Extend the shaft by pushing down on the end of the extension with your hand, then screw the extension onto the clubhead. Check alignment of extension and clubhead after installation by hitting a ball. If necessary, adjust screws to ensure proper alignment. Golf club shaft extensions are a great way to improve your game while on the green.
How do you shorten a golf club shaft?
To do that, the DIY golfer will have to:
- Remove the existing grip.
- With steel shafts, use a tubing cutter to trim the shaft; with graphite shafts, shorten using a hacksaw.
- Re-install a grip on the newly shortened shaft.
- And, most importantly, Wishon says, add weight to the clubhead in some manner to restore the swingweight feel of the club. ...
How to install a shaft in a golf club?
How to Install a Shaft in a Golf Club
- Remove the old shaft. It can be done by melting the glue, or epoxy, that holds the shaft to the head of the club.
- Cut the shaft to the proper length, depending on what club you are modifying. There are websites that can help you determine the length.
- Roughen the tip of your new shaft before inserting it into the hosel of the club head. ...
How do you replace a golf club shaft?
How To Re-Shaft Your Steel Golf Clubs
- Carefully clamp the shaft into a vise using a Shaft Vise Clamp. ...
- When removing steel shafts from clubheads, use a torch to heat the hosel. ...
- After 30 seconds of heating, with your gloved hands grasp the head and twist/pull the head. ...
- Using a wire brush remove excess epoxy from the inside of the hosel.
How much does it cost to reshaft a golf club?
So, how much does it cost to reshaft a golf club? To reshaft a golf club, you’re likely to spend between $20 to $200 per club. The cost of reshafting your golf clubs will vary greatly depending on where you go to have it done. The cost will depend on the cost of the labor, the number of clubs, and the cost of the new shafts.
Can golf club shafts be lengthened?
There are two ways to lengthen your shafts. You may add extenders to your existing shafts or you may replace your existing shafts with longer ones. The effects can be very different. Tom Wishon has written extensively about the effects of changing shafts in "The Golfsmith Practical Clubfitting Program" guide.
How do you install a golf club shaft extender?
0:562:35How To Install Graphite Shaft Extenders - YouTubeYouTubeStart of suggested clipEnd of suggested clipInto the butt end make sure it's nice and snug. And then we're ready to do our next assembly stageMoreInto the butt end make sure it's nice and snug. And then we're ready to do our next assembly stage which is to epoxy it into the shaft. Just want a good even coating.
How much does it cost to extend a golf shaft?
The average cost to reshaft your golf clubs is $24 per club plus the cost of the shaft and grip. A new iron shaft and grip can range between $10 and $95 while a new driver shaft and grip can range between $18 and $440.
How are golf shafts extended?
A shaft butt extension fits inside the grip end of the shaft and can lengthen it by up to 2 inches. Cut off and remove the old grip with the utility knife. Remove the old tape from the shaft, using a knife if necessary. Fit check the extension inside the end of the shaft.
What if my golf clubs are too short?
What Happens When Golf Clubs Are Too Short? For most golfers, having clubs that are too short will be better than if they're too long, but can still result in inconsistent shots. Clubs that are too short will make you stand bent over, which can cause back pain. You'll also have the tendency to push the ball a lot.
Do I need to lengthen my golf clubs?
Because golf is a game of repetition and your swing should not vary in most circumstances, your stance will be the same. It doesn't matter how tall you are if you have a deeper crouch in your swing because your wrists will then be closer to the ground, which means you need slightly shorter clubs.
Should I add length to my irons?
Sometimes a golfer's height and arm length will negate each other and a standard length is the best option. As length is increased, so is the weight. Increasing the length also changes shaft flex. For every 1" added, the shaft becomes one flex softer; likewise, a shorter shaft plays stiffer.
Is it worth Reshafting my irons?
Reshafting is just one way to keep your clubs performing at a high level. You can also benefit from regripping your clubs. Replacing worn-out golf grips can help make your clubs feel new again. Adding the right shaft to your favorite clubs can get you back on the course and working toward a new personal low round.
Is it easy to Reshaft irons?
Golf irons can be a bit easier to reshaft than a driver. If you are reshafting with steel irons, it is usually pretty straightforward. However, you will need the proper tools and space to complete this project.
How do you add 1/2 on a golf club?
5:529:01Extending Golf Shafts 1/2 Inch | How to at home! | Simple - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd then simply take your golf club and the extension. And insert one into the other. And twist itMoreAnd then simply take your golf club and the extension. And insert one into the other. And twist it down until you have no gift between the shaft and the extension itself and that will then rest.
Does lengthening a golf club change the lie angle?
The lie angle will automatically change if clubs are lengthened. Only slightly but it will change. There is no such thing as standard lie as all the manufacturers generally are different. The lie angle that is correct for you can only be tested dynamically - i.e. via a pro or fitter on a lie board hitting golf balls.
Does half an inch make a difference in golf clubs?
Master clubmaker Ralph Maltby says that adding 1/2 inch length can add about 5 to 7 yards in distance for irons. But the longer shaft still makes it harder to control the clubhead, which is even more important the closer you get to the green.
How does extending a golf shaft affect swing weight?
6. Remember that extending the shaft will make it feel a bit more flexible and that every ½” longer the shaft becomes will increase the club’s swingweight 3 points. The total weight of the club will increase equal to the weight of the extender and epoxy as well. The club’s balance point will move toward the grip end as well due to the longer length of the club.
How far should a steel shaft be extended?
1. Never extend a steel shaft more than 2″. Any more may cause premature failure due to stress where the extension is made. The only exception would be putter shafts.
Can you use wood dowels to extend steel shafts?
Wooden dowels can also be used to extend steel shafts, but these require much more work (in our opinion) than using steel extenders. 3. Always epoxy the extension in place, do not rely on a pressure fit. 4. Abrade the extension piece prior to installation to give the epoxy a better hold.
Is it safe to extend shafts?
Extending shafts is a common and profitable repair. Following the above common-sense rules will make the repair practical and safe.
Can you use graphite shafts as extenders?
5. Saving your old graphite shafts to use as shaft extenders will save you money and will make a perfectly acceptable extender.
How does lengthening a shaft affect swing?
Timing and Feel. In many ways, the biggest effect of lengthening a club shaft is how it affects your ability to swing the club. The combined changes in length and swing weight make the club feel different. In turn, these changes will affect your timing and even your mechanics, perhaps without you even realizing it.
Can you feel differently to get the club around?
You may simply feel that you must move differently to get the club around.
Can you use extenders to lengthen a golf club?
However, using extenders to lengthen a club will change the flex of the club, sometimes by an unpredictable amount. Not only does the shaft become more flexible than before, thus further affecting accuracy, but it lowers the kick (or bend) ...
Does lengthening the shaft make the club head heavier?
Lengthening the shaft increases the swing weight, which makes the club head feel heavier. It may even make the club too heavy for you, which will slow down your swing speed and actually reduce your distance.
Does lengthening a golf club shaft affect accuracy?
Accuracy. As a general rule, lengthening any club's shaft will reduce your accuracy with that club. The longer the club, the more difficult it becomes to hit the ball solidly. This is especially true when the ball is on the ground rather than on a tee, since hitting the ball fat is more likely.
Is shaft length a factor?
Shaft length is certainly a factor in how far you hit a given club. However, some clubs benefit more than others. Installing longer shafts in wedges and short irons will almost always result in more distance, as most players have little trouble swinging the shorter clubs.
Do golf clubs have longer shafts?
Effects of Lengthening a Golf Club Shaft. Tall players like Bubba Watson have to use longer shafts in all of their clubs. Most players consider using longer shafts in their clubs at some time or another, believing that longer shafts equal more distance, although that isn't necessarily true. There are two ways to lengthen your shafts.
How to lengthen a golf shaft?
The most common way of lengthening a shaft is by placing a “plug” in the top of the shaft which is covered by the grip. See the chart below that gives an idea of the actual length of shaft required for the average player. (men)
What is the function of the shaft in golf?
The shaft is the engine of the “car” and determines how far, straight and the trajectory of the ball flight. The dynamics of the shaft. The flex of the shaft changes if you lengthen or shorten the shaft. The swing-weight and balance will change effectively requiring the golfer to make adjustments to the swing.
How does the lie angle change in golf?
The lie-angle will change by forcing the golfer to stand closer or further from the ball at the address. And finally the real “kicker”, control.
Why are longer shafts fashionable?
To increase the swing arc, and thus the distance off the tee, longer shafts became fashionable.
Why is distance important in golf?
Distance may be important, but will not win you games unless you can control the direction and flight of the ball. Control and accuracy should and will be the factor that lowers the handicap and improves the all-around performance on the golf course.
How far should the back of the left hand be from the belt buckle?
Ideally, the back of the left hand should be about 6-inches from the belt buckle. (right-hand golfers)
What chart to use for suggested lengths?
Use the Iron chart for suggested lengths.
How to Install Golf Club Shaft Extensions
- If you are looking to improve your game by adding a few extra yards of range, then installing golf club shaft extensions might be the perfect solution. Here is a guide on how to do it: First, remove the club from the golf cart. Then, remove the shaft from the club. Next, install new shaft extensions and align and tighten them as needed. Finally, at...
Parts of A Golf Club Shaft
- Golf club shaft extensions are devices that are inserted into the end of a golf club shaft to increase its length. Golfers use them when they want to hit shots farther or higher off the ground. There are many types of golf club shaft extensions on the market, and each one is designed for a specific purpose. Golf club shaft extensions come in different lengths and weights, so you’ll nee…
Tools Required
- To install golf club shaft extensions, you will need the correct tools and pieces of equipment. There are a few different types of extensions that you can buy, each with its own set of instructions. The most important part of installing these extensions is to make sure that the fit is perfect. If your club has a metal shaft, then it is important to use a metal extension sleeve. If you…
Conclusion
- If you are looking to add some extra length to your golf club shafts, golf club shaft extensions can be a great option. They are easy to install and can give you the extra length you need for those tricky shots.