Golf-FAQ.com

how to adjust the governor of an ezgo txt golf cart

by Aniyah Glover Published 3 years ago Updated 2 years ago
image

To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open. Then you would turn the bottom "clip" (which is connected to the governor shaft) counter clockwise. This will the governor shaft on top of the governor spool.

Take off the plastic cover and set it aside with the seats. Follow the thickest cable coming fromMoreTake off the plastic cover and set it aside with the seats. Follow the thickest cable coming from the gas pedal until your find a small spring wrapped around a metal rod. This is the governor.

Full Answer

How do you adjust the governor on an EZ GO golf cart?

The function of the governor to control speed within factory preset limits may be affected by adjusting the governor spring. E-Z-Go does not recommend additional measures to alter the governor to permit speeds outside factory preset limits. Locate the governor arm mounted on top of the rear axle case underneath the cart.

How many horsepower does an EZ GO golf cart have?

E-Z-Go gas-powered golf carts are equipped with 9-horsepower, 295 cc Robin engines. Designed entirely for use on golf course trails, E-Z-Go carts are not engineered for higher-speed on-road use and/or cornering.

Can E-Z-Go Carts be used on the road?

Designed entirely for use on golf course trails, E-Z-Go carts are not engineered for higher-speed on-road use and/or cornering.

Should I buy a golf cart with an adjusted Governor?

You'll likely need to get repairs and replacement parts faster on a cart with an adjusted governor. In addition, any cart that can go above 19mph is officially a motor vehicle, and you legally need seatbelts and inspections. This shouldn't be a big problem, but it is worth knowing.

image

How do I increase the speed of my ezgo TXT gas?

Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.

How do I remove the governor from my EZ GO TXT?

General InstructionsDetach the cable from the carburetor. The cable is about the width of a straw. ... Follow the disconnected cable up to the governor. ... Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ... Using your wrench, remove the bolt on the gas pedal shaft.

How do you take a speed limiter off a golf cart?

0:040:46So the farther you bend that normally the faster it goes and then that's it basically when you wantMoreSo the farther you bend that normally the faster it goes and then that's it basically when you want to return your heart you just bend that back down and go back to normal speed.

How can I make my gas golf cart go faster?

Increase the RPM An increase in the input shaft rpm for all differential ratios will produce a higher speed. For a gas golf cart, other than adjusting the governor, the speed may be enhanced by replacing the engine with a higher rpm output model.

What does removing the governor do?

Removing the governor will increase the maximum rpm of the engine, but the internal parts of the Predator 212 are designed for 3600 rpm. Generally, this isn't an issue with just the governor removal, the internal parts can usually withstand 5000 rpm without breaking apart (unless you go full throttle for too long).

How can I make my electric golf cart go faster without upgrading?

How to Make an Electric Golf Cart Faster Without UpgradesWash Your Cart Properly. ... Inspect the Batteries. ... Refill the Battery Water. ... Check the Gas Pedal and Linkage. ... Measure the Tire Pressure. ... Charge Up Your Battery Unit. ... Lighten Up Your Cart's Weight.

How do I turn off speed governor?

0:102:00Up. So go to program vehicle strategy tune and then it'll ask you to turn the car on press ContinueMoreUp. So go to program vehicle strategy tune and then it'll ask you to turn the car on press Continue turn the car off press Continue remember that's not starting the car just turning it to ignition.

Where is the speed controller on an ezgo golf cart?

Flip the maintenance switch All EZ-GO speed controllers are equipped with a maintenance switch that needs to be flipped before you begin work on repairing the problem. You will likely find the switch under the seat of your golf car,t but if you're having trouble finding it, consult your owner's manual.

How do you change the governor on a golf cart?

If you find this rod, then your governor can be easily adjusted by accessing the cart's inner workings. Simply adjust the cable coming from this metal protrusion, turning the nut counterclockwise to make the cable longer, effectively adjusting the cart's governance to increase the overall speed.

How do I adjust my EZ GO carburetor?

2 Cycle engine: The adjustment screw is on the side of the carburetor and is parallel to the ground. You can identify it by the lock nut at the base of the screw. Loosen this and turn the screw all the way into a soft seat, then back it out one and a half (1-1/2) turns.

Why is my gas golf cart running slow?

Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.

What causes golf cart hesitation?

In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.

How fast is an EZGO golf cart?

The top speed of an EZGO golf cart is usually 19.9mph and the average speed is 14mph to 15mph. With governor adjustment, the EZGO cart can go faster by 5 to 10mph.

What is a golf cart governor?

A golf cart governor is a mechanical device that helps in controlling the maximum speed of the cart when it moves on flat ground. This device prevents the engine RPMs from increasing beyond the recommended specifications.

How to start a golf cart with a gas pedal?

Locate the gas pedal that is fitted to the governor and remove the connection. Re-route the gas pedal to the carburetor. Remove the bolt present on the shaft of the gas pedal. Slide the shaft upwards so that the gas pedal has more play. Tighten the bolt and start the golf cart.

How to change the speed of a golf cart?

Locate the spring on the differential or carburetor that helps in changing the cart speed by adjusting its tension. Increase the length of the cable that is fitted on to the body of the throttle and clutch of the two-stroke engine.

How to ride a golf cart at full speed?

Ride the cart at full speed over a course of known length. This will ensure that the governor controls the speed of the cart within factory specifications. Fasten the black plastic cover and put the seat back in place. Take care when tightening the nut. The more you tighten, the faster your cart will go.

Where is the governor arm on a golf cart?

Locate the governor arm of the golf cart. This is mounted above the rear axle housing and under the cart. Depending on the cart model, there may be a protection plate above the governor.

Can you remove a golf cart governor?

It doesn’t take much time or skill to remove a golf cart governor. With some basic mechanical expertise and general-purpose tools, you can do this yourself. The process is more or less the same in all golf carts.

How to find the governor on a golf cart?

Locate the golf cart’s governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor. Use a screwdriver—or in some cases a wrench—to loosen the tension on the governor’s springs. You have now adjusted the governor for faster speed.

Who is the writer of GolfCarCatalog.com?

GolfCarCatalog.com – “Adjusting Your Golf Cart’s Governor”. Writer Bio. Richard Kalinowski began writing professionally in 2006. He also works as a website programmer and graphic designer for several clients.

Can a golf cart be a nuisance?

In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds. Luckily, you don’t have to stick with these standard speeds. Golf cart speed is often controlled by a device called a governor, and you can adjust the governor on a golf cart relatively easily to make the cart faster.

Can golf carts be adjusted manually?

By Richard Kalinowski. Governors limit the speed of golf carts but can be adjusted manually. In theory, golf carts make it easier for players to get across the course, saving their much-needed energy for the game. In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9