If you would like to do it without cutting it off you can follow these steps:
- Make sure the golf cart is turned off, the transition is in neutral, and the brakes are locked. ...
- If the drive belt is loose you can remove it very easily by pulling it off the rear and starter clutch.
- If it’s too hard to do so, you can simply use a screwdriver and place it under the drive belt as a lever while rotating the clutch and it will ...
How to change drive belt on a club car golf cart?
How to Change the Drive Belt on a Club Car Golf Cart Switch the engine OFF after parking the golf cart.. Allow the engine to cool, if it has been running for some time.. Remove the engine cover.. You will be able to see the drive belt now.. Use an open-end wrench to loosen the drive belt tension ...
What happens if the drive belt is too loose on an EZGO?
A loose drive belt can result in your EZGO Golf Cart to lose top speed and underperform. If the drive belt is the right model but it seems to be too loose then it could be because there is something stuck in the clutch or there is some damage in the clutch.
Why is my EZGO golf cart losing top speed?
A loose drive belt can result in your EZGO Golf Cart to lose top speed and underperform. If the drive belt is the right model but it seems to be too loose then it could be because there is something stuck in the clutch or there is some damage in the clutch. In this case you’ll need to call a certified technician to inspect your golf cart.
How do I know if my golf cart drive belt is bad?
The best test to see if a golf cart drive belt has the correct tension is to use the Finger Test. Press the drive belt with one finger at its center between the two clutches. It should sag by just an inch and a half. Another method suggested by an expert is to go for a drive belt that is 1-inch shorter than the stock belt in your cart.
Can you adjust drive belt on EZGO golf cart?
And EZGO is no different – there are no screws, knobs, or any other type of adjustment item that you can use to tighten up your belt. Once the belt is one, it has the same tightness and can only be changed if you swap the belt for another one either the proper length and width for your specific cart engine.
How tight should the drive belt be on a golf cart?
The reason for a Club Car drive belt being too tight can be because the drive belt is too small for the golf cart. The way to check if the belt is fitted correctly is to push the belt down with one finger at the center between the clutches. It should not deflect more than 1.5inches. It should not be less as well.
How do I know if my golf cart belt is too loose?
0:012:00How to Check the Belts in your Gas Golf Cart | Golf Cars UnlimitedYouTubeStart of suggested clipEnd of suggested clipDown below and you don't want to press the moderate pressure on that belt you're gonna want to seeMoreDown below and you don't want to press the moderate pressure on that belt you're gonna want to see about 3/16 to 1/4 inch of deflection. There no more than that that'll be your proper.
How do you tighten the drive belt on a Club Car golf cart?
Slide the old drive belt off the front drive clutch pulley, and then the rear clutch pulley. Slip the new belt around the golf cart's clutch pulley, and then stretch it out over the front pulley. Pull the front pulley forward slightly to increase the belt tension, and then tighten the tension bolt with the wrench.
Can you adjust a golf cart clutch?
If you are unsure about removing the drive belt or the clutch, then you can adjust it. Just take out the belt and wound it again with the secondary clutch according to the requirements, and your problem should be fixed.
How can I speed up my Club Car golf cart?
0:061:31Club Car Precedent Speed Increase SUPER EASY!!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. AndMoreIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. And if you turn it that way or clockwise it speeds things up. Very.
How does a golf cart clutch work?
Both golf cart clutches look similar to a large pulley but each clutch has a sliding sheave that moves in & out along a central shaft as the clutch spins. The other sheave is fixed to either the crankshaft or the differential input shaft and it does not slide, it just spins.
Do golf carts have transmissions?
All golf carts (much like cars) have a clutch, which is the part of the drivetrain that helps the put the power of the motor down through to the wheels/ground. Golf cart clutches are a part of the Continuously Variable Transmission (or CVT).
How do you measure a golf cart belt?
0:002:04How to measure for a go-kart drive belt. - YouTubeYouTubeStart of suggested clipEnd of suggested clipCover. Now the first measurement we're going to take on this is we're going to measure from theMoreCover. Now the first measurement we're going to take on this is we're going to measure from the centerline of the crankshaft. To the centerline of the jack shaft.
How do you put a drive belt on a club car?
5:269:16Club Car DS Tune Up Kit | Starter/Drive Belt | How to Install on ...YouTubeStart of suggested clipEnd of suggested clipYou have to loosen all the bolts up the two up front which are 9/16 and loosen the adjustment bolt.MoreYou have to loosen all the bolts up the two up front which are 9/16 and loosen the adjustment bolt. Here which is a half-inch. So let's get these things loosened. Up.Club Car DS Tune Up Kit | Starter/Drive Belt | How to Install on ...https://www.youtube.com › watchhttps://www.youtube.com › watchSearch for: How do you put a drive belt on a club car?
Are golf carts belt driven?
Belts - Drive Belts The drive belt on your club car golf cart is the one that is loose between both your drive and driven clutch. A worn out belt will slip and not allow your carts engine to power your rear wheels. Replacing your belt will give your golf car a smoother take off and increase the torque as well as speed.Drive Belts - Club Car Parts - DIY Golf Carthttps://diygolfcart.com › club-car-parts › belts-drive-beltshttps://diygolfcart.com › club-car-parts › belts-drive-beltsSearch for: Are golf carts belt driven?
How to check if golf cart drive belt is too tight?
To check if the drive belt is too tight, follow these steps: Switch OFF the golf cart ’s engine. Reach to where the drive belt is located and use your fingers to press the drive belt between the two clutches. The belt must deflect at least one and a half inches under the pressure of your fingers.
What happens if a golf cart belt is too tight?
If the belt is too tight then your starter will be under strain and this should be avoided. The best test to see if a golf cart drive belt has the correct tension is to use the Finger Test.
How to tell if a 1997 club car has a slipping drive belt?
When a 1997 Club Car drive belt is slipping, first make sure that it is the drive belt that is at fault. You may have to remove the cover and watch the clutches in action while the cart is in motion to make sure that it is indeed the drive belt that is slipping.
How to remove drive belt?
Removing the drive belt involves holding the belt with both hands in the center between the driven and drive clutches and lifting the belt. You must now rotate the driven clutch counter-clockwise and slip the belt off the sheave. You can then slide the drive belt off the drive clutch.
Why is my club car drive belt so tight?
The reason for a Club Car drive belt being too tight can be because the drive belt is too small for the golf cart. The way to check if the belt is fitted correctly is to push the belt down with one finger at the center between the clutches. It should not deflect more than 1.5inches. It should not be less as well.
What is the primary function of a golf cart drive belt?
To primary function of a golf cart drive belt is to connect the primary clutch and the secondary clutch. The primary clutch drives the cart and the belt helps it to rotate the secondary clutch (they are referred to as the drive clutch and the driven clutch respectively). The drive belt, unlike some of the other automotive belts, are very thick.
Why does my golf cart drive belt slip?
The reason for the drive belt slipping could be that it is of a larger/longer size and therefore loose. You may start feeling the slippage after driving for a while. This is because the belt gets heated up after the golf cart runs for some time and loosens further .
