The governor on a golf cart can be adjusted easily by loosening the tension on its springs using a wrench or screwdriver to get the golf cart going at a relatively faster speed. In some cases, the adjustment can be done by turning the cable nut that connects the cable to the throttle lever in the counter-clockwise direction.
Full Answer
Are RXV golf carts any good?
The RXV line pushed the boundaries of the typical golf cart with their AC Motor system and motor brake. They did have some major motor issues in the roll out of the new product, however, golfers have enjoyed the features.
Should I buy a golf cart with an adjusted Governor?
You'll likely need to get repairs and replacement parts faster on a cart with an adjusted governor. In addition, any cart that can go above 19mph is officially a motor vehicle, and you legally need seatbelts and inspections. This shouldn't be a big problem, but it is worth knowing.
How fast does a golf cart go with the governor on?
This article has been viewed 507,181 times. Learn more... Adjusting the governor can make your golf cart go 5–10 mph (8.0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h).
What is an EZGO freedom RXV golf cart?
It was one of the first of its kinds to be introduced to the Golf Cart market. One of the innovative features of the EZGO Freedom RXV Golf Cart was the inclusion of a motor brake built into the motor making it so when you come to a stop, you do not have to engage the motor brake manually – It locks automatically.
How to make a golf cart go faster?
Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.
How to adjust EZ Go cart governor?
To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.
How to get a cart to move faster?
1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.
How fast can a golf cart go?
Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.
How many screws are in a golf cart engine?
There should be five screws in most models. The engine is in the front of golf carts, underneath this panel. Take off the plastic cover and set it aside with the seats. ...
How to change the speed of a car?
Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...
How to raise the top speed of a golf cart?
To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly. If you cannot find this spring, you likely have a newer model that is more difficult to adjust, though this is rare. Lift up the seat. Remove the seat cousins, which hide the engine.
What happens if your battery is dead on a golf cart?
Also, since the motor brake runs off the battery power, if your batteries are dead, then the vehicle will not move until a service professional can get access to the vehicle . The RXV line pushed the boundaries of the typical golf cart with their AC Motor system and motor brake.
When was the EZGO Freedom RXV introduced?
Their EZGO RXV model was introduced in 2007 with an AC motor system. It was one of the first of its kinds to be introduced to the Golf Cart market. One of the innovative features of the EZGO Freedom RXV Golf Cart was the inclusion of a motor brake built into the motor making it so when you come to a stop, you do not have to engage ...
How to remove clutch on EZGO golf cart?
How to remove a secondary clutch on an EZGO golf cart. First of all, make sure that the golf cart is turned off, and the brake is in place. Make sure to put pressure on the gas pedal. Use a clutch puller to remove the drive belt. Loosen the central bolt using an air gun.
How to remove secondary clutch on Yamaha golf cart?
Just carefully follow the given steps: First of all, identify the right clutch puller according to the VIN number of the golf cart you are operating.
Why does my golf cart clutch slip?
There can be a problem with the drive belt, which can cause the clutch to slip. Sometimes the installed belt drive may not match the clutch in the golf cart, causing problems. Just replace it, and you are good to go. Check if the belt drive is misaligned. This is also a common problem with the clutch.
What is wrong with my golf cart clutch?
If there is any problem in how your golf cart runs, you can check for the following problems: There might be a problem with the belt. Check if the belt is too tight or loose.
What is clutch puller?
They are the clutch puller, an air gun, machine oil, and a rubber hammer. It is necessary to be gentle in the process because if you use excessive force, then the transmission may be damaged. So, take great care while adjusting the clutch and use the clutch puller that matches the cart’s model.
What to do if you have a problem with your G16 golf cart?
If there is any problem with the secondary clutch, it is best to replace it or the drive belt connected to it. If you are unsure about removing the drive belt or the clutch, then you can adjust it.
How to find primary clutch on golf cart?
There are two clutches in the golf cart. To locate the primary clutch, it is generally the lower one. Consult the cart’s manual to make sure. First, observe exactly how the drive belts have been adjusted to the clutches. After you have noted that.
How to make a cart faster?
Step 1. The first option to making your cart faster is to replace the electronic speed control. This will enable more voltage to pass to the motor, producing the desired result. Unfortunately, this upgrade is not inexpensive as the unit can run anywhere from $100 to $1,000. Step 2.
How fast can a factory cart go?
The factory gear most likely has a 12.5:1 ratio, which allows the cart to achieve somewhere around 14 mph. If you swap out the factory gear for one with an 8:1 gear ratio, you'll up your top end to about 20 mph.
Can you drive a golf cart faster?
It should be noted that the golf cart you are trying to make faster may not be designed to do so. Weigh the options carefully and exercise caution whenever driving a golf cart at any speed. Remember that golf carts are not equipped with seat belts, air bags and other safety equipment that you find in automobiles.
Who is Lawrence Malestic?
About The Author. Lawrence Malestic grew up around the game of golf, first as a club caddie at North Shore Country Club in Glenview, Illinois. He then became a professional, caddying on the PGA European Tour for 2 seasons and the Senior PGA Tour for 12 years. His former bosses include Orville Moody, Bruce Crampton, Chi Chi Rodriguez, Gary Player, ...
What is the Freedom RXV?
Freedom RXV models bring the perfect combination of efficiency, performance and style to your course. With standard headlights, golfer-focused upgrades and a smooth ride, the Freedom RXV adds more to every round. Electric and ELiTE lithium Freedom RXV models are equipped with energy-efficient IntelliBrake technology and an automatic parking brake, while the first-of-it’s-kind EX1 gas engine with closed-loop EFI adds numerous ownership benefits.
Does the RXV electric reduce maintenance?
“Since making the switch to the RXV ELiTE, we have seen a significant reduction in electricity costs. The reduced maintenance allows us to turn cars quickly, which helps elevate our customer experience.”