Golf-FAQ.com

how to clean contacts on golf cart accelerator pedal

by Jacquelyn Jacobs MD Published 3 years ago Updated 2 years ago

How do you test a golf cart solenoid?

BEFORE testing the golf cart solenoid, test both the accelerator micro switch and the key switch. These components are both wired into the control circuit of the solenoid and if they are faulty, the solenoid will not operate.

What happens when the solenoid on a golf cart wears out?

The solenoid wears out every time the gas pedal is pressed down. The solenoid gets pressed down to a thin plate. After repeated use of the cart and pressing down of the gas pedal, the pressure creates small electric arcs on the thin plate. This restricts the current from flowing.

Why EZGO TXT/RXV golf cart hesitates when accelerating?

Why EZGO TXT/RXV golf cart hesitates when accelerating 1 Routine inspection can prevent stalling. 2 Replace the contact plate near the solenoid. 3 The more you use the cart, the more you should replace it to prevent it from stalling. 4 The speed controller gets damaged either due to overuse or lack of use. ... More items...

Why does my golf cart Jerk when accelerating?

The main reason why a Club car golf cart jerks when you accelerate it is due to a misaligned Inductive Throttle Sensor or dirty clutch. Causes of jerky Electric golf carts: 1] Water-logging in some of the components of your electric golf cart can result in jerking.

Why does my golf cart jerk when I accelerate?

Why does my Club car golf cart jerk when accelerating? The main reason why a Club car golf cart jerks when you accelerate it is due to a misaligned Inductive Throttle Sensor or dirty clutch.

Why does my gas golf cart hesitation?

The main reason why an EZGO Gas golf cart hesitates while accelerating, is because of a dirty carburetor. A dirty carburetor causes this hesitation. Regular cleaning can prevent this problem. Check the rubber boot and clean if you spot any dirt.

How do you fix a golf cart accelerator?

Open up your cart hood and find the wires connected to your controller. Check to make sure each of these wires is properly screwed down and held in place. Inspect all other wires throughout your engine and accelerators. Tighten the connections on these wires to ensure that they run smoothly.

Why is my golf cart not going forward?

The problem could be with either the Run/Tow switch or Forward/Reverse switch or both. Check the switches to ensure that they aren't stuck midway. If they are, getting them released should help. However, if they show signs of wear and tear, you must get them replaced.

How do you fix hesitation when accelerating?

0:589:09How To Fix Engine Hesitation During Acceleration - Easy Fix! - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst pertains to air intake. Systems number one is a dirty air filter causing. Air it takeMoreFirst pertains to air intake. Systems number one is a dirty air filter causing. Air it take restriction which can cause a rich air fuel mixture engine misfire and a check engine light.

What can cause hesitation when accelerating?

Why Does My Car Hesitate When I Accelerate? 7 Common CausesWorn-out spark plugs.A faulty ignition coil.Damaged or worn spark plug wires.An issue with the distributor.A bad ignition control module.

What does an MCOR do?

Club Cars use an MCOR throttle device. This translates your foot movement at the pedal into electric impulse that the motor controller reads. MCOR stands for "Motor Controller Output Regulator".

Why does my golf cart click but not move?

A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.

Why does my electric golf cart go slow uphill?

The Reason Your Electric Golf Cart Goes Slow Uphill? Your electric golf cart can struggle on inclines for a variety of reasons. Weak batteries, incorrect tires, and wear and tear to the motor and wiring are all potential causes of your cart's slow speed.

Why does my EZGO gas golf cart not move?

First of all, you need to check your air filter to make sure that it isn't clogged with dirt or other debris. If your air filter is too dirty, it will refuse to run your cart and may cause problems. In many cases, your engine will run awkwardly or poorly and may struggle to operate at all.

Where is the reset button on golf cart motor?

First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!

What makes golf carts go forward?

The next most common problem you're likely to experience with your golf cart is a malfunctioning controller. Controllers for direction come in two varieties – forward and reverse. As a result, a cart that will go forward but not reverse may have a broken controller for the reverse that needs to be fixed or repaired.

How to check for leaks in golf cart?

You can check for any leaks by following these steps: Crank up the golf cart and check every seal for leakage. You can also spray wd40 at the clutch to find leaks. When the cart becomes hot, the voltage also drops. So, make sure you provide enough voltage to the batteries so the cart can run.

What happens when you press down the gas pedal on a gas cart?

The solenoid gets pressed down to a thin plate. After repeated use of the cart and pressing down of the gas pedal, the pressure creates small electric arcs on the thin plate. This restricts the current from flowing.

Why does my EZGO golf cart hesitate?

The main reason why an EZGO Gas golf cart hesitates while accelerating, is because of a dirty carburetor. A dirty carburetor causes this hesitation. Regular cleaning can prevent this problem. Check the rubber boot and clean if you spot any dirt. In case it has worn out too much, you can replace the carburetor.

Why is my EZGO RXV hesitation?

In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.

Why does my golf cart stall?

The most common reason why your golf cart is stalling is due to a bad solenoid or a faulty speed controller. Batteries have lost charge. Faulty ignition. Problem with the direction switch. Faulty speed controller. Bad solenoid. The solenoid wears out every time the gas pedal is pressed down. The solenoid gets pressed down to a thin plate.

Why does my cart stutter?

If you change the battery, change the charger as well; otherwise, the battery will keep running down. If your cart seems to run fine for a few feet, and then it stutters, it is most likely the batteries. If it is not the battery, then check if it is the speed controller or the resistor.

Why does my golf cart spin out?

The brake bub will spin out when there is too much load to prevent any damage to the rear axles, causing the golf cart to stall on hills. Remove the covers from the rear wheel. Notice the castle nuts that are holding the hub to the axles. Apply the brakes.

How to protect a golf cart battery?

Golf cart batteries are highly corrosive, so avoid spills at all times. Wear protective gloves when testing or cleaning your battery. It is also recommended to wear protective glasses when you are handling the battery, so corrosive liquid does not splash into your eyes.

How does a potentiometer work on a golf cart?

When it is working properly, the potentiometer allows your golf cart to accelerate smoothly. Find your potentiometer and inspect it for any cracks, broken parts, or disconnected wires.

How many ohms does a golf cart potentiometer have?

Most golf cart potentiometers are 5K – 0 ohms, which means the potentiometer relays 5,000 ohms when you floor the accelerator. Some older models use volts instead, so double check the resistance type before you try to test the output. There are two terminals on a potentiometer.

What happens if your solenoid is not working?

If your solenoid is working and the cart still isn’t going, there is one last part to check before you reset the entire motor. You may have never come across the potentiometer before, but it is an important part to keep your golf cart going. It sends an electrical signal to the speed controller from the accelerator pedal, indicating the pedal’s position.

What to do if your solenoid is high?

If you don’t hear a click when the cart is on and you’re pressing the accelerator, switch your multimeter to volts and place a contact on each of the small solenoid terminals. These small terminals connect to the batteries.

How does a solenoid work?

The solenoid allows electricity to flow from your batteries to the electric motor. It usually makes a clicking noise when you turn the key to the “on” position. It is engaged each time you turn on the cart and every time you step on the accelerator or the brake, so it is a part that can wear out quickly. If you’re unsure if it is working, it is simple to test.

What to do if your electric cart won't run?

Once you’ve pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run. If you’ve reset the motor and the cart will still not run, there are a few things that could be wrong with your electric motor.

What tools do you need to dismantle a golf cart battery?

This battery consists of various cables and wires, which are crucial for the working of your vehicle. Cutters, crimpers, nails, and a screwdriver are all essential tools you should carry in case you want to dismantle or recharge your golf cart’s battery.

Why does my electric golf cart jerk?

1] Water-logging in some of the components of your electric golf cart can result in jerking. Sensors and micro switches installed near the vehicle’s floor mat can malfunction due to water interference, which causes jerks when you accelerate.

How much does a DS golf cart weigh?

The DS produces both battery and gas-powered golf carts. The electric DS weighs 498 pounds, whereas the Gas DS weighs 619 pounds. The speed ranges between 12-15 miles/hour for the gas model, whereas 12-19 miles/hour for the electric one. Jerks can occur in the DS Car for the following reasons.

Why is it important to maintain a golf cart?

Hygiene and maintenance of your golf cart are not only important for your comfort but also the regular functioning of your golf cart. The clutch is the component of your golf cart used very frequently and can be easily soiled with dirt and dust particles.

How fast is a club car?

Club Car’s gasoline-powered Tempo golf cart is one of the most highly coveted golf carts by golfers worldwide. Its speed ranges from12-15 miles/hour. The Tempo golf cart comes with a 5-year warranty and a dynamic engine of 3.3 horsepower.

How much does a club car precedent weigh?

It costs around 11,500 USD and has a minimum horsepower of 3.7 (2.7 kW). The Precedent weighs 1176 lbs, and its speed ranges from 8-14.8 miles/hour.

Why does my DS car jerk?

Battery damage: – Jerks can occur while accelerating in a DS model if the cart’s battery and other electrical components have been damaged . Repairing or replacing these components can lessen or nullify the problem of jerking.

How to test golf cart solenoid?

A diode allows current to run in one direction, but not in the other. Testing the diode is a simple procedure. Remove the diode from the circuit and check the leads with a continuity tester.

Why doesn't my golf cart solenoid click?

This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid.

What to do if your solenoid is not zero?

If the reading is not zero, then the solenoid is stuck and needs to be replaced. If the ohmmeter does read zero, set the cart to forward travel and turn the key switch on. Press the accelerator pedal (or have a friend do it) and you should hear a click. If you don’t hear a click, measure the resistance anyway.

How to tell if solenoid is bad on golf cart?

The common symptom of a bad solenoid is no clicks when the cart’s ignition is on and you press the accelerator.

How to tell if a golf cart won't start?

The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. Now, on to the next symptoms…. The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting.

Where are the solenoids on a golf cart?

In all golf carts, new and old, the solenoids can be found under the seat or in the engine well and are easily identifiable by the wires that lead to them. Banks of heavy duty solenoids, as in the previous illustration, are mounted on the side or back panel near the electric motor.

How to check if a battery is low?

First, follow these steps: Step 1 – Check the battery voltage from the positive connection to the battery negative. A solenoid uses 12-18volts and low voltage will not activate the solenoid. Step 2 – If the voltage is low, check the cable ends for corrosion. Clean and charge the battery.

Check The Batteries

Inspect The Charger and Test The Wall Socket

Listen For The Solenoid

Examine The Potentiometer

Reset The Motor

  • Just like many other electronics, an electric golf cart motor sometimes just needs to be restarted to clear the cobwebs. If you’ve checked and double-checked all of the parts mentioned above, and the cart still isn’t moving, you’ll want to reset the motor. t’s simple to do – just a press of a button. The reset button acts as a mini circuit breaker ...
See more on golfcartking.com

Precautions

Conclusion

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9