How do you take the governor off a golf cart?
The governor on a golf cart can be adjusted easily by loosening the tension on its springs using a wrench or screwdriver to get the golf cart going at a relatively faster speed. In some cases, the adjustment can be done by turning the cable nut that connects the cable to the throttle lever in the counter-clockwise direction.
How to disconnect the governor on golf carts?
Steps to Adjust Club Car Golf Cart Governor Step 1: Sit on the driver's seat and look for a plastic plate held by two small screws on the console. Check the size and type of the screws. Make sure to use the appropriate screwdriver to remove them from the panel.
How to adjust the governor on a Yamaha golf cart?
Mar 29, 2020 · The first step in adjusting the governor is locating it. Check for a small rod near the golf cart’s clutch. If this rod is found, the governor can be adjusted by simply tightening or loosening the nut attached to the small wire connected to the rod. If a rod is not found, the governor is likely located inside the golf cart’s engine bay on the largest wire running from the …
How to remove Governor on a club car golf cart?
Mar 19, 2009 · Follow throttle cable from black box to governor arm of tranny. You can access this through the black access panel behind the seat. Loosen the nut/bolt that clamps the arm to the shaft coming out of the tranny. Once loose, use a flat blade screwdriver to pry apart slightly. Just till it moves freely on the shaft. DO NOT TIGHTEN.
See more
By mechanically pulling the throttle lever back, you decrease the gas flow to the engine and control the golf cart’s speed. This governor can be adjusted by adjusting the cable nut which holds the cable to the throttle lever.
Where is the governor on a Club Car golf cart?
Does a Club Car golf cart have a governor?
How do you make a Club Car golf cart go faster?
- Add More Torque to Your Golf Cart.
- Upgrade Your Golf Cart's Motor.
- Improve the High-Speed Controller of the Cart.
- Add Better Golf Cart Tires.
- Use a Higher Powered Golf Cart Battery.
- Watch the Weight in Your Golf Cart.
How do you take the governor off a club car?
- Detach the cable from the carburetor. The cable is about the width of a straw. ...
- Follow the disconnected cable up to the governor. ...
- Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ...
- Using your wrench, remove the bolt on the gas pedal shaft.
How do I change the speed on my club car?
How fast can a golf cart go without a governor?
A typical electric cart without an upgraded speed control tops out around 12 mph. If you go this route, anticipate an upgrade cost around $700.
Is 30 mph fast for a golf cart?
How do you take the governor off a club car gas?
Where is the reset button on a Club Car golf cart?
How do you govern a golf cart?
How to find the governor on a golf cart?
Locate the golf cart’s governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor. Use a screwdriver—or in some cases a wrench—to loosen the tension on the governor’s springs. You have now adjusted the governor for faster speed.
Can a golf cart be a nuisance?
In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds. Luckily, you don’t have to stick with these standard speeds. Golf cart speed is often controlled by a device called a governor, and you can adjust the governor on a golf cart relatively easily to make the cart faster.
Who is Richard Kalinowski?
Richard Kalinowski began writing professionally in 2006. He also works as a website programmer and graphic designer for several clients . Kalinowski holds a Master of Fine Arts from Goddard College and a Bachelor of Science in education from the University of Wisconsin-Whitewater.
