Method 1.
- 1. Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which ...
- 2. Lift up the seat. Remove the seat cousins, which hide the engine. You may have to unscrew the seat in newer models.
- 3. Remove the screws from the black plastic cover at the rear of the seat. There should be five screws in most models. The engine is in the front of ...
- 4. Follow the thickest cable coming from the gas pedal until your find a small spring wrapped around a metal rod. This is the governor. The spring ...
Full Answer
How to adjust Governor EZGO?
Things You'll Need
- A crescent wrench
- A pair of channel lock's
- A set of torx screwdriver bits
- A screwdriver with interchangeable bits
How do you adjust the governor on a golf cart?
Yamaha G29 Governor Adjustment
- Remove the rear inspection panel from the golf cart. The spring accelerated governor is right below this panel.
- Use a 10mm wrench and tighten the nut a little by moving it in to expose the threaded rod a little more. ...
- Take the cart for a test drive to check for the desired speed.
How to remove drive clutch on EZGO golf cart?
How to remove a secondary clutch on an EZGO golf cart. First of all, make sure that the golf cart is turned off, and the brake is in place. Make sure to put pressure on the gas pedal. Use a clutch puller to remove the drive belt. Loosen the central bolt using an air gun.
How do you change oil in EZGO golf cart?
- The power from the engine transfers to the ring gear through a pinion gear. Again, the ring gear is connected to a spider gear. ...
- The spider gear can rotate at two different angles. ...
- The spider gear also meshes with the two side gears.
- This simple but complex mechanism allows the differential to act conveniently when you are making a turn.
How fast is an EZGO golf cart?
The top speed of an EZGO golf cart is usually 19.9mph and the average speed is 14mph to 15mph. With governor adjustment, the EZGO cart can go faster by 5 to 10mph.
What is a golf cart governor?
A golf cart governor is a mechanical device that helps in controlling the maximum speed of the cart when it moves on flat ground. This device prevents the engine RPMs from increasing beyond the recommended specifications.
How to start a golf cart with a gas pedal?
Locate the gas pedal that is fitted to the governor and remove the connection. Re-route the gas pedal to the carburetor. Remove the bolt present on the shaft of the gas pedal. Slide the shaft upwards so that the gas pedal has more play. Tighten the bolt and start the golf cart.
How to change the speed of a golf cart?
Locate the spring on the differential or carburetor that helps in changing the cart speed by adjusting its tension. Increase the length of the cable that is fitted on to the body of the throttle and clutch of the two-stroke engine.
How to ride a golf cart at full speed?
Ride the cart at full speed over a course of known length. This will ensure that the governor controls the speed of the cart within factory specifications. Fasten the black plastic cover and put the seat back in place. Take care when tightening the nut. The more you tighten, the faster your cart will go.
Where is the governor arm on a golf cart?
Locate the governor arm of the golf cart. This is mounted above the rear axle housing and under the cart. Depending on the cart model, there may be a protection plate above the governor.
Can you remove a golf cart governor?
It doesn’t take much time or skill to remove a golf cart governor. With some basic mechanical expertise and general-purpose tools, you can do this yourself. The process is more or less the same in all golf carts.