This method is appropriate for a Yamaha G9 cart and other carts similar to it:
- Open up your cart hood to expose your carburetor and to make it easier to work upon
- Find the pilot adjustment screw on the edge of your carburetor
- Pay attention to this screw – it should be a sharp point and not flat
- Carefully remove this screw and then carefully screw it back
- Turn this screw out one and one-half turns to adjust it properly
- Pull out the pilot adjustment screw. ...
- Rethread the screw back until it's slightly seated.
- Turn the screw outwards by 1-1/2 turns.
- Push the throttle stop screw backward until the throttle shaft is closed completely.
- Turn the screw in by a 1/4 turn.
How to adjust a carburetor on a golf cart?
How to Remove Carburetor on a 1993 EZGO Marathon
- Move the starter to the front of the golf cart.
- Pull the stud bolt of the carburetor gently.
- Turn the carburetor and remove it.
How do you slow down a gas Yamaha golf cart?
Yamaha Golf Cart Running Slow with New Batteries
- Ensure that the distilled water levels are always above 50% inside the battery. New batteries do usually have enough distilled water levels but might drain out in a short while.
- Ensuring proper series wiring is important while installing a new battery in your Yamaha golf cart. ...
- Check the user guide manual for instructions on setting up a new battery. ...
How to properly charge your golf cart Yamaha?
Yamaha g1 Golf Cart not charging
- Often, the G1 golf cart doesn’t charge because of a bad receptacle. Make sure that the receptacles fit tightly and are clean. ...
- Check the plastic coverings on the prongs. A broken cover can also build problems. ...
- The next thing to watch out for is corrosion. Corrosion mainly occurs at the battery terminals. ...
Why does my Yamaha golf cart backfire?
Yamaha Golf Cart Backfires
- The needed adjustment to remedy golf cart backfiring will vary between manufacturers and year models. ...
- 83 yamaha g1 backfiring: Gas Yamaha: gas 2005 yamaha backfiring: Gas Club Car: Yamaha G9 engine adjustment ( backfiring issue & running rough ) Gas Yamaha: 1987 Yamaha gas cart ...
- 3. ...
How do you adjust a golf cart carburetor?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
Where is the carburetor adjustment screw?
3:057:36Two-Stroke Carburetor | Adjustment Screws | How they Work? - YouTubeYouTubeStart of suggested clipEnd of suggested clipOut into the actual fuel vane there. So if we were to screw this adjuster screw in further. So thatMoreOut into the actual fuel vane there. So if we were to screw this adjuster screw in further. So that it protrudes.
How can I make my Yamaha gas golf cart go faster?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
Why does my Yamaha golf cart backfire?
The golf cart backfires through the carburetor because of an open throttle plate. The accelerator cable at the scale is out of adjustment and, in turn, stops the vessel from closing when the microswitch makes contact with the ignition.
How do you adjust air mixture screws?
Turn the screw clockwise until the engine starts to sound rough.Tightening the screw weakens the air and fuel mixture and decreases the amount of fuel flowing to the engine.Tightening the screw is also called making the fuel mixture leaner, which lowers the RPMs at which the engine idles.More items...
What are the two adjustment screws on a carburetor?
Find the adjustment screws on the front of the carburetor. There should be two screws on the front of the carburetor, which are used to adjust the air and fuel mixture. Often these look like flat-head screws and you can use a screwdriver to turn them, adjusting the amount of fuel and air mixing in the carb.
Why is my gas golf cart running slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
How fast will a Yamaha gas golf cart go?
19 mphAlthough, new gasoline and electric golf cart versions of Yamaha all have the same top speed. The top speed of both versions of Yamaha golf carts is 19 mph (31 kph).
How do you adjust the governor on a Yamaha electric golf cart?
1:042:57Yamaha G29/DRIVE Governor Speed Increase | ASK DAVE | Golf Cart ...YouTubeStart of suggested clipEnd of suggested clipAnd locating the governor under the service panel in the rear above the engine. For reference it'sMoreAnd locating the governor under the service panel in the rear above the engine. For reference it's just opposite the driven clutch at the rear of the engine. Compartment.
Why is my golf cart sputtering?
Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.
Why does my golf cart backfire when I let off the gas?
The golf cart backfires when you let off gas is because the carburetor butterfly isn't getting closed completely. Air suction from the exhaust gasket is another possible cause. Checking the carburetor and adjusting the return spring to its original position so that the carburetor is closed solves the problem.
How do you adjust the carburetor on a Yamaha g22 golf cart?
How to Adjust Yamaha Golf Cart CarburetorPull out the pilot adjustment screw. ... Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
How to Adjust a Golf Cart Carburetor
The way to adjust the carburetor on a golf cart will depend on the model of golf cart. In most cases, you’ll need to adjust the jet pilot screw, perform a valve clearance adjustment and then clean the carburetor.
Bad Golf Cart Carburetor Symptoms
The engine shows a reduced performance such as a reduction in fuel efficiency or power and sluggish acceleration.
Troubleshooting Golf Cart Carburetor Problems
Adjust the idle jet pilot screw on the carburetor. This can be done by doing a 1/4 turn of the screw.
How to Adjust Yamaha Golf Cart Carburetor
Pull out the pilot adjustment screw. It must be present at a sharp point and not a flat spot.
Yamaha Golf Cart Carb Vs EFI
The carb model is more powerful as well as starts and goes faster when compared to the EFI. The EFI experiences delay to start moving when the pedal is pressed.
How to Adjust EZGO Golf Cart Carburetor
Check the valve adjustment for proper compression using a compression tester. You will have to pull out the plugs and put the tester inside.
EZGO Golf Cart Carburetor Diagram
The EZGO TXT gas golf cart carburetor diagram shows just one adjustment on the engine. This is present above the carburetor towards its rear. In a 2-cycle cart, this is the idle circuit and is initially set for 1-1/2 outward turns.
What is a golf cart carburetor?
A golf cart carburetor is just like any other carburetor on a gas-powered vehicle. While it may be a bit smaller and have a slightly simpler design, the overall look and feel is the same. More importantly, the purpose of a carburetor on a golf cart remains the same – decreasing fuel waste and minimizing your carbon output to ensure ...
How to get your carburetor in good order?
Once the engine’s operation starts to sound drastically different, stop turning the screw. Bring the screw back until the change in the engine disappears or evens out. Ride your cart to test how well you have adjusted your carburetor. Repeat these steps, as needed, to get your carburetor in great operational order.
Why is my golf cart not running?
That’s because your carburetor helps to keep the cart running smoothly and with even and powerful acceleration. Other problems that may affect your golf cart include regular overheating or backfiring.
Why does my carburetor stutter?
These issues occur because your carburetor does not properly mix your fuel and it is much too lean for your cart. As a result, it may stutter and struggle to run properly without help. You may also see this problem trigger a steady cloud of black smoke as you drive that is quite nauseous.
Do carburetors last longer?
However, they are also more powerful and typically last longer, which makes them popular with a certain subset of buyers. However, these buyers may find that the carburetor on their cart is threatening to go out or is causing issues with cart operation. As a result, it is important for cart owners to understand how to adjust ...
Is my carburetor struggling?
Typically , your cart will showcase a myriad of issues that will make it quite clear that your carburetor is struggling . However, there are many differences between the cart models and manufacturers that may make this process a little harder to properly execute.
Does EZGO have a carburetor?
EZGO manufactures many different carts, each gas model of which has a carburetor that may run into complications over time. These issues are not uncommon with other cart manufacturers – however, some are more common in EZGO carts.
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
How many times can a Yamaha engine be rebuilt?
Yamaha engines are durable and because of the simple design, they can be successfully rebuilt 3 or 4 times . Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard.
Does the G21 have a filter?
The G2, G9, G11, and the G21 model Fuel tank has a screw-in filter that is difficult to reach. It is advisable to remove the 2-4 bolts holding the tank in and pull the tank out to drain and replace the filter. Please note that on ALL models using the screw-in filter the tank will need to be drained.
How to change the speed of a golf cart?
Locate the spring on the differential or carburetor that helps in changing the cart speed by adjusting its tension. Increase the length of the cable that is fitted on to the body of the throttle and clutch of the two-stroke engine.
How to start a golf cart with a gas pedal?
Locate the gas pedal that is fitted to the governor and remove the connection. Re-route the gas pedal to the carburetor. Remove the bolt present on the shaft of the gas pedal. Slide the shaft upwards so that the gas pedal has more play. Tighten the bolt and start the golf cart.
How fast is an EZGO golf cart?
The top speed of an EZGO golf cart is usually 19.9mph and the average speed is 14mph to 15mph. With governor adjustment, the EZGO cart can go faster by 5 to 10mph.
What is a golf cart governor?
A golf cart governor is a mechanical device that helps in controlling the maximum speed of the cart when it moves on flat ground. This device prevents the engine RPMs from increasing beyond the recommended specifications.
How to ride a golf cart at full speed?
Ride the cart at full speed over a course of known length. This will ensure that the governor controls the speed of the cart within factory specifications. Fasten the black plastic cover and put the seat back in place. Take care when tightening the nut. The more you tighten, the faster your cart will go.
Where is the governor arm on a golf cart?
Locate the governor arm of the golf cart. This is mounted above the rear axle housing and under the cart. Depending on the cart model, there may be a protection plate above the governor.
Can you remove a golf cart governor?
It doesn’t take much time or skill to remove a golf cart governor. With some basic mechanical expertise and general-purpose tools, you can do this yourself. The process is more or less the same in all golf carts.
