Turn it on and slowly press down on the accelerator. If the golf cart begins to move, you’ve fixed it! If nothing happens, and you hear no noise from the motor, then it is most likely finished with its run and should be replaced by a professional.
Full Answer
How do I bypass the reed switch on my EZGO golf cart?
How do I Bypass the Reed Switch on My EZGO? You can bypass the reed switch in an EZGO golf cart by connecting the red wire of the reed switch to the white wire from the charger receptacles and to the red wire from the FRN micro switch. Ensure that the main power supply is disconnected before accessing the reed switch and charger receptacles.
Do all EZ-GO golf carts have speed controllers?
Every EZ-GO golf cart comes equipped with one of two kinds of speed controllers, a precision drive system or a drive control system. All modern golf carts (Including any cart that is sold by Garrett’s) use the precision drive system or PDS, whereas older carts made before 1994 will use a drive control system.
Why does my EZGO golf cart stop and start while running?
EZGO golf carts tend to stop and start while running when there is a problem with the micro switch. In case you face any of these troubles in your golf cart, the first thing you should do is test the micro switches in your golf cart and have them fixed at the earliest.
How to reset a golf cart electric motor?
Carefully remove them with a screwdriver. Then reset your cart’s motor; most golf cart electric motors contain a special button designed to reset the motor by behaving like a tiny circuit breaker. You will usually find this button―you can’t miss it; it’s red!―in the same area where various wires enter the motor unit.
How do you fix a golf cart accelerator?
Open up your cart hood and find the wires connected to your controller. Check to make sure each of these wires is properly screwed down and held in place. Inspect all other wires throughout your engine and accelerators. Tighten the connections on these wires to ensure that they run smoothly.
Why does my golf cart not accelerate?
Bad Solenoid If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.
Why does my electric golf cart hesitate when I accelerate?
In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.
How does an electric golf cart throttle work?
Just like the gas-powered car throttle, the throttle is an inductive sensor. It pushes the acceleration lever to send electricity to the solenoid and speed controller and drives the motor. Electric Motor. The electric motor requires the right amount of electricity to turn the cart's wheel.
Why won't my electric golf cart go forward or reverse?
The problem could be with either the Run/Tow switch or Forward/Reverse switch or both. Check the switches to ensure that they aren't stuck midway. If they are, getting them released should help. However, if they show signs of wear and tear, you must get them replaced.
Where is the reset button on an EZGO electric golf cart?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
What causes hesitation on acceleration?
An engine that is hesitating to accelerate is most likely dealing with a fuel/air mixture that is too lean. Engine's that are running inefficiently will begin to show signs like hesitation which will only become worse over time.
What would cause a delay in acceleration?
What Causes Acceleration Problems? Hiccups in air and fuel delivery and sensor issues are the main causes of poor acceleration. However, mechanical issues can also be the cause of low power.
What can cause slow acceleration?
Here are 8 reasons why your car could be struggling to accelerate:Air Filter. It could be something as simple as a dirty air filter that isn't allowing enough air to get into the engine. ... Fuel System. ... Low Compression. ... Exhaust System. ... Sensor Failure/Malfunction. ... Spark Plugs. ... Ignition Coil. ... Transmission.
How do you test the inductive throttle sensor on a EZGO golf cart?
Put the key in the “On” position in your Run/Tow switch on the cart. Switch the F/R switch into a forward position to test your cart. Place your voltimeter testing pins on the throttle pins to see how much voltage you get. When the cart is running with no throttle, you should get about 10 volts here.
How do I fix my EZGO speed controller?
Here are 5 steps you should follow for a DIY fix to your golf cart's speed controller.Flip the maintenance switch. ... Reset the battery cable. ... Check your connections. ... Test the solenoid. ... Check your controller's power output.
How do you troubleshoot an electric EZGO golf cart?
Things to Keep in Mind Before TroubleshootingEZGO golf cart batteries aren't perfect right away.Sticky accelerators are perfectly normal and can be fixed easily.Keep your cart stable.Make sure your charging wall socket isn't faulty.Keep your tire pressure stable.Troubleshooting the speed controller.
Why is my golf cart not turning?
The two possible problems you can identify this way is either a bad speed controller, or a bad directional switch or motor. If the motor on your golf cart doesn’t turn, the problem is probably the directional switch/motor, but if there is no voltage at all on your reading, you’ll need to replace your speed controller.
How to test solenoid on a cart?
To test your cart’s solenoid, you’ll want to take a reading of the voltage and compare it to the reading you got off your battery. Att ach the positive probe to the solenoid post nearest the battery and get the reading. If the solenoid and battery readings are identical, there is an issue with the solenoid.
What happens if the solenoid and battery readings are identical?
However, if the reading isn’t at least 3 volts less than the battery, the problem is with the resistor and it should be replaced . Check your controller’s power output.
What is Garrett's drive system?
All modern golf carts (Including any cart that is sold by Garrett’s) use the precision drive system or PDS, whereas older carts made before 1994 will use a drive control system. These devices control the acceleration and overall speed of the golf cart, so when they’re not working properly it’s important to know what to do.
What is an EZGO golf cart?
Your EZGO golf cart is probably a more integral part of your life than you realize. If you live in a residential neighborhood or gated community, chances are that you use your golf cart for a wide variety of purposes beyond simply golfing―to take a trip to the nearby grocery store, to drive a mile or two to the country club or tennis courts down the road, to act as a makeshift hunting vehicle during hunting season, or even to fetch your mail in rainy or snowy weather.
What does the Ezgo manual say about battery replacement?
The EZGO manual says that, “First, a battery that performs poorly and is outside of the manufacturer’s specification should be identified in order to replace it under the terms of the manufacturer’s warranty.”. This means that every manufacturer retains its own unique requirements, specs, and timelines.
Why is it important to keep a golf cart in good shape?
Therefore, it is very important to keep your golf cart in great shape at all times, and learning how to troubleshoot can mean the difference between diagnosing and quickly fixing problems, or having your cart break down.
How many cycles does a golf cart battery take?
Your golf cart’s battery needs to mature completely before it can operate at its maximum levels. This can take as many as 100 full charge cycles, so be patient if the brand new golf cart you just purchased isn’t quite living up to its battery expectations.
What happens if the voltage is not equal to the voltage on a solenoid?
If it is not equal, then the solenoid has a wiring problem. oYou should also put the positive probe on the opposite post of the solenoid and read the voltage there. The voltage should have three or more volts below the battery’s own reading. If not, then you should get the resistor replaced as soon as possible.
What is the recommended tire pressure for an EZGO cart?
The standard recommended pressure of an EZGO cart’s tires ranges from 18 to 22 PSI. Be sure to inspect your tires regularly, too, and replace them as necessary. If your cart is driving slower than usual or making strange noises “down there,” it could very well just be a sign of low tire pressure.
Why is my golf cart foot pedal so smooth?
If you are having issues with the smoothness of your foot pedal, it may simply be due to the air quality of your surroundings and should eventually fix itself. If your golf cart is a few months or years old, the stickiness may be due to constant pressure.
Do E-Z-Go Golf Carts have titles?
E-Z-Go Golf Carts, unlike vehicles, do not have a title, but they do have serial numbers. If you are buying a golf cart, it is essential to check the serial number to ensure you do not buy a stolen one. Each E-Z-Go Golf cart has a unique serial number that you can use to identify your golf cart.
Where is the E-Z-Go Cart Serial Number
As mentioned above, all E-Z-Go Golf carts have unique serial numbers. These numbers are essential when buying replacement parts for your golf cart. Textron Specialized Vehicles has been building golf carts for a long time, and the serial numbers are placed on different parts of the golf carts.
How do I push my E-Z-Go Golf Cart?
It can be frustrating when your battery is flat and your golf cart will not roll. To push it to the nearest charging or gas station, you need to release the motor brake. Follow these easy steps to do that.
Why does my E-Z-Go golf cart not move
There are several reasons why your cart refuses to move, but you should check the battery before anything else. If the battery is charged, here are some other reasons why your golf cart will not move.
Are all E-Z-Go Golf carts electric?
No, there are both electric and gas-powered E-Z-Go Golf carts available. Bear in mind that there are several models you can drive on the street, but those are all-electric. These electric models run on batteries that you have to charge at least every 24 hours, depending on how much you use them.
How to tell the Assembly year of my E-Z-Go golf cart
The placement of serial numbers is discussed above, and you will find the manufacturer’s number right next to it. The manufacturer’s number consists of one letter and 3 or 4 numbers. The last two numbers indicate the last two digits of the year of assembly.
How to service E-Z-Go Golf Cart
Like all vehicles, E-Z-Go golf carts require regular maintenance to enhance longevity and performance. You should ensure that your golf cart is serviced after every six months of use. That will ensure that you spot problems and repair them early, which will help reduce repair costs. Here are essential guidelines for E-Z-Go golf cart maintenance.
Where is the accelerator switch on an EZGO golf cart?
On EZGO gas golf carts, the accelerator micro switch is located behind the forward-reverse lever and right below the seats under the mat near the accelerator pedal.
How to bypass a reed switch on an EZGO golf cart?
To bypass the reed switch, remove the reed switch and install an eyelet on the white wire that was cut short in step 3. Connect the new eyelet to the A+ terminal of the charger receptacle which was opened in step 2. The above steps ensure that the reed switch is safely bypassed on your EZGO golf cart.
Why does my EZGO golf cart stop?
EZGO golf carts tend to stop and start while running when there is a problem with the micro switch. In case you face any of these troubles in your golf cart, the first thing you should do is test the micro switches in your golf cart and have them fixed at the earliest.
How does a golf cart accelerator work?
Accelerates the golf cart. A micro switch on the accelerator pedal gets activated once the pedal is pushed. This sends a signal to the solenoid and in turn more power to your wheels to make them move faster. These micro switches are more common in electric golf carts.
Why does my golf cart micro switch stop working?
A bumpy ride, a wrong wiring or a defective component can cause the micro switch to stop performing as expected. A list of common problems associated with micro switches in a golf cart is given below. The mechanical switch gets stuck and doesn’t turn over when charged.
Where are the switches on an EZGO golf cart?
Most of the micro switches on EZGO golf carts including the EZGO TXT, EZGO RXV, and EZGO Express are located beneath the cart near the chassis. You have to unscrew the cover and access the switches.
Can you fix a golf cart on your own?
Under NO circumstances should you attempt to fix your golf cart on your own. Doing so is dangerous and could result in serious bodily harm. The information on this website has not been verified for accuracy and should only be used for general information purposes only. Use this information at your own risk. The author (s) and owner of of golfstorageguide.com are NOT trained electricians, mechanics or technicians. The webmaster of golfstorageguide.com and the author (s) is not responsible for any loss in damages, financial loss, personal injury, or death. By using the content on this website, you agree to the terms outlined in this disclaimer.