On your starter generator, there is a terminal marked F2 and one marked A1. When this issue occurs, use the voltmeter – connect the positive lead to the F2 terminal and the negative to the A1 terminal. Key on and in forward gear, press the accelerator pedal and confirm you are getting the full 12 volts to the starter generator.
Full Answer
How does a starter generator work on a golf cart?
The starter generator is an electric motor that runs on the voltage drawn from the cart’s battery. After igniting and cranking the engine, when the starter generator is spinning at over 1200rpm, it starts converting the AC it produces to DC to regenerate the battery.
How do I test the starter generator on my cart?
12) Jack up the back of your cart, leave the body up, put in and turn the key then press the gas pedal as a final test. Bad brushes should be changed to ensure your starter generator works properly.
How do two terminal starter generators work?
Two terminal starter generators only work in one direction and the direction depends on how it’s wired internally. The starter generator can be rewired to make it spin in another direction.
What causes a starter to malfunction on a golf cart?
Bad brushes tend to cause your starter to malfunction first, then as it gets worse, it affects your generator. To replace the brushes of your golf cart starter generator, you must:
How do you wire up a starter generator?
1:012:59How to: wire a Sears starter generator - YouTubeYouTubeStart of suggested clipEnd of suggested clipBottom one of those on the bottom of the regulator. This one goes on to the bottom of the regulator.MoreBottom one of those on the bottom of the regulator. This one goes on to the bottom of the regulator. And comes here and slides. Right on to the a pole. The a pole which is one closest to the engine.
How does a starter generator work on a golf cart?
The starter generator works in two ways; the starter portion cranks the engine and the generator portion recharges the battery. When the gas pedal is depressed the starter cranks the engine over. When it begins to run on its own, the generator portion of the unit begins to charge the 12-volt battery.
How do you test a golf cart starter generator?
0:011:03How to Check the Generator on Your Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you should see the voltage jump up from around 12 volts with the cart running to about 16 voltsMoreAnd you should see the voltage jump up from around 12 volts with the cart running to about 16 volts that that happens that proves the generator is fine you simply need to change.
How do you polarize a starter generator on a golf cart?
0:391:10How to Polarize at the Generator - YouTubeYouTubeStart of suggested clipEnd of suggested clipTake your live jumper lead and touch it touch touch. You're going to get a small spark. When that'sMoreTake your live jumper lead and touch it touch touch. You're going to get a small spark. When that's happened that's the end of it lay. Your field wire back on where she belongs. And the job is done.
How does a generator starter motor work?
After voltage gets sent to the starter, the component acts as a small motor. The starter turns, tripping or turning the engine. Voltage is simultaneously being sent to the spark plugs, which ignites the fuel inside the engine cylinder or turbine.
How does starter alternator work?
The starter uses the complete opposite energy of the alternator. It uses the electrical energy of the car and turns it into mechanical energy. This energy comes from the battery and is used to start the crankshaft turn, which gets your car moving.
How do I know if my starter generator is charging?
0:000:42Zip Tip Starter Generator Testing - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd while it's spinning down come over to your. Field. If it stops like that and acts like anMoreAnd while it's spinning down come over to your. Field. If it stops like that and acts like an electric brake. You have a good starter dinner zip tip out.
How does a belt starter generator work?
Belt Driven Starter Generator The main difference with a standard belt drive system is the reinforcement of the belt tensioning, the BSG acts bidirectional on the belt to speed up the combustion engine during start-up. For small engines a conventional starter is not needed while it is required for larger ones.
How do I test my starter generator not charging?
To check if the starter generator is causing the battery charging issue in your EZ-GO golf cart, all you've got to do is short the green wire to ground. Remember, you need to short the wire and not the terminal itself. After doing that, apply a full field current at the battery terminal.
What happens if you don't polarize a generator?
A regulator always runs off positive current. As a result, if the generator is not polarized to a positive charge and positive current is sent into the terminals, the generator can be damaged as well as the other motors and switches on the same current.
Which is the a terminal on a generator?
On an AC alternator, the generator terminals are the connection point between the main stator windings and the load. Often a plastic terminal board formed with threaded studs embedded into it, cables come from the main stator and are attached to the terminals with spring washers, flat washers and nuts.
What is the L terminal for on a voltage regulator?
As shown in Figure 3, the regulator has an extra terminal marked "L" which is connected with the lower contact point in the cutout relay. This extra ter- minal permits current from the generator to be diverted to the load without its passing through the current-voltage regulator.
How does Golf Cart Starter Generator Work?
In this article, we will describe the full process of a starter-generator works. Anyone can be helpful by reading this article. We show here some important steps with troubleshooting a golf cart starter generator. And also find a way to resolve these kinds of issues.
What is a golf cart starter generator?
For every golf cart, there should be a starter generator. It is known as a very special device that helps for turning the engine and also charges the battery of the golf cart simultaneously. Usually, it works in two ways.
How does golf cart starter generator work?
Generally, every electric golf cart and gasoline golf cart has a starter generator. It starts to work when the gas pedal decreased its workability, then the engine of the golf cart needs to crank. This job is done by the starter. The starter cranks the golf cart engine properly while the battery is getting charged up by the generator.
What is battery regeneration?
The battery regeneration part involves the starter generator brushes, Solenoid and Voltage Regulator. The solenoid has to remain energized at all times to ensure that the return path via voltage regulator to the battery remains open. This return path is the route through which the current is returned to the battery to recharge it while the cart is running.
Why is my EZGO golf cart not charging?
This is because of the configuration of EZGO Golf carts. Almost all of the EZGO models have a setup that is foolproof to any generator failure. If the battery is not charging, it is usually the wiring or the voltage regulator. The possibility of having an starter generator that doesn’t charge the battery is very low.
What is a golf cart starter?
A golf cart starter primarily serves two functions; turning over the engine to start the cart and act as a key link in getting the battery charged. The starter has enough current to crank the engine. The generator converts the alternating current to direct current and recharges the battery.
Why is my golf cart generator not charging?
If your starter generator is not charging properly, it may be that the solenoid, voltage regulator or brushes are faulty. If you’ve ensured that all of these parts are working fine, the starter generator may not be drawing enough current to regenerate the battery.
How many volts does a starter generator have?
If the starter generator is showing 15 to 16 volts during the full field test, replace the voltage regulator.
What is a starter generator?
The starter generator is an electric motor that runs on the voltage drawn from the cart’s battery. After igniting and cranking the engine, when the starter generator is spinning at over 1200rpm, it starts converting the AC it produces to DC to regenerate the battery.
What happens when a green wire is shorted?
When the green wire gets shorted on its own, the field current starts flowing directly to the starter generator circuit, therefore recharging the battery.
How does a pedal box work?
Basically, when you press down on the pedal, a metal rod is inserted into the sensor coil in the pedal box, changing the inductance of the coil, which reduces the voltage signal sent through it . This varying voltage signal tells the controller how much current the driver wants passed to the motor.
What voltage is a DCS?
DCS: Pin-1 (white wire) 0.4V to 0.6V pedal up and 1.50V to 1.75V pedal down.
What is the use of meter neg. probe on the B terminal?
With meter neg. probe on the B- terminal, use the positive lead to probe the white wire in the controller main molex connector.
What terminals are used for golf cart motors?
Working on a golf cart motor. Terminals are A1, A2, F1 and F2. I have continuity between A1 and A2 and between F1 and
What is the F&R on a Sepex cart?
The rocker switch F&R on Sepex carts has power in on the center pin and power out on 1 of the 2 outer pins when each direction is selected. A simple voltage check will verify operation.
Is JustAnswer responsible for posts?
Disclaimer: Information in questions answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
Where to connect probe to solenoid?
Connect (+) probe to the battery side of the solenoid's large stud.
How to test a starter generator?
In order to test the function of the Starter/Generator and the Voltage Regulator, the wire attached to DF can be removed and while a meter is used to monitor the voltage B+, DF can be shorted to ground (with a jumper) with the motor running. Before the jumper is shorted to ground, the voltage at B+ should, of course, reflect the charge state of the battery (around 12 volts), but when the jumper is touched to ground (which is what the Voltage Regulator does in instantaneous bursts), the voltage at B+ should rise as the motor’s speed is increased. It should peak at about 15 volts (the maximum output of the Starter/Generator’s charge ability). If it does increase, then the Starter/Generator is alright. If it doesn’t, there is a problem with the Starter/Generator. If the voltage does increase, but the voltage at B+ doesn’t increase when the wire is re-attached to DF as the speed of the motor is increased, the Voltage Regulator is the culprit.
How many volts should a jumper have before it is shorted?
Before the jumper is shorted to ground, the voltage at B+ should, of course, reflect the charge state of the battery (around 12 volts), but when the jumper is touched to ground (which is what the Voltage Regulator does in instantaneous bursts), the voltage at B+ should rise as the motor’s speed is increased.
What happens when a starter generator spins?
That completes the circuit, so the Starter/Generator begins to spin. As it spins, a voltage appears at the DF terminal of the Starter/Generator, which is connected to the Voltage Regulator.
How many volts should a starter generator output?
It should peak at about 15 volts (the maximum output of the Starter/Generator’s charge ability). If it does increase, then the Starter/Generator is alright. If it doesn’t, there is a problem with the Starter/Generator.