustment nuts either inwards or outwards to adjust the throttle cable.
How do you take the governor off a Yamaha golf cart?
General InstructionsDetach the cable from the carburetor. The cable is about the width of a straw. ... Follow the disconnected cable up to the governor. ... Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ... Using your wrench, remove the bolt on the gas pedal shaft.
Where is the model number on a Yamaha golf cart?
There serial number on your Yamaha Golf Cart can be located in one of three places:Under the seat where the floor board meets the motor compartment.Under the rear bumper on the frame.Under driver side glove box.
How do you take the bumper off a Yamaha golf cart?
0:555:14There's two bolts that hold the bumper on to the frame. You're going to use ten millimeter socketMoreThere's two bolts that hold the bumper on to the frame. You're going to use ten millimeter socket and remove. These. Using a 17 millimeter socket.
Why does my Yamaha golf cart backfire?
Engine backfiring occurs when there is an air leak within your golf cart or sometimes when there is too much fuel inside. This can cause the piston to slam against the cylinder head and cause a tapping sound. An essential component of any golf cart is the drive belt.
How do I stop my Yamaha golf cart from backfiring?
One simple way to stop the golf cart from backfiring is to use good quality fuel. Once this is done, ensure that the throttle plate is closed by adjusting the accelerator cable at the plate.
How do I speed up my Yamaha drive 2 golf cart?
1:544:32Down to make sure that i'm getting maximum speed out of these carts i also like to make sure that myMoreDown to make sure that i'm getting maximum speed out of these carts i also like to make sure that my throttle cable is adjusted properly to ensure that the throttle. Body is getting open to the wide.
How do I make my Yamaha electric golf cart go faster?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.
How do you remove the speed limiter on a electric golf cart?
Basically, an electric speed governor can be controlled by a tiny metal rod that's located by the clutch of your golf cart. First things first: The electric speed governor is connected to a cable. You can adjust your speed by rotating the nut in a counterclockwise rotation.
How do you speed up a Yamaha golf cart?
By tightening the nut, you expose more of the rod and increase the speed of the cart. Overtightening, however, can damage the engine or allow oil to seep into the carburetor or muffler. NOTE: Your engine warranty may be affected by increasing the speed setting of your governor.