
The marks on the cam shaft point to (left cam shaft 11 oclock the mark on the right point to the 1 oclock position. The chain will have 3 black links-- the top black links will be at the timing marks on the shafts with the 3rd black link directly at 6 oclock facing a mark on the gear.
Full Answer
How do I tell what year my Yamaha golf cart is?
Usually found under the seat, under the driver side glove box area or on the chassis towards the rear of the golf cart. Under the bumper area usually. Once you have located this you can use the chart below to cross-reference those numbers and determine the year and model of your Yamaha Golf Cart.
How do I find the year and model of my Yamaha?
The year and model of your Yamaha golf cart can be found in the first 4 digits of the serial number. This the listing of all of the models and the years they were produced.
How do I troubleshoot the 2008 Yamaha golf cart controller?
You can troubleshoot the 2008 Yamaha golf cart controller using the following steps: Press the accelerator and check whether the voltage increases up to the full voltage of the battery. If it does not increase, then there is a problem with the controller or the batteries. Examine the batteries and check if they are dead.
How do you test a Yamaha golf cart solenoid?
How to Test Yamaha Golf Cart Solenoid First, disconnect the two small wires connecting the solenoid. Take a jumper cable and connect them from the positive and negative posts of the battery pack to the two posts on the solenoid that you just disconnected.

How do you adjust the governor on a Yamaha G2 golf cart?
Yamaha G2 Governor AdjustmentLocate the lever present above the transaxle. This lever houses a 10mm nut.Tighten the nut or move it inwards as much as you want based on the desired speed using a 1/4″ drive ratchet with a 10mm deep socket.
How can I make my Yamaha gas golf cart go faster?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How do you adjust the valves on a Yamaha golf cart?
0:101:38How to Check your Golf Cart's Valve Adjustment | Golf Cars UnlimitedYouTubeStart of suggested clipEnd of suggested clipNext thing we're gonna do is remove the valve cover. There are four six millimeter bolts that holdMoreNext thing we're gonna do is remove the valve cover. There are four six millimeter bolts that hold it on ten millimeter socket or remove. Them. And we're gonna remove the valve covers.
How can you tell how old a Yamaha golf cart is?
If you are trying to determine the year of your Yamaha golf cart, you will first need to find the golf cart's identification plate or sticker or have the vehicle's serial number and date code. Usually found under the seat, under the driver side glove box area or on the chassis towards the rear of the golf cart.
How fast can a Yamaha Drive 2 Go?
Although, new gasoline and electric golf cart versions of Yamaha all have the same top speed. The top speed of both versions of Yamaha golf carts is 19 mph (31 kph). The fastest electric golf cart that Club Car has on offer is the Villager 2+2 LSV that goes 23 mph.
Why is my gas golf cart running slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
How do you adjust the carburetor on a Yamaha g16 golf cart?
How to Adjust Yamaha Golf Cart CarburetorPull out the pilot adjustment screw. ... Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
How do you remove a Yamaha golf cart engine?
2:108:33Yamaha G5 Golf Cart, engine and transaxle removal, only 4 boltsYouTubeStart of suggested clipEnd of suggested clipThere's a bolt through the front here uh you take the belt. Off the um cables. Right with all thisMoreThere's a bolt through the front here uh you take the belt. Off the um cables. Right with all this stuff. And uh the rear end pops right out piece of cake. Um to get the engine. Off.
Where is the spark plug located on a Yamaha golf cart?
0:374:08Yamaha Spark Plug NGK BP4ES Install | G16 | G29 Drive Golf CartYouTubeStart of suggested clipEnd of suggested clipMy 13/16 socket got a golf car so let's go ahead and get started as with most Yamahas the spark plugMoreMy 13/16 socket got a golf car so let's go ahead and get started as with most Yamahas the spark plug is actually sitting right here on the front portion of the engine.
What year is a G2 Yamaha golf cart?
Yamaha Electric & Yamaha Gas Golf Cart Serial Numbers:Yamaha G1 to G11Yamaha's Longest Running Cart Model. The G-Series.JA2-000001G2 GAS1988J55-000101G2 GAS1989J55-100120G2 GAS199084 more rows
How do I know what engine is in my Yamaha golf cart?
It is likely located:Under the rear bumper on the frame; or.Under the seat where the floor board meets the motor compartment; or.Under driver side glove box.
What kind of Yamaha golf cart do I have?
The Yamaha G9 serial number location is underneath the seat towards the front of the golf cart. The Yamaha G11 Serial Number location is underneath the seat towards the rear of the golf cart. The Yamaha G14 & G16 serial numbers are located underneath the drivers side seat towards the front of the golf cart.
Yamaha Golf Cart won't start
did you leave the key on and kill the battery or a light or something double ck that battery , they will still light up the ignition and lights and ll but does not have enough to crank the starter , that is what is sounds like to me be put a jump on it or charge it and try again , when you turn on the ignition does the lights light up on the dash panal if so the batter is low.
Oil and fuel blowing out through top of motor in yamaha golf cart 4 stroke engine
Engine got to much oil in it? Worn engine allowing fuel down into engine diluting the oil and raising the oil level? Blocked engine breather, pressurising the crankcase. Oil change and clean the breather. Worth a try
How do i set the timing on a yz450
Set the piston to TDC (top dead center) this is the higest point the piston will rise before moving on to the down stroke, either by lining up the marks on the crank rotor or a long screw driver (large handle so it wont fall in) down the plug hole and watch for the highest point lock or hold at this point.
Yamaha 4 stroke golf cart back fires all the time..Replaced coils and the carby but no change
Very important... valves get out of adjustment and are easy to set. This is where I would start FOR SURE. Check out www.buggiesgonewild.com and an example of how to do it on EZ GO 295 http://www.buggiesgonewild.com/ezgo-gas-tech/1196-ezgo-295-350-engine-valve-adjustment.html
Vw golf 1.4 16v after changeing timing belt car idles eratticaly or not at all. Timing marks correct at crankshaft, cam pulleys locked as per haynes manual!
The timing could be 180 degrees out you will have to do it all over again. Bring #1 cylinder upto TDC check the distributor rotor arm that it is pointing to #1 plug wire, It is important that the cams are on the intake stroke and not on the exhaust stroke. The crank is no big deal just make sure the marks are lined up.
Will not start up I have no compression but i have fire and fule. It is a Yamaha 2 stroke engine in a yamaha golf cart . Just wondering if it has a compression release on it that i'm not seeing. Garry
I find with two stroke engines the carb gets all gummed up if you store it for the winter. A good carb cleaning usually does the trick
Geting the timing right for my 85 xj 700
86 nissan 4×4 3.0. V6 distributor set with number 1 tdc but timing marks on pulley are about 180 degrees off engine starts and runs
How many times can a Yamaha engine be rebuilt?
Yamaha engines are durable and because of the simple design, they can be successfully rebuilt 3 or 4 times . Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard.
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
Why is my Yamaha golf cart controller so hot?
The primary reason why a Yamaha golf cart controller gets too hot is because of overuse. When the golf cart is used for long periods of time, the controller can start overheating. The driving surface might also be a cause of heating. If driving on a straight and soft surface, the problem of heating should not occur.
How to test Yamaha G16?
To test the Yamaha g16’s speed controller, check the voltage reading while pressing the accelerator. Test other components such as the batteries, the charger, and the solenoid for their smooth functioning. If any of these components do not work as expected, then you need to replace them.
What to do if your golf cart controller does not increase?
If it does not increase, then there is a problem with the controller or the batteries. Examine the batteries and check if they are dead. If dead, replace them. Examine the controller, as discussed in the previous sections. Remember to always consult a mechanic to have your golf cart controller repaired.
What are the problems with a Yamaha G22?
Yamaha G22 also faces similar problems like G9 and G16. Overheating, battery faults, wiring issues, voltage issues are some problems that might occur with your Yamaha G22. To avoid these problems, test the golf cart’s major components connected to the controller regularly.
Why is it important to troubleshoot a golf cart controller?
Troubleshooting the controller is extremely important for the golf cart’s smooth functioning. Generally, controllers face major issues only when there is a problem with wires or defects on the controller itself, such as marks or cracks.
How to troubleshoot a G9 controller?
Here are some easy steps for troubleshooting the G9 controller: Check the controller’s body to locate any major defects such as cracks, scratches, or black marks. If these are found, then replace the controller immediately. If no major defects are found, then check the wiring.
Why is my golf cart not heating?
If driving on a straight and soft surface, the problem of heating should not occur. But, if driven on uneven or steep surfaces , there are chances of heating. Another reason could be the brakes. It is essential to check if the brakes are dragging while the golf cart controller is driven.
Where is the serial number on a golf cart?
The serial number this model golf cart is usually located on the front of the vehicle stamped into a tin tag and riveted to the frame, underneath the cart on the main cross member of the forward frame.
Where is the serial number on a Yamaha G3 Sun Classic?
The serial number for the Yamaha G3 Sun Classic model golf cart is usually located just under the rear bumper on the passenger’s side. It is stamped onto a tin tag which is riveted to the frame. It should begin with either a “J46” prefix for electric models and a “J42” prefix for gas models. See below. Gas Yamaha G3A.
What was the main competitor of the 1979 Yamaha Golf Cart?
In 1979, Yamaha’s main competition was E-Z-Go and Harley Davidson (AMF). The body style changes over the years for the Yamaha golf cart models are a little more subtle than those of the E-Z-Go and Club Car, and because of these minor changes, many are wondering what model they DO have.
When did the G1 golf cart come out?
Yamaha Model G1 1979 – 1989. Yamaha entered the golf cart scene with the model G1, which sported a 2-cycle gas engine. Club Car was not even producing gas-powered golf carts at this time. The G1 was introduced in 1979 and production on the electric was discontinued in 1986, the gas model ended in 1989.
Where is the serial number on a Yamaha G19?
The Yamaha G19 serial number is typically located inside the driver’s side glove compartment or under the rear bumper attached to the frame . The Yamaha G22 or G-MAX began production in 2003 and the serial number is located inside the driver’s side glove compartment.
What is a G1 engine?
Model G1. The G1 is powered by 1. A 2 cycle gas engine with an oil injection system or 2. By a 36-volt electric motor & six 6V batteries. The G1 underwent several alterations over 10 years of production. The different models (and year of manufacture) are identified by the serial number and its prefix.
Does the Yamaha G1 have a factory top?
The Yamaha G1 golf car has never had a standard ‘factory’ top assembly. There were several aftermarket manufacturers that provided the top section so, in order to get a wrap-around rain curtain to fit your G1, it’s pretty important to get the manufacturer’s name that produced YOUR cart top.
Where to find the year of a Yamaha golf cart?
Usually found under the seat, under the driver side glove box area or on the chassis towards the rear of the golf cart. Under the bumper area usually.
Where to find serial number on G1 golf cart?
You can find the serial number under the golf cart towards the drivers side rear wheel.
Where is the serial number on a G3?
The G3 was short lived and soon to be replaced by the G5. You can find the serial number on the G3 under the cart towards the rear passenger side tire.
Why is my Yamaha golf cart not moving?
The main cause of a Yamaha golf cart clicking but not moving, is a faulty controller or solenoid. The battery has to be checked first to see if it’s delivering the right voltage while in the idle state as well as when the pedal is pressed. There can be other reasons for the Yamaha golf cart not moving though you hear the click.
How to check solenoid on G9 Yamaha?
The solenoid can be checked using an old screwdriver to jump the terminals. Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced. You must be careful while doing this crude test; there could be sparks when the two terminals touch.
What to do if your G9 golf cart is not clicking?
If you find your G9 Yamaha golf cart not starting nor clicking, check the key components for damage. If you find the parts to in good condition, check the brushes in the starter/generator.
What are the settings on the M3?
The variable settings on the M3 allow a player to adjust the loft, lie, and face angles of the club, as well as create a variable fade or draw bias. Which can correct many swing or hit issues...
