How do you take the governor off a golf cart?
Method 2 Loosen the nut attached to the governor arm with a 7/16” wrench to turn the shaft. Push the governor arm to the back of the cart and grasp it with your hand. Turn the governor shaft in the counter-clockwise direction until it cannot be turned further. Retighten the nut and let …
How to disconnect the governor on golf carts?
How to Adjust the Governor on a Golf Cart. Step 1. Look for a small metal rod near your golf cart’s clutch. If you find this rod, then your governor can be easily adjusted by accessing the ...
How to adjust the governor on a Yamaha golf cart?
Steps to Adjust EZ-GO Golf Cart Governor. Step 1 - First, lift the seat of your engine to reveal seat cousins. You may need to remove screws in some carts, and they often have Philips heads, so make sure your toolset has this available if required. Step 2 - …
How to remove Governor on a club car golf cart?
By mechanically pulling the throttle lever back, you decrease the gas flow to the engine and control the golf cart’s speed. This governor can be adjusted by adjusting the cable nut which holds the cable to the throttle lever.
How can I make my gas golf cart go faster?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.May 18, 2021
How do you change the governor on a golf cart?
General InstructionsDetach the cable from the carburetor. The cable is about the width of a straw. ... Follow the disconnected cable up to the governor. ... Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ... Using your wrench, remove the bolt on the gas pedal shaft.
How do I adjust the speed on my EZ Go golf cart?
One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.Jun 16, 2015
What does the governor do on a golf cart?
0:061:28Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt is a control speed.MoreIt is a control speed.
Why is my golf cart so slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.Jul 14, 2021
How can I make my electric golf cart go faster without upgrading?
How to Make an Electric Golf Cart Faster Without UpgradesWash Your Cart Properly. ... Inspect the Batteries. ... Refill the Battery Water. ... Check the Gas Pedal and Linkage. ... Measure the Tire Pressure. ... Charge Up Your Battery Unit. ... Lighten Up Your Cart's Weight.
How do you adjust the governor on a EZ GO TXT gas golf cart?
How to Adjust the Governor on a Gas E-Z-Go Golf CartLocate the governor arm mounted on top of the rear axle case underneath the cart. ... Loosen the adjusting locknut on the end of the governor spring. ... Retighten the adjusting locknut.More items...
How do you remove the governor on a EZ Go electric golf cart?
0:101:28Golf Tips & Etiquette : Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell a golf carts governor located is actually down in the motor compartment some of them there'sMoreWell a golf carts governor located is actually down in the motor compartment some of them there's electric ones nowadays.
Can you make a 36 volt golf cart faster?
Put larger tires on the cart. Larger tires will allow the 36 volts to work at the same power but cover more ground, as the larger surface area of the tires covers more ground. Replace any old or worn-out parts that are causing the cart to move slower than it should.
Is there a governor on a golf cart?
Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine.
How to find the governor on a golf cart?
Locate the golf cart’s governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor. Use a screwdriver—or in some cases a wrench—to loosen the tension on the governor’s springs. You have now adjusted the governor for faster speed.
Who is the writer of GolfCarCatalog.com?
GolfCarCatalog.com – “Adjusting Your Golf Cart’s Governor”. Writer Bio. Richard Kalinowski began writing professionally in 2006. He also works as a website programmer and graphic designer for several clients.
Can a golf cart be a nuisance?
In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds. Luckily, you don’t have to stick with these standard speeds. Golf cart speed is often controlled by a device called a governor, and you can adjust the governor on a golf cart relatively easily to make the cart faster.
Can golf carts be adjusted manually?
By Richard Kalinowski. Governors limit the speed of golf carts but can be adjusted manually. In theory, golf carts make it easier for players to get across the course, saving their much-needed energy for the game. In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds.
How to adjust EZ Go cart governor?
To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.
How to raise the top speed of a golf cart?
To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly. If you cannot find this spring, you likely have a newer model that is more difficult to adjust, though this is rare. Lift up the seat. Remove the seat cousins, which hide the engine.
How to make a golf cart go faster?
Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.
How to get a cart to move faster?
1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.
How fast can a golf cart go?
Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.
How many screws are in a golf cart engine?
There should be five screws in most models. The engine is in the front of golf carts, underneath this panel. Take off the plastic cover and set it aside with the seats. ...
How to change the speed of a car?
Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...
What are the governors on a Yamaha golf cart?
The three types of governors in Yamaha models include spring adjustment, clutch cable, and spark regulation governors.
How to make a golf cart go faster?
To make a golf cart go faster, you can also consider installing a new engine. Always consult the owner's manual for the Yamaha golf cart model you have. Every model has limits to how fast it can physically go without engine damage or failure resulting. To make a golf cart go faster, you can also consider installing a new engine.
