How Do I Adjust The Governor On My Club Car
- How far down does your gas pedal go before the starter engages? If more than 1", you need to adjust the throttle rod under the cart. ...
- You will need to look at the carb closely on this one. First, remove the cover of the black box. ...
- Install your tach on the dash somewhere. ...
- Governor removal. ...
Full Answer
How do you take the governor off a golf cart?
Steps to Adjust Club Car Golf Cart Governor Step 1: Sit on the driver's seat and look for a plastic plate held by two small screws on the console. Check the size and type of the screws. Make sure to use the appropriate screwdriver to remove them from the panel.
How to disconnect the governor on golf carts?
Mar 19, 2009 · Follow throttle cable from black box to governor arm of tranny. You can access this through the black access panel behind the seat. Loosen the nut/bolt that clamps the arm to the shaft coming out of the tranny. Once loose, use a flat blade screwdriver to pry apart slightly. Just till it moves freely on the shaft. DO NOT TIGHTEN.
How to adjust the governor on a Yamaha golf cart?
Mar 29, 2020 · The first step in adjusting the governor is locating it. Check for a small rod near the golf cart’s clutch. If this rod is found, the governor can be adjusted by simply tightening or loosening the nut attached to the small wire connected to the rod. If a rod is not found, the governor is likely located inside the golf cart’s engine bay on the largest wire running from the …
How to remove Governor on a club car golf cart?
May 21, 2020 · In this video I explain a quick and easy way to speed up your gas club car golf cart and still retain your factory rpm limiter. NOTE: If you bypass the Gover...
Can you adjust a golf cart's governor?
Yes, it is possible to adjust the governor on a golf cart. Some golf carts use electronic governors, which are considered more difficult to adjust. It is best to consult a professional when dealing with these. The first step in adjusting the governor is locating it. Check for a small rod near the golf cart's clutch.
Where is the governor located on a golf cart?
Check for a small rod near the golf cart's c lutch. If this rod is found, the governor can be adjusted by simply tightening or loosening the nut attached to the small wire connected to the rod. If a rod is not found, the governor is likely located inside the golf cart's engine bay on the largest wire running from the gas pedal.
