First, disconnect the negative battery terminal. Next, locate the solenoid on your golf cart. Once you’ve found it, remove the wires from the solenoid terminals that run to the starter.
Videos of How to Change Selenoid On Electric Golf Cartbing.com/videos
On an electric golf cart, if the solenoid is silent – no clicking – use the setting voltmeter to DC volts using the 200 range. First, turn on the ignition while looking for a reading on the smaller terminals. If nothing is appearing, then press on the accelerator.
How do you test the solenoid on an electric golf cart?
Ok, you have determined that you need to replace the solenoid. Many places carry replacements, like Amazon and eBay and run anywhere from $12 to $57 depending on the type. When you look for a replacement online, always have the make, model and year of your golf cart handy.
How much does it cost to replace a solenoid on a golf cart?
Basically it’s your golf cart’s go switch, and it’s absolutely essential to your golf cart’s ability to do its job. Golf cart solenoids are also typically one of the first components to fail in your golf cart, because they work very hard, turning on and off every time you stop and go in your golf cart.
What is a golf cart solenoid and why is it important?
Whether you have a Yamaha, E-Z-GO, or Club Car golf cart, and no matter if it is an electric or gas golf cart, you need a properly operating solenoid to get anywhere. What is a solenoid? What does my solenoid do exactly? Where is my solenoid? What is a solenoid? Good question! A solenoid, for our purposes, is a type of relay.
Do I need a solenoid for my Yamaha golf cart?
Images of How to Change Solenoid on electric Golf Cartbing.com/images
How do I know if my electric golf cart solenoid is bad?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
Will an electric golf cart run with a bad solenoid?
The ability of your golf cart to function properly depends largely on the solenoid. If the solenoid is broken and not working correctly, you may notice your golf cart won't start, picking up speed, or even working at all (issues with acceleration could also be caused by a bad speed controller).
Can you bypass the solenoid on an electric golf cart?
Bypassing Golf Cart Solenoid Method If you do decide to bypass the solenoid, this is what you need to do: Take the two larger wires that connect to the solenoid and connect them directly (keeping all safety precautions in place). This should do the trick and if it does not work then the solenoid is not the problem.
Can a golf cart solenoid click and still be bad?
Usually, you'll be able to hear the solenoid clicking both on and off whenever you switch your ignition. But if you don't hear anything? It's likely that the solenoid can no longer send electricity out to power the golf cart. In some cases, this happens because the coil of the battery is worn out or is too old.
Will a bad solenoid click?
A single “click” sound comes from the engine compartment or from under the car. This could mean that the solenoid is trying to engage but that the internal components are stuck and unable to work properly. Repeated “clicking” sounds usually indicate a dead battery.
How do you check if a solenoid is working?
Do your best to listen for a “click” noise. If the click is strong and loud, it most likely means the solenoid has enough power and is working properly. If the clicking you are hearing is quiet or repetitive, it may be that your solenoid is not strong enough or does not have enough power from the battery.
How do I know if my ezgo golf cart solenoid is bad?
First, turn on the ignition while looking for a reading on the smaller terminals. If nothing is appearing, then press on the accelerator. If the needle doesn't move, then the problem is not with the solenoid. If it jumps and displays full voltage, then the solenoid is the problem and should be replaced with a new one.
Why does my golf cart click but not move?
A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.
How do you test a solenoid on a EZ Go electric golf cart?
This can Also be tested by putting a test lead on each small terminal and pressing the gas pedal. The meter should read 36 V when the gas is pressed. If this voltage does exist when the gas pedal is pressed then the solenoid should click and engage.
How do I test a golf cart solenoid?
Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. But, if there is no such sound, it means that either there is no low side voltage or there is a problem with the solenoid. Use a voltmeter and engage the solenoid.
Can you bypass a solenoid?
5:037:29Solenoid Bypass - YouTubeYouTubeStart of suggested clipEnd of suggested clipAll you have to do to bypass the solenoid. And make the starter turn is basically connect this hardMoreAll you have to do to bypass the solenoid. And make the starter turn is basically connect this hard copper wire to this point on the battery. Then you're not doing anything with the solenoid.
What would cause an electric golf cart not to move?
Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.