Golf-FAQ.com

how to adjust the governor on a yamaha golf cart

by Leslie Hoeger Published 3 years ago Updated 2 years ago
image

Yamaha G29 Governor Adjustment

  • Remove the rear inspection panel from the golf cart. The spring accelerated governor is right below this panel.
  • Use a 10mm wrench and tighten the nut a little by moving it in to expose the threaded rod a little more. ...
  • Take the cart for a test drive to check for the desired speed.

Part of a video titled Yamaha G29 Drive Golf Cart Governor Adjustment - YouTube
0:00
5:15
Itself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.

Full Answer

How do you adjust the governor on a Yamaha G2 golf cart?

Mar 01, 2022 · How To Adjust Governor On Yamaha Golf Cart? In coordination with the vehicle’s acceleration, a spring-loaded device will make up the governor. Make sure that all screws holding the governor in place are turned on by using a screwdriver.

How do you make a Yamaha golf cart go faster?

Mar 31, 2010 · Locate the cable nut that holds the cable to the throttle lever for a clutch cable governor. Adjust the main cable nut, holding it in place with the screwdriver. Turning the nut counter-clockwise will make the cable longer, allowing the cart to go faster. Turning the nut clockwise will reduce the vehicle's top speed.

How do you adjust the governor on a club car G16?

Jun 09, 2014 · Barry, at DIY Golf Cart, shows you how to properly adjust the governor on a Yamaha G29 Drive gas golf cart. Most golf carts are limited in their speed from t...

What are the different types of Yamaha Governor adjustments?

How do you adjust the governor on a Yamaha g2 golf cart? Locate the cable nut that holds the cable to the throttle lever for a clutch cable governor. Adjust the main cable nut, holding it in place with the screwdriver. Turning the nut counter-clockwise will make the cable longer, allowing the cart to go faster.

image

Is there a governor on a Yamaha golf cart?

Different types of Yamaha golf cart models have different types of governors, which regulate the top speed of the golf cart over flat terrain. The three types of governors in Yamaha models include spring adjustment, clutch cable, and spark regulation governors.Mar 31, 2010

How do you turn off the governor on a Yamaha golf cart?

General InstructionsDetach the cable from the carburetor. The cable is about the width of a straw. ... Follow the disconnected cable up to the governor. ... Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ... Using your wrench, remove the bolt on the gas pedal shaft.

How do you make a Yamaha golf cart go faster?

6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.May 18, 2021

How do you adjust the governor on a Yamaha 2021 golf cart?

1:294:32Yamaha Drive 2 Quietech Governor Adjustment - GET MORE SPEEDYouTubeStart of suggested clipEnd of suggested clipLeft from where the bottom of the nut is at so to do that i like to use a ratcheting wrench that youMoreLeft from where the bottom of the nut is at so to do that i like to use a ratcheting wrench that you can just put right on the end of that nut. And then just start tightening.

How fast can a golf cart go without a governor?

Consult with your golf cart manufacturer, but replacing your speed control can increase your speed to 20 mph or more, depending on your upgrade. A typical electric cart without an upgraded speed control tops out around 12 mph.

How does a golf cart governor work?

By mechanically pulling the throttle lever back, you decrease the gas flow to the engine and control the golf cart's speed. This governor can be adjusted by adjusting the cable nut which holds the cable to the throttle lever.Sep 5, 2004

Can you make a Yamaha gas golf cart faster?

The first step is to take the rear inspection panel off. This is where the spring-actuated governor sits. It looks like a needle held in place by a silver handle. By tightening the nut, you expose more of the rod and increase the speed of the cart.Jul 12, 2017

How fast does a Yamaha golf cart go?

19 mphThe top speed of both versions of Yamaha golf carts is 19 mph (31 kph). The fastest electric golf cart that Club Car has on offer is the Villager 2+2 LSV that goes 23 mph. The fastest gasoline Club Car only goes 19 mph. And the fastest electric EZGO is the 2Five that goes 25 mph.Apr 12, 2021

Is 30 mph fast for a golf cart?

Depending on how far you want to go on a full charge, you might want a 40mph or a 30mph golf cart. At top speed, most golf carts do around 14mph. However, with the advent of street legal golf carts and modifications, it is possible to go 35mph and above.Oct 4, 2021

Where is the governor on a Yamaha gas golf cart?

1:003:57How to Adjust Governor on Yamaha G29 Drive Gas Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo on your car you take the rear inspection panel off right underneath it here. You will have aMoreSo on your car you take the rear inspection panel off right underneath it here. You will have a spring actuated governor this is actually what speeds you up and slows you down.

How do you take the governor off a gas golf cart?

0:000:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt looks up look inside. There's 12 cable down right here this lever you want to lift up and BendMoreIt looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.

How do you adjust the speed of a gas golf cart?

Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.

How to Adjust, Remove, Bypass a Golf Cart Governor (STEPS ..

Yamaha G2 Governor Adjustment. The following methods show you how to adjust the governor on your Yamaha G2 golf cart. Method 1. Locate the lever present above the transaxle. This lever houses a 10mm nut. Tighten the nut or move it inwards as much as you want based on the desired speed using a 1/4″ drive ratchet with a 10mm deep socket. More ›

How do i adjust the governer on my yamaha g 16 golf cart

Reply to Jivey's Post: This is not an answer,the only "speed limiter" on a yamaha gas golf cart is the "governer".

How to Adjust & Troubleshoot a Golf Cart Carburetor (STEPS ..

How to Adjust a Golf Cart Carburetor. The way to adjust the carburetor on a golf cart will depend on the model of golf cart. In most cases, you'll need to adjust the jet pilot screw, perform a valve clearance adjustment and then clean the carburetor. More ›

Adjusting Your Golf Cart's Governor

Spring Adjustment: The first common golf cart governor type is mechanical and is common on many makes and models. You'll see some type of spring loaded mechanism in line with the golf cart's accelerator system. Whether it's located at the carburetor or sticking out as a pivot point from the differential, the principle is the same. More ›

How do I adjust Govener - DoItYourself.com Community Forums

Every G16 or later gas Yamaha I've seen can do at least the low 20's just by adjusting the govenor on top of the rear end. Generally if an engine is running well there is nothing to fix, so adjusting the carb. can do more harm than good; as you have found out. More ›

Yamaha Complete Replacement Gas Engine (Models G16 - G20 ..

Yamaha Complete Replacement Gas Engine (Models G16 - G20) Golf Carts Love Us! 1-888-312-7342. Register Login 0. Register Login. Home; Shop by Category. Parts - Club Car. Accelerator Group; Battery Hardware; ... Yamaha > Rebuild Kits > Yamaha Complete Replacement Gas Engine (Models G16 - G20) Receive exclusive weekly deals by joining our email ...

Yamaha G14,G16,G22 Accelerator Cable (Pedal to Governor ..

It is designed for gas G14, G16 and G22 model Yamaha golf carts. There are two accelerator cables used on these models; one stretches from the accelerator pedal to the governor (offered here), and the other connects the governor to the carburetor. This pedal to governor cable measures 67-1/2" long. More ›

What is a golf cart governor?

A golf cart governor is a mechanical device that helps in controlling the maximum speed of the cart when it moves on flat ground. This device prevents the engine RPMs from increasing beyond the recommended specifications.

Where is the governor arm on a golf cart?

Locate the governor arm of the golf cart. This is mounted above the rear axle housing and under the cart. Depending on the cart model, there may be a protection plate above the governor.

How to start a golf cart with a gas pedal?

Locate the gas pedal that is fitted to the governor and remove the connection. Re-route the gas pedal to the carburetor. Remove the bolt present on the shaft of the gas pedal. Slide the shaft upwards so that the gas pedal has more play. Tighten the bolt and start the golf cart.

How fast is an EZGO golf cart?

The top speed of an EZGO golf cart is usually 19.9mph and the average speed is 14mph to 15mph. With governor adjustment, the EZGO cart can go faster by 5 to 10mph.

How to change the speed of a golf cart?

Locate the spring on the differential or carburetor that helps in changing the cart speed by adjusting its tension. Increase the length of the cable that is fitted on to the body of the throttle and clutch of the two-stroke engine.

How to ride a golf cart at full speed?

Ride the cart at full speed over a course of known length. This will ensure that the governor controls the speed of the cart within factory specifications. Fasten the black plastic cover and put the seat back in place. Take care when tightening the nut. The more you tighten, the faster your cart will go.

Can you remove a golf cart governor?

It doesn’t take much time or skill to remove a golf cart governor. With some basic mechanical expertise and general-purpose tools, you can do this yourself. The process is more or less the same in all golf carts.

What are the governors on a Yamaha golf cart?

Different types of Yamaha golf cart models have different types of governors, which regulate the top speed of the golf cart over flat terrain. The three types of governors in Yamaha models include spring adjustment, clutch cable, and spark regulation governors. Each of these models has different procedures for proper ...

How to increase or decrease golf car speed?

Adjusting the tension on the spring will either increase or decrease your golf car's speed depending on which way you turn it. Clutch/Throttle Cable: The second common ground speed governor type is commonly used on 2 cycle golf cart engines. There is an arm located next to the driven clutch (secondary sheave).

What year was the G1 golf cart made?

Club Car was not even producing gas-powered golf carts at this time. The G1 was introduced in 1979 and production on the electric was discontinued in 1986, the gas model ended in 1989. More ›.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9