Golf-FAQ.com

how to check for bent axle club golf carts

by Aniya Paucek Published 2 years ago Updated 2 years ago
image

Check the axle - if it doesn't look bent, take a tape measure and see if the front edges of the tires is ~1/8" closer together than the rears like it should be. Sorry for my ignorance, but Camber / Caster / Toe always confuses the shit out of me.

Full Answer

How to replace the axle on a golf cart?

Loosen the nut present on the axle at the end. Raise the rear end of the cart and place it on the jack stand. Take off the rear wheel followed by the brake hub. Check where the axle is positioned at the rear end. You’ll also notice the C-clip just before the axle bearing.

Can you remove the rear axle on a club car precedent?

You can remove the rear axle on a Club Car Precedent by carrying out the steps mentioned above. However, it’s worth bearing in mind that there is usually limited space to insert a 90-degree spring clip pliers in the gap between the clip and the rear of the axle flange.

How to put tires on a golf cart?

Now put them on the ground with the tires facing front. Drive the cart forward by approximately five feet with the tires in normal running position. Make sure the difference between the front and rear tires are less than 1/8 th of an inch.

How to remove axle shaft on a club car DS?

You will need a few chocks, a pair of 90-degree internal snap ring pliers, a floor jack and jack stands to remove the axle shaft on a Club Car DS. The steps given below can help you to take off the axle shaft from the golf cart.

image

How do you check for a bent axle?

2:444:36POSSIBLE Way to check for a bent axle/Drive shaft/CV joint axleYouTubeStart of suggested clipEnd of suggested clipIf it's straight they're not gonna move much. But if if the axles bent they're going to do a swingMoreIf it's straight they're not gonna move much. But if if the axles bent they're going to do a swing back and forth motion.

How do you know if your axle tube is bent?

0:321:49checking rear end for bent axle tubes www.hammondmotorsports.comYouTubeStart of suggested clipEnd of suggested clipRed hot with a torch about the size of a quarter and have a garden hose. And clench that tube whileMoreRed hot with a torch about the size of a quarter and have a garden hose. And clench that tube while the torch is still on there and that would shrink the tube to make it. Straight.

How do you know if your rear axle shaft is bent?

Shaft/axle wobble and vibration - When your vehicle has a bent or broken axle shaft, one of the clearest ways you'll notice is how at lower speeds the car might seem to wobble. At higher speeds (over 20 mph), the wobble may turn into what feels more like a general vibration.

How much does it cost to fix a bent axle on a golf cart?

The cost to repair an axle runs between about $500 and $600 dollars before taxes and fees. Costs vary depending the type of vehicle, brand, make, and model.

What does a bent axle sound like?

A Loud Clanking, Clunking, or Clicking If there is an unusual loud clanking or clunking as you put your vehicle into gear, or if a vehicle seems to struggle to get power as it starts to move, there may be axle-joint damage.

What would cause a bent axle?

While they're designed to be very strong and should last for a long time, they can be damaged. This can occur during an auto accident, running over a curb, or even hitting a particularly deep pothole at higher speeds. The result is a bent axle.

How do you know if your axle is damaged?

Here are signs that you have a broken axle.No Tire Rotation. The most common sign of a broken axle is that your tires won't rotate. ... Hard to Accelerate. In some cases, you may still be able to drive on a broken axle, although we do not recommend it. ... Clunking Noises. ... Wobbly Ride. ... Misaligned Brake Pads.

How do I know if my rear axle is bad?

Top Signs Your Car Needs Axle RepairClunking Sounds. If the axle is damaged the vehicle will strain to move. ... Wheel Area Vibrations. Odd vibrations or an uncommon rumbling sensations coming from the area of one tire that occur as you accelerate or while cornering are good signs that there is axle damage. ... Car Won't Move.

Will a bent axle cause vibration?

Uneven or bent axles are another common cause of car vibration. The axles of your car are the long, rotating shafts that attach to your wheels, and drive power from your transmission into them.

What does a broken axle sound like?

If the axle is the issue, the clunking sound you hear indicates your automobile's inability to transfer the power and torque from the engine and transmission to the wheels to get them moving. It might be that the power/torque transfer stops at the broken axle.

Can you drive with a broken axle?

If your axles are failing, you'll still technically be able to drive your car. This is very risky, though, as they could completely fail at any point. When your axle fails, it's possible that you'll lose control of the car, possibly causing an accident or crashing.

How much does a new axle cost?

The average cost for axle shaft replacement is between $159 and $201. Labor costs are estimated between $158 and $199 while parts are priced at $1.

How to remove the rear wheel of a golf cart?

Remove the rear wheel of the golf cart. Take off the brake drum from its place. Insert a 90-degree snap ring pliers through the holes in the hub and remove the snap ring. Slide the axle out of its position. You may require a slide hammer to help you with releasing the bearing from the axle if it’s stuck on to it.

Where is the C clip on a golf cart?

You can also check for a C-clip at the backside of the golf cart that keeps the axle in position. This clip is often inside the axle tube behind the drum mounting flange.

How to remove the shaft on a club car DS?

How to remove the axle shaft on Club Car DS. You will need a few chocks, a pair of 90-degree internal snap ring pliers, a floor jack and jack stands to remove the axle shaft on a Club Car DS. The steps given below can help you to take off the axle shaft from the golf cart. Keep the chocks before the front wheels of the Club Car.

How to remove rear axle snap ring?

You can remove the rear axle snap ring on a Club Car using a pair of 90-degree snap ring pliers and a flashlight. Take off the rear wheel from the Club Car golf cart. Remove the brake drum from its place.

How to tell if rear axle bearing is bad?

The most common giveaway sign of a bad rear axle bearing is a loud noise coming from the axle assembly. You can try one of the following tips to solve the problem.

How to remove rear axle seal on 2002 Club Car DS?

In a 2002 Club Car DS, you can remove the rear axle seal from the axle opening by popping it out using a seal puller. If you want to install a new axle assembly, you’ll have to do the above steps followed by fitting the new assembly in place and redoing these steps once again in the reverse order.

Where is the retainer nut on a 1998 Club Car?

The axle bearing of a 1998 electric Club Car rear axle houses a retainer nut that is located inside the axle tube. This is often a C-clip and keeps the axle in position inside the tube. This C-clip or retainer nut can be accessed only using a pair of 90-degree C-clip pliers.

Why do golf carts need camber?

The camber is the angle of the wheels of a golf cart The camber is extremely important for maintaining the balance of the tyres on a golf cart. Golf cart owners need a good camber adjustment to ensure a smooth jerk-free ride. The golf cart’s wheels get wearied away over time due to regular rides over rough terrain, potholes and other uneven ground, ...

What size arm lift kit for Yamaha golf cart?

One can opt for a 6’ double A arm to avoid such a problem. A rollover or crashing golf cart: A six inch A arm lift kit that suits the Yamaha Drive model can cause reduced control over your golf cart if you don’t adjust the camber of its front wheels properly.

Why is my Yamaha G9 camber bad?

Worn out or incorrect struts are a key cause of camber problems in a Yamaha G9 golf cart. Often, this, combined with excessive positive camber can wear away your tires very easily. The positive camber can be a result of worn out shocks.

How to make a cart out of a car?

Begin by jacking up your car’s front wheels. Move out each of the wheels and make a pattern along the middle, covering the circumference. Now put them on the ground with the tires facing front. Drive the cart forward by approximately five feet with the tires in normal running position.

Why do my wheels have negative camber?

Consider replacing the struts and you will have a fine camber again. Negative camber can also be the result of wide tires or loose king pins. Don’t forget to check out the toe-in of your cart.

How to check camber on G1?

A good option to check the camber on a G1 is to check the toe-in. You can easily do that by watching it roll over a flat surface. If you detect an off toeing in, it will definitely reflect on the camber. You can put in a four stroke axle to take care of the problem. That should help.

How to jack up a car with a heim joint?

Use the parking brakes to jack up your car. Then loosen the lower heim joint by loosening the nut of the lower control arm. You must adjust the nuts to bring them closer to or farther from the frame of the car if the camber is out or in respectively. Lower the car and check the camber. Repeat the steps if needed.

How to replace battery in golf cart?

Since nearly all golf carts are electric, the battery often runs down and when empty the cart will not function at all. Remove the battery by disconnecting the cables to the battery terminals. Wearing gloves, remove the battery and replace it with a fresh one.

Why are my golf cart batteries dead?

Keep your golf cart in good running condition with a little know-how. Golf carts frequently become damaged because of overuse, improper use or a lack of maintenance. The latter often results in dead batteries, which can be fixed rather simply.

How to fix a flat tire?

To fix a flat tire, first attempt to inflate the tire with an electric air pump. Listen for hissing sounds (air being released) and see if the tire remains inflated. If not, jack up the golf cart on a car jack. Remove the lug nuts that secure the tire to the axle and remove the entire wheel rim and tire. Replace the complete wheel rim and tire ...

How to clean a cart battery?

If the cart still does not function with a fresh battery installed (one you are certain is fully charged), remove the battery cables and clean them by brushing with a wire brush. Inspect the battery case for leaks, cracks or damage. If the casing is cracked, a fresh battery needs to be installed.

How to reduce noise in golf cart?

You can reduce the noise in a Club Car considerably by opting for an engine with lower HP, insulating or lining the engine compartment, opting for mufflers or addressing mechanical problems like loose screws.

Why does my gas golf cart make a squealing noise?

The gas golf cart tends to make a squealing noise due to a loose or worn out starter/generator belt, a loose drive and/or alternator belt or a dusty clutch. Loose or worn out starter/generator belt. Loose drive and/or alternator belt. Dusty clutch.

Why does my 2001 Club Car DS make a grinding noise?

The grinding noise in a 2001 Club Car DS is because of worn out brakes, a bad wheel bearing, low transaxle oil level in the rear end or a worn out input shaft bearing.

Why does my club car DS make a clunk?

The front-end clunking noise in a Club Car DS is due to worn out bushings under the spring and spindle, loose nuts on the spindle, a damaged rubber bumper or a cracked front leaf spring plate.

Why does my Club Car DS make a popping noise when turning the steering wheel?

The Club Car DS makes a popping noise when turning the steering wheel due to loose components in the front suspension, a cracked upper clevis, a worn out steering, missing bushings or lack of grease.

Why does my club car make a rattling noise?

The rattling noise in a Club Car DS is often because of a worn out clutch, loose bolts, a rod knock, a loose top light, a dirty guide ring or a windshield problem.

Why does my clutch make a noise?

Clutch making noise (Club Car DS) The clutch in the Club Car DS makes a noise because of a worn out clutch, damaged clutch belt, shaft or buttons or low oil level in the rear end. Worn out clutch. Damaged clutch belt, shaft or buttons. Low oil level in the rear end.

How to fix a golf cart tire?

To fix the issue, you should align the tires. Check the tire’s height, and both tires need to place in the same position. Remove the tires and clean them if there are any particles stuck in them. Check the engine of your golf cart, steerings, and solenoids. Install a new tire if it needs, and then go for a test driving.

How to fix a Yamaha golf cart?

Steps to fix the issue: To fix the Yamaha golf cart G1, you should check the fuel pump and engine oil of the golf cart G1. Check the quality of your engine and replace it if you have used this for a long time. You should also check the batteries to whether it’s working or dead. Replace this if it needs replacement.

Why does my Yamaha G16 shake?

Yamaha G16 golf cart shaking. Yamaha G16 golf cart shaking can occur due to bad solenoids, ignition, solenoid breakdown, and faulty batteries. To fix the issue, you should open your golf cart’s tires and engine to check whether it’s in good condition or not.

Why does my Ezgo RXV shake?

The golf cart Ezgo RXV shaking issues that occur in your golf cart may be due to worn steering parts, loose lug nuts, and loose wheel bearings. This may be due to brake drums and tires. To fix the issue, check the steerings of your golf cart. If it’s worn, then replace it with the worn steering parts.

Why does my golf cart jerk?

The golf cart may cause a jerk because of the solenoid issues. You need to check the voltage reading (normal range or not) of the solenoid. If the range is more or less than the normal range, then replace this.

Why does my Club Car DS shake?

The Club Car DS shakes while accelerating due to various reasons that include low & dead batteries, bad motor controller output regulator, and other issues. It’s usually because of a lousy adaptor and clutches.

Is the Ping G25 adjustable?

Is the Ping G25 driver adjustable? The Ping G25 driver is adjustable. It’s possible to do four adjustments using the hosel adapter of the driver apart from the stated loft setting and...

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9