To check if the starter generator is causing the battery charging issue in your EZ-GO golf cart, all you’ve got to do is short the green wire to ground. Remember, you need to short the wire and not the terminal itself. After doing that, apply a full field current at the battery terminal.
Full Answer
How do I charge my EZ GO golf cart?
Step 1. Buy an EZ Go Golf Cart charger from the manufacturer or your local retailer if you did not acquire one when you purchased your cart. Step 2. Confirm the golf cart battery charger by inserting it into a power source (wall outlet) and then plugging the charger plug into your golf cart's charging receptacle.
How to charge a golf cart battery?
Confirm the golf cart battery charger by inserting it into a power source (wall outlet) and then plugging the charger plug into your golf cart's charging receptacle. Step 3. Observe the LED lights on your charger. They will flash red if your cart's batteries are significantly discharged, and green if the amount of discharge is slight.
Why won’t my EZGO charge?
A 36 V EZGO may not charge due to the reasons given below. The charger receptacle may have worn out connectors or Radsok. You can plug in a good charger and hold the cord end that is plugged in a little high so that good contact is established.
How does an EZ Go Starter work?
E-Z-Go gas cart Starter/Generator and Voltage Regulator When the solenoid is energized through the logic switches (Key Switch and Accelerator Switch), current flows from B+ through the solenoid, to F2 of the Starter/Generator, though the field winding to F1, through the strap, to A2, through the armature to A1 to ground.
How do I test my EZ GO charging system?
0:011:03How to Check the Generator on Your Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you should see the voltage jump up from around 12 volts with the cart running to about 16 voltsMoreAnd you should see the voltage jump up from around 12 volts with the cart running to about 16 volts that that happens that proves the generator is fine you simply need to change.
How do you test a golf cart charging system?
Turn on the Charger – Once you have the voltmeter attached to your battery charger, turn on the charger to read the electrical output. Typically, the needle on the voltmeter will move from left to right – with right being higher – to gauge the amps produced. A reading of about 36 amps is typical for a battery charger.
How do I know if my ezgo golf cart is charging?
The charger's LED lights will flash green when the cart is charging. A full charge following 36 holes will require 10 to 14 hours. The charger will begin charging as soon as it is plugged into the cart.
How do you tell if EZ GO charger is bad?
2:447:01Fix Golf Cart Ezgo Powerwise Charger - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you only need to unscrew one of them and you can actually do a continuity test throughout to seeMoreAnd you only need to unscrew one of them and you can actually do a continuity test throughout to see if the power is going in both directions or not on top of that you also have a fuse here.
What would cause a golf cart not to charge?
If your batteries aren't hooked up correctly, or the connections between them are weak or frayed, this can quickly lead to a loss of power and cause your charger to fail. Make sure you check each battery terminal for corrosion; any buildup will impede the flow of electricity, and could likewise cause problems.
What charges the battery on a gas powered golf cart?
Gas golf cart accessories will also rely on battery power. However, they feature a starter/generator that will charge the battery on its own while the gas pedal is depressed. This doesn't mean a gas golf cart battery is invincible – any accessories left on while the cart isn't running will eventually kill your battery.
Why is my ezgo blinking red?
EZGO RXV Charger Flashing Red You can clean the contacts and tighten the connector to check if the problem goes away. Even a defective charger can cause the red LED to flash. One way to find out low battery voltage is by checking the voltage of each battery.
How do I troubleshoot my EZ Go golf cart?
Things to Keep in Mind Before TroubleshootingEZGO golf cart batteries aren't perfect right away.Sticky accelerators are perfectly normal and can be fixed easily.Keep your cart stable.Make sure your charging wall socket isn't faulty.Keep your tire pressure stable.Troubleshooting the speed controller.
Where is the reset button on an ezgo golf cart?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
Why is my ezgo charger not working?
1:383:23EZGO Charger Troubleshooting | ASK DAVE | Golf Cart Garage - YouTubeYouTubeStart of suggested clipEnd of suggested clipReceptacle cart wiring or battery cables checking and securing these components and connections canMoreReceptacle cart wiring or battery cables checking and securing these components and connections can sometimes help if something has come loose or sustained damage. From age weather corrosion or pests.
How do you troubleshoot a battery charger?
5 Troubleshooting Tips for Your Car Battery ChargerCheck the outlets. There are three ways to determine if the outlets are causing problems to your jump starter. ... See if your battery is in good shape. ... Inspect the charger for signs of damage. ... Check for corrosion or rust. ... Clean your charger.
How do I fix my golf cart charger?
0:476:46Fix Golf Cart Charger Club Car - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo let's take a look first off what you're going to need is a screwdriver of some sort you can seeMoreSo let's take a look first off what you're going to need is a screwdriver of some sort you can see here I'm using a power screwdriver. Obviously power screwdriver is going to be good on the externals.
How many volts does an EZ Go golf cart have?
An EZ-GO golf cart will come either with a 36-volt or a 48-volt battery function. The cart will come with different charging receptacles, depending on the model that you have.
Why is my EZ Go charging?
Most EZ-GO golf carts charging problem tends to happen because of insufficient cart power, loose or damaged wiring, and charger malfunction or damage. An EZ-GO charger should function automatically if everything is okay with your cart. But if you face trouble while charging the battery, there must be something wrong with your golf cart or ...
What does it mean when a cart is insufficient power?
Insufficient cart power means the cart has a dead battery. The charger needs some signal from the cart to detect whether the device needs any voltage or not. When the battery goes dead, it fails to transmit the signal. As a result, the charger does not start charging the battery.
What happens when you plug in a charger?
When you plug in the charger, the charger will automatically decide whether the batteries require additional voltage or not. If the battery does, the charger will start charging the battery. But if something is wrong with the cart or the charger, the charging process may not start.
What does it mean when a charger does not work?
If the charger does not operate automatically, these are the three primary issues that maybe are causing the problems-. Insufficient cart power. Insufficient cart power means problems with the dead batteries.
Why is my charger connector loose?
Securing or checking whether the cart has a loose connection or not can be another way of solving the problem. Bad weather, corrosion, rust, and debris are the most common reasons for developing a loose connection.
How long to charge two 6 volt batteries?
Charge each battery for a maximum time of five to ten minutes and then move to the next one.
How to charge a golf cart?
Step 2. Confirm the golf cart battery charger by inserting it into a power source (wall outlet) and then plugging the charger plug into your golf cart's charging receptacle. Step 3.
What does it mean when your cart lights up red?
They will flash red if your cart's batteries are significantly discharged, and green if the amount of discharge is slight. You should also see a total amperage of approximately 21 amps on the charger. Charge the cart batteries until the charger turns off.
What happens if you don't charge your battery?
If you do not allow the charger to fully charge the batteries, they can become unbalanced and require replacement sooner than normal. Step 5. Conduct an equalization charge monthly in order to eliminate sulfation and stratification.
Why won't my Ezgo golf cart charge?
Some reasons why an EZGO RXV golf cart will not charge could be because of a dirty charging port, loose or broken wire, a blown-out fuse or a problem with the auxiliary contact. Clean the charging port so that it’s free of dust and dirt accumulation. Sometimes, dust and dirt can prevent proper charging.
Why is my Ezgo cart not charging?
It could be due to a lack of battery voltage, a faulty charger or a lack of hydrogen in the batteries. A charger problem can also be associated with the charger making a loud clicking noise, failing to stop charging after the batteries have attained full charge ...
How many volts does an EZGO 2012 hold?
Check the battery pack voltage using a multimeter. For a 48-volt cart, this should be between 46 to 50 volts based on the charge level.
How to check if golf cart battery charger is faulty?
The charger may be faulty. Check this by plugging the charger into the golf cart and see how much it charges the battery pack using a digital voltmeter. Alternatively, you can use another charger to do the charging and see if there is a difference. Allow the charger to charge the pack fully and shut down on its own.
How many volts should a golf cart battery pack have?
Charge two batteries at a time with a 12-volt charger and then use the auto golf cart charger to resume the charging. The battery pack must have at least 28 volts for the cart charger to be able to kick in. Also, ensure that the battery plates have at least 1/4 inch of distilled water above them before charging.
How to check if a voltage regulator is faulty?
To check if the regulator is defective, remove the green wire connecting the generator and the stator at the generator end. Get the engine running, ground the disconnected end and check the voltage rating using a voltmeter.
How long should I charge a 12 volt battery?
You can consider charging them two at a time if you have a 12-volt charger for around 20 minutes. The batteries should never be allowed to discharge below 20%.
How many volts should a starter generator output?
It should peak at about 15 volts (the maximum output of the Starter/Generator’s charge ability). If it does increase, then the Starter/Generator is alright. If it doesn’t, there is a problem with the Starter/Generator.
How many volts should a jumper have before it is shorted?
Before the jumper is shorted to ground, the voltage at B+ should, of course, reflect the charge state of the battery (around 12 volts), but when the jumper is touched to ground (which is what the Voltage Regulator does in instantaneous bursts), the voltage at B+ should rise as the motor’s speed is increased.
Do E-Z-Go Golf Carts have titles?
E-Z-Go Golf Carts, unlike vehicles, do not have a title, but they do have serial numbers. If you are buying a golf cart, it is essential to check the serial number to ensure you do not buy a stolen one. Each E-Z-Go Golf cart has a unique serial number that you can use to identify your golf cart.
Where is the E-Z-Go Cart Serial Number
As mentioned above, all E-Z-Go Golf carts have unique serial numbers. These numbers are essential when buying replacement parts for your golf cart. Textron Specialized Vehicles has been building golf carts for a long time, and the serial numbers are placed on different parts of the golf carts.
How do I push my E-Z-Go Golf Cart?
It can be frustrating when your battery is flat and your golf cart will not roll. To push it to the nearest charging or gas station, you need to release the motor brake. Follow these easy steps to do that.
Why does my E-Z-Go golf cart not move
There are several reasons why your cart refuses to move, but you should check the battery before anything else. If the battery is charged, here are some other reasons why your golf cart will not move.
Are all E-Z-Go Golf carts electric?
No, there are both electric and gas-powered E-Z-Go Golf carts available. Bear in mind that there are several models you can drive on the street, but those are all-electric. These electric models run on batteries that you have to charge at least every 24 hours, depending on how much you use them.
How to tell the Assembly year of my E-Z-Go golf cart
The placement of serial numbers is discussed above, and you will find the manufacturer’s number right next to it. The manufacturer’s number consists of one letter and 3 or 4 numbers. The last two numbers indicate the last two digits of the year of assembly.
How to service E-Z-Go Golf Cart
Like all vehicles, E-Z-Go golf carts require regular maintenance to enhance longevity and performance. You should ensure that your golf cart is serviced after every six months of use. That will ensure that you spot problems and repair them early, which will help reduce repair costs. Here are essential guidelines for E-Z-Go golf cart maintenance.
What is a golf cart starter?
A golf cart starter primarily serves two functions; turning over the engine to start the cart and act as a key link in getting the battery charged. The starter has enough current to crank the engine. The generator converts the alternating current to direct current and recharges the battery.
Why is my golf cart generator not charging?
If your starter generator is not charging properly, it may be that the solenoid, voltage regulator or brushes are faulty. If you’ve ensured that all of these parts are working fine, the starter generator may not be drawing enough current to regenerate the battery.
What to do if your starter generator is not energized?
Check Solenoid. The solenoid is expected to remain energized at all times. If it is not energized at any point in time, the return path for the starter generator to charge the battery via the voltage regulator won’t be completed .
What to check for when starter generator fails?
Wires are the first thing to check for in the case of an starter generator failure. Any loose or damaged wire is enough to prevent the cart from working completely. To ensure the starter generator is charging the battery as intended, check all the terminal connections.
How many volts does a Yamaha G1 generator have?
The only difference is the wiring setup which can be found in the user manual. The ideal voltage output from the starter generator in these carts is around 14-15 volts.
Can a starter generator charge a golf cart?
In most of the cases, a starter-generator that can start the cart will also be able to charge the battery. This is because of the configuration of EZGO Golf carts.
How to open a charger case?
Start with the handle screws and then do the front and back of the case. You can open the charger case by lifting up on the back of it and pulling it forward to release it. Use a voltage meter to check the fuses of the DC cord and make sure there is continuity in the circuit.
Why is my cart not charging?
Because they are electric, one of the more common areas you may encounter problems is with the charging system. When the cart doesn't perform as specified, there are steps you can take to troubleshoot the charger. Plug the charger into a DC power source.