
- Pull your golf cart into a garage or other covered area. Use your 2-ton floor jack and lift the rear of your cart until both wheels are in the air.
- Remove the rear wheels from the cart with your socket wrench. Set each wheel aside.
- Remove the brake drums to access the brake pads. The pads will be held in place with one or two clips depending on the model of cart you own.
- Pull off the clips and remove the worn-out pads. Apply anti-squeal grease to the interior of each replacement brake pad. ...
- Reattach the rear wheels and secure the lug nuts. Lower your cart and test the new brake pads in your driveway at a slow speed to ensure they are responsive.
Full Answer
How do you adjust the brakes on a golf cart?
Adjust the brake cable so that it’s not hard but the pedal remains stiff enough. Spin the adjustment wheel by pushing the locking mechanism below the wheel downward using a screwdriver. Why are my Club Car Golf Cart Brakes Sticking?
What kind of brakes do I need for my golf cart?
Your Yamaha, E-Z-GO, or Club Car golf cart was designed with drum brakes, because they can handle any application of your stock golf cart. However, rear only drum brakes don’t provide the most stopping power or responsive speed control.
How do the brakes work on an E-Z-GO golf cart?
The brakes in an E-Z-GO golf cart are automatically adjusted by its mechanical rear drum braking system depending on the wear of the brake shoe. This is done while the golf cart is running.
Why are my Yamaha golf cart brakes locking up?
Why are my Yamaha Golf Cart Brakes Locking Up? If both the wheels are locking, it’s often because there is a binding on the main brake cable that results in the mechanical linkage. This will cause the main cable to get stuck. If your cart has hydraulic brakes, the master cylinder may have gone bad.

How do you change brake shoes on a Yamaha golf cart?
0:3215:26Golf Cart Brake Job [part 1]: Installing New Brake Shoes - YouTubeYouTubeStart of suggested clipEnd of suggested clipOkay next we can remove the rear wheel. And release the parking brake. Now the brake drum shouldMoreOkay next we can remove the rear wheel. And release the parking brake. Now the brake drum should slide right off if they don't you may need to release some preload off the manual adjuster.
How do you fix squeaky brakes on a golf cart?
To fix squeaky brakes on your golf cart, apply anti-squeal grease on the pads and replace the clips. With prolonged use, the brake pads of golf carts usually emit a squeaky noise while applying the brakes. This can be one way of alerting you to replace the brake pads.
What kind of brakes does a golf cart have?
Your stock golf cart from the manufacturer has the mechanical rear drum brake system. The system includes service brake, park brake pedal and release linkage that serves park brake. Also, the self-adjusting wheel brake system has an equalizer link, compensator system, and braking cables.
Do golf carts have brake pads?
Golf cart brakes can be repaired by following these steps. Lift the rear set of wheels using the jack. Use a socket wrench to disengage the wheels and place them aside. Use a pair of needle-nose pliers to take off the cotter pin that holds the hub. Seated under the hub are the brake pads held by clips.
What to spray on brakes to stop squeaking?
Permatex Disc Brake Quiet stops brake squealing by dampening vibration at the caliper/brake pad interface. While providing a tighter fit and allowing for easier disassembly it also protects against corrosion.
Why do my brakes squeak but the pads are good?
As mentioned above, ceramic or metallic pads or moisture can cause pads to squeak. This type of squeaking is usually harmless, says Popular Mechanics. But new brake pads can also squeak because of a foreign object, explains Bockman's Auto Care. Twigs, pinecones or rocks may get stuck between the brake pad and rotor.
How do you check golf cart brakes?
1:543:20How to Inspect Your Golf Cart's Brakes | Golf Cars Unlimited - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you will for your brakes wien visually inspect it and clean the brake drum. And shoe area.MoreIf you will for your brakes wien visually inspect it and clean the brake drum. And shoe area.
How do you clean golf cart brakes?
Keep Them Clean First, lift the axle the brakes are on using a jack. Take off the wheels and brake drums from the studs. Use an aerosol brake parts cleaner to blow any accumulated dust and loose debris off the shoes. Once that's done, damped a clean rag with WD-40 and wipe away anything that didn't blow loose.
How do you adjust disc brakes on a golf cart?
1:533:35How to Adjust Brakes on a Club Car Precedent Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipTurn it counterclockwise. So we'll get the amount of play that we want don't want to over tightenMoreTurn it counterclockwise. So we'll get the amount of play that we want don't want to over tighten this because you'll put a strain the breaks use all the time. And we've got it just like we want.
Do golf cart brakes self adjust?
Many modern golf carts have self-adjustment brakes and do not require manual adjustment, but they do need a little bit of tweaking here and there. However, if you feel the brakes need adjustment, you can do so manually as well.
How do you put a brake light on a golf cart?
0:162:06Brake Light Kit | How to Install Video | Madjax® Golf Cart AccessoriesYouTubeStart of suggested clipEnd of suggested clipUsing the six screws provided in the kit. Attach the brake pads to the brake. Pedal. Now have yourMoreUsing the six screws provided in the kit. Attach the brake pads to the brake. Pedal. Now have your brake pad attached. You want to secure your brake pad harness to the brake pedal.
How do you adjust the brakes on an electric golf cart?
0:195:17How to adjust club car golf cart brakes - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd whenever you those those kind of stays stationary whenever you push on your brakes. DownMoreAnd whenever you those those kind of stays stationary whenever you push on your brakes. Down underneath here that's where the the mechanism is that pushes out on the bottom of those brakes.
How to adjust brakes on a golf cart?
Here are the steps in adjusting the brakes: Turn off the power of the golf cart. Don’t set its parking brake. Put the brick or blocks in front and behind each of the front wheel of the golf cart to prevent it from rolling. Get the floor jack into position at the rear of the golf cart.
Why is it important to adjust the distance of travel on a golf cart?
It is important to adjust this distance of travel to make sure that the brakes are working properly. If there is too much travel distance, the braking capacity or power of the golf cart will be reduced. But if the distance is too short, the brakes may not release fully. So adjustments are necessary in both cases.
How to remove lug nuts on a car?
Use the socket wrench to loosen the lug nuts on the rear wheels. Remove the nuts and the wheels and set them aside. Remove the rubber boots on the underside of the wheels and the brake adjustment screw will be exposed. Pull these rubber boots away from the wheels by using your hands.
Do golf carts have brakes?
As in ordinary vehicles, golf carts have brakes. If you notice that the brakes are not functioning well, they need to be adjusted. Here are some of the ways by which you can adjust the brakes of different types of golf carts. This is also part of the golf cart maintenance checklist that we’ve created. Contents [ show]
Is it safe to drive a golf cart?
Just like any vehicle, safety is very important in driving a golf cart. If not properly handled a golf cart could also cause accidents, although not as serious as the accidents caused by bigger cars and trucks. Nevertheless, you should also know how to safely drive and operate a golf cart. As in ordinary vehicles, golf carts have brakes.
Do old golf carts have low switches?
Some of the old style golf carts may have run/low switches. These switches should be shifted to the tow position before disconnecting their battery packs. Lift the back of the golf cart and put the floor jack in a secure section of the cart which should provide it a stable support.
What happens when a drum brake goes past the power requirement?
Once a drum brake goes past that and slides too much, they glaze over and lose almost all power. The only way to regain that power is if they cool off completely, and sometimes even require being replaced.
How fast can a golf cart go?
Most golf carts are designed to go about 15 miles per hour. It doesn’t take a lot to stop a relatively light vehicle at that speed. It also depends on. A few easy upgrades can have you exceeding 25 miles per hour, though.
Why do you need disc brakes?
Other reasons to consider disc brakes are for trail riding. For the most part, as long as you don’t get into any wicked descents or types of terrains that don’t allow your rear wheels good contact, you should be fine on drums.
Can you get a full hydraulic brake system?
You can get a kit with either a full hydraulic disc brake system, or one with hydraulic front disc brakes and cable actuated rear disc brakes. I would suggest spending the extra money and getting the full hydraulic system. The only real benefit of the cable actuated rear disc brakes is that they’re less expensive.
Can disc brakes warp?
If a disc brake gets hot, it may warp, but it won’t lose power. With cornering in an upgraded golf cart, you will require the ability to slow down swiftly and in a controlled manner to come back to a safe speed for maneuvering. Disc brakes excel at this application, as they are much easier for the driver to regulate.
Do golf carts have disc brakes?
It’s possible that if you bought a golf cart specifically designed for trail usage or racing, you might have disc brakes, but most likely, you’re gonna need to install them yourself if you want them.
Do you need disc brakes on a golf cart?
Disc brakes really only become necessary if you plan to use your golf cart on a more technical trail where your brakes are needed for harsh descents, or if you modify your golf cart to be faster or more powerful than your stock drums can handle. It’s possible that if you bought a golf cart specifically designed for trail usage or racing, ...
How to fix a sticky brake on a golf cart?
You can also fix sticky brakes by following the steps given below. Take off the brake pedal from the golf cart. Drill out the bushings and the pedal assembly using a 3/4-inch drill bit. Drill the frame at the point where the pedal is mounted using a 1/2-inch bit.
Why do you need to replace brakes on a golf cart?
In most cases, you will have to replace the brake cables of your golf cart because they have not been adjusted properly. Another reason why you may have to go in for a replacement is a broken linkage or broken cable ends. If the pads under the drum are in good condition, it’s a sign of the cable beginning to seize up.
Why does my brake line keep dragging?
The locking or dragging could also be due to rusting of the collar, bolt, return spring or bushings of the pivot assembly. Cleaning up the rust may work. Attending to damaged brake cables and linings under the drums also help.
How to adjust brakes on a Yamaha G2?
How to adjust Yamaha G2 Golf Cart Brakes: Remove the brake shoes and check if the adjuster moves backward and forward. Clean the adjuster star wheel well so that it spins without a glitch. Remove the pins that connect the brake cable to the brake arm behind the brake backing plate.
Why do golf cart brakes lock up?
Golf cart brakes can start locking up when the brake cable gets stuck, or when the bolts on the lift kit are loose. The brake cable gets stuck because of a binding, resulting in a mechanical linkage. One or more parts of the pivot assembly have rusted. There’s wear and tear of the brake drum, brake shoe, brake cable or brake spring.
How to adjust brakes on a G29 golf cart?
The brake adjustment of a G29 golf cart can be done in the following ways. Apply mild hand pressure on the brake pedal. This will give a yield of 1 to 1.75 inches on the pedal. If you don’t get this yield, it’s likely that the brake cable has stretched out and needs to be replaced.
Why is my cart locking?
If both the wheels are locking, it’s often because there is a binding on the main brake cable that results in the mechanical linkage. This will cause the main cable to get stuck. If your cart has hydraulic brakes, the master cylinder may have gone bad. You may try loosening the brake cable or the line at the wheels.
