How to Change the Drive Belt on a Club Car Golf Cart
- Switch the engine OFF after parking the golf cart.
- Allow the engine to cool, if it has been running for some time.
- Remove the engine cover.
- You will be able to see the drive belt now.
- Use an open-end wrench to loosen the drive belt tension bolt.
- This bolt is on the front clutch pulley.
- Remove the drive belt by sliding it off the front pulley.
- Slide if off the rear clutch pulley next, to disengage it completely.
- Now, with the new drive belt follow these steps in the reverse; wrap it over the rear pulley first.
- Stretch the belt over the front pulley.
- You will have to pull the front clutch pulley a little forward to create tension on the belt.
- Tighten the tension bolt using a wrench. Now your Club Car golf cart has a new drive belt and you will be able to feel the difference when you drive ...
How to properly drive a golf cart?
- When you go for your backswing, you should shift your weight backward. This will give your swing more power.
- A lot of times your instinct might be to have a fast backswing thinking that it will give you more power to crush the ball. ...
- Stay flat. ...
- Take a steady backswing and pause at the top to reset before begin your downswing. ...
How to change drive belt on EZGO golf cart?
The removal of the drive belt on a Club Car golf cart involves a series of steps as given below:
- Turn the Forward/Reverse handle to Neutral.
- Chock the wheels of the cart.
- Disconnect the battery by removing the negative cable first, followed by the positive.
- Disconnect the spark plug wire from the plug.
- It would be better to wear gloves when you do this.
How to adjust the drive belt?
The Process To Adjust Husqvarna Self-propelled Lawnmower
- Adjusting the drive control. ...
- Step #1: Disconnect Power Cable. ...
- Step #2: Adjust Lawn Mower Speed. ...
- Step #3: Test Lawn Mower Speed. ...
- Step #4: Change The Belt. ...
- Adjusting the cutting height. ...
- Step #1: Adjust The Adjusting Lever. ...
- Step #2: Increase The Deck Height. ...
- Step #3: Reduce The Deck Height. ...
- Adjusting the drive pulley. ...
Does my golf cart need seat belts?
Typical golf carts are designed and manufactured to meet an ANSI (American National Standards Institute) safety standard which limits the maximum speed to 15 mph and does not require (or prohibit) seat belts. It is worth noting however, that this ANSI safety standard was written entirely by a committee of the major golf car manufacturers.
How do you change a belt on a Club Car golf cart?
The drive belt is plainly visible. Loosen the drive belt tension bolt, with the open end wrench, on the front pulley. Slide the old drive belt off the front drive clutch pulley, and then the rear clutch pulley. Slip the new belt around the golf cart's clutch pulley, and then stretch it out over the front pulley.
How do you put a drive belt on a golf cart?
0:445:12Yamaha G2, G9 Drive and Starter Belt Replacement - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd just rolling it right over. It's that simple that was a little twisting a little tugging. ThatMoreAnd just rolling it right over. It's that simple that was a little twisting a little tugging. That will come right on. Now. We do this lift it from around the clutch.
How tight should a golf cart drive belt be?
The reason for a Club Car drive belt being too tight can be because the drive belt is too small for the golf cart. The way to check if the belt is fitted correctly is to push the belt down with one finger at the center between the clutches. It should not deflect more than 1.5inches. It should not be less as well.
Do electric golf carts have a drive belt?
The drive belt is one of the most important belts on your EZGO golf cart. It helps to translate engine power into different gears and makes it possible to shift your cart, giving it the get up and go it needs to run. However, there are times when this belt may be loose or damaged and you may want to tighten it.
How do I know if my golf cart belt is bad?
0:152:00How to Check the Belts in your Gas Golf Cart | Golf Cars UnlimitedYouTubeStart of suggested clipEnd of suggested clipDown below and you don't want to press the moderate pressure on that belt you're gonna want to seeMoreDown below and you don't want to press the moderate pressure on that belt you're gonna want to see about 3/16 to 1/4 inch of deflection. There no more than that that'll be your proper.
How do you measure a golf cart belt?
0:002:04How to measure for a go-kart drive belt. - YouTubeYouTubeStart of suggested clipEnd of suggested clipCover. Now the first measurement we're going to take on this is we're going to measure from theMoreCover. Now the first measurement we're going to take on this is we're going to measure from the centerline of the crankshaft. To the centerline of the jack shaft.
How can I speed up my Club Car golf cart?
0:061:31Club Car Precedent Speed Increase SUPER EASY!!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. AndMoreIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. And if you turn it that way or clockwise it speeds things up. Very.
How do I stop my golf cart belt from squeaking?
Your belt may also be wearing down and even fraying which is a problem that can cause the belt to both squeak and whine as it runs. Replace any frayed belts right away, before they break, to avoid damaging your engine, and lubricate or replace any pulleys which continue to squeak on your cart.
Do golf carts have transmissions?
All golf carts (much like cars) have a clutch, which is the part of the drivetrain that helps the put the power of the motor down through to the wheels/ground. Golf cart clutches are a part of the Continuously Variable Transmission (or CVT).
Do golf carts have belts?
Most carts do not come equipped with golf cart seatbelts, so, if you plan on driving your cart on the street, you'll need to install these to make it street legal.
Why does my golf cart slow down going downhill?
The Reason Your Electric Golf Cart Goes Slow Uphill? Your electric golf cart can struggle on inclines for a variety of reasons. Weak batteries, incorrect tires, and wear and tear to the motor and wiring are all potential causes of your cart's slow speed.
How long do electric golf carts last?
With all other brands-EZ Go, Yamaha, etc... They make them with steel frames and they will rust and eventually break. Longevity ranges between 30-40 years or longer for the various manufacturers.
How Tight Should the Drive Belt be in a Club Car Golf Cart?
The rule of thumb is that the drive belt must neither be too tight nor too loose. If the drive belt in a Club Car golf cart is loose then you won’t get the required speed while driving. If the belt is too tight then your starter will be under strain and this should be avoided.
What is slipping drive belt on 1985 golf cart?
The 1985 Club Car golf cart is no exception to this. The way the clutches are designed for these golf carts is that there is the drive belt connecting the two, the driven and the drive clutches. It has to be of the appropriate size and tension for it to provide a smooth ride.
Why is My Club Car Drive Belt Too Loose?
The drive belt on your Club Car golf cart may be loose if the belt you have fitted is too large for the golf cart . Some belts can overheat with overuse, or even stretch after a few months and become too loose.
How to tell if golf cart starter belt is tight?
The best test to see if a golf cart drive belt has the correct tension is to use the Finger Test. Press the drive belt with one finger at its center between the two clutches. It should sag by just an inch and a half.
Why does my golf cart drive belt slip?
The reason for the drive belt slipping could be that it is of a larger/longer size and therefore loose. You may start feeling the slippage after driving for a while. This is because the belt gets heated up after the golf cart runs for some time and loosens further .
What is the primary function of a golf cart drive belt?
To primary function of a golf cart drive belt is to connect the primary clutch and the secondary clutch. The primary clutch drives the cart and the belt helps it to rotate the secondary clutch (they are referred to as the drive clutch and the driven clutch respectively). The drive belt, unlike some of the other automotive belts, are very thick.
How to tell if golf cart drive belt is damaged?
Make sure that the golf cart’s engine is turned OFF. An inspection can reveal if the drive belt is damaged. Check if it is too tight or loose. In case of a damaged, tight, or loose belt order a new one. Replacing the drive belt is not a very difficult task.
What is the belt on a golf cart?
The drive belt on a golf cart connects the two clutches (the drive clutch and the driven clutch) and distributes the power from the engine to the rear wheels.
How to tell if golf cart drive belt is too tight?
To check if your drive belt is set just right make sure your golf cart is turned off then check the drive belt by pressing it down between the two clutches with your finger. If it deflects less than 1.5” it’s too tight.
Why is my EZGO Drive Belt Too Tight?
The reason your EZGO drive belt is too tight can be because you’re not using the right size drive belt.
Why is my EZGO belt so loose?
The reason your EZGO drive belt is too loose could be because it’s worn out, or you’re simply using the wrong size drive belt. In this case, need to find a replacement immediately.
Why is my clutch too tight?
It can also be too tight because the drive/driven clutch is misplaced or broken. A drive belt that’s too tight can damage the drive and driven clutches and can also result in the drive belt being worn out too fast. To check, whether the drive/driven clutch is misplaced or broken call a certified technician to have a look.
What does it mean when the drive belt is misaligned?
Check and see if the drive belt appears misaligned? If so, is it misaligned more towards the driven clutch (the one on the axle) or the drive clutch (the one on the motor)? If it’s misaligned there is something wrong with the drive clutch.
How to stop a EZYGO drive belt from slipping?
How to stop a EZYGO drive belt slipping: Make sure that you have the right drive belt. Sometimes the wrong drive belt will not be as wide as the clutch you are putting it on. This gives it an unwanted room to move back and forth when you are using the golf cart.
