You can grease the golf cart manually by following these steps:
- Disconnect the battery.
- Remove the golf cart from the charger.
- Remove the battery cover.
- Open the battery compartment.
- Find the small fitting in the middle of the battery compartment.
- Remove the small fitting.
- Turn the small fitting counter-clockwise to loosen it. ...
- Turn the fitting clockwise to loosen it.
- The grease fitting should be loose.
How do you fix a loose steering wheel on a golf cart?
Now, you can fit the wheel back the way you removed it, putting the washer and nut back and tightening with a wrench or a rachet. Take the cart out and see if you feel comfortable and the steering wheel is not loose anymore.
How do I clean the grease off of my front wheel bearings?
You will want to clean the grease off bearings, any parts you removed, check them for wear also (degreaser solvent,rags and paint brush work for removing old grease).
How to fix a water damaged golf cart?
Inspect the cart bearings, motor, gears, and couplings. Change the RE Fluid in the Golf cart. Don’t start driving when your cart is not completely dry after washing it. While washing, it is possible that some water entered the F&R switch. Remove the switches and also the wires and then dry them properly and rewire them.
Can I Drive my Yamaha golf cart with a loose steering wheel?
You should not be driving your golf cart if the steering wheel is too loose. There may be other reasons why you may have to make adjustments to the steering wheel on your Yamaha golf cart.
Do golf carts have grease fittings?
The front end of your car will have "Zerk" or "Grease Fittings", that allow you to apply grease via a grease gun into the high wear points on the golf cart.
Where do I grease my EZ Go golf cart?
The suspension in EZ Go can be greased manually by following these steps:Remove the cap on the front of the rear axle.Turn the wheel anti-clockwise until the cap is off.Remove the grease inside the cap.Pour the newly purchased synthetic water-resistant grease into the cap and replace it.More items...
How do you lubricate a Club Car golf cart?
0:572:10Club Car Golf Carts - Lubrication Schedule - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou're going to want to actually feet see how the grease comes out of there fitting. Watch when IMoreYou're going to want to actually feet see how the grease comes out of there fitting. Watch when I push this see how it comes out you want to be able to see grease coming out of the fitting.
What type of grease do you use for wheel bearings?
Most wheel bearings require an NLGI 2 grade grease, while some sealed hub units require an NLGI 00 grade semi-fluid product.
Why do golf carts squeak?
The five most common reasons a golf cart squeaks include bad rubber bushings, front and rear spring failure, slipping belts, loose parts rubbing together, and problems with your wheels.
What maintenance is required for electric golf cart?
All the connections should be clean and tight. You shouldn't have any corrosion or dirt coating the connections within your golf cart batteries. If you do, create a solution using water and baking soda and clean them. It'll help you maintain proper connections within your batteries so that they charge correctly.
How do you maintain a golf cart?
Start by consulting the owner's manual for your cart for any specific maintenance or safety precautions, and then follow these eight tips for golf cart upkeep:Charge Your Batteries. ... Fill Battery Cells, But Not Too Much. ... Clean The Batteries. ... Keep The Tires Filled. ... Check The Brakes. ... Keep An Eye Out For Oil Leaks.More items...
How do you adjust the toe on a Club Car DS?
2:514:39Crash Course #11 How to Adjust Toe and Camber - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd rotate it one full turn on the passenger. Side I want to rotate it one full turn on the driverMoreAnd rotate it one full turn on the passenger. Side I want to rotate it one full turn on the driver side as well that helps keep everything even. And once you've made your adjustments.
Do you need to put grease on wheel bearings?
The importance of grease on wheel bearing can never be overemphasized, greasing the wheel bearing provides lubrication and prevents corrosion. Without greasing, the bearing and the parts around it can rust, and this will affect the bearing's performance.
Can you use all purpose grease on wheel bearings?
Multi-Purpose Grease These have a high resistance to water, but do not fare well under high heat application, such as disc brake wheel bearings. DO NOT use multi-purpose grease for disc brake wheel bearings or other high-heat applications.
What happens if you over grease a bearing?
Too much grease volume (overgreasing) in a bearing cavity will cause the rotating bearing elements to begin churning the grease, pushing it out of the way, resulting in energy loss and rising temperatures.
How to turn locknut on golf cart?
The locknut should now be turned using the wrench in the clockwise direction; this must be done holding the center adjustment bolt in position. Move the steering wheel a few times to check if it is freely moving without any binding. Now lower the golf cart and remove the wheel blocks.
How to fit steering wheel back after you removed it?
The wheel will come off. Now, you can fit the wheel back the way you removed it, putting the washer and nut back and tightening with a wrench or a rachet. Take the cart out and see if you feel comfortable and the steering wheel is not loose anymore.
How to fix a loose steering wheel on a Yamaha golf cart?
You can fix a loose steering wheel on a Yamaha golf cart by opening up the steering box, filling it with grease, and closing the cover. Jack up the front of your Yamaha golf cart. Remove the cover of the steering box; it’s a plate secured by 4x 10mm bolts. Now fill the box with grease till the top. Fix the cover back.
Why is my Yamaha golf cart steering wheel loose?
The most common reason for a loose steering wheel on your Yamaha golf cart is a loose tie rod. This can make your cart’s steering wheel feel loose while driving. Reasons for a loose steering wheel on a Yamaha golf cart: Cracks in the steering box. There could be cracks in it or the grease could be leaking. Faulty wheel bearings.
How to get steering wheel out of place?
You can now jerk the steering wheel out from its place. One way is to use all the force in your two hands to shake the wheel up and down and pull it towards you. The other option is to use a nylon hammer and tap the wheel from below lightly.
How to stop a cart from rolling off?
Place blocks on one of the rear wheels to prevent the cart from rolling off. Lift the front part of the cart with a jack; the wheels should be free. Now check if there is any play in the steering wheel by rotating the wheels right to left and back until they lock.
How to check if golf cart tie rods are locked?
The tie rod runs between the two front wheels and is connected to the steering shaft. You must turn the wheels manually to one side and then the other to check if the tie rods are locked in place and not loose.
What is a Wheel Bearing on a Golf Cart?
Wheel bearings are essential pieces in the overall performance of your golf cart. These small pieces of equipment, which work alongside the wheel and tire assemblies, are a series of small steel balls held together by a metal ring. This metal ring is often referred to as a race.
The Two Types of Golf Cart Wheel Bearings
In general, there are two common types of wheel bearings that are often used on golf carts. These two types are sealed and unsealed wheel bearings. Both of these wheel bearings are made up of the same components: a series of steel balls and a steel race which are inserted flush against the hub of a golf cart’s brakes.
Keep on Rolling
If you think about it, wheel bearings are pretty impressive. These little manufactured pieces of steel allow your golf cart to smoothly transition across an array of terrain while maintaining the optimal performance of your wheels and tires and eliminating friction.
Why does my EZGO make a noise?
Why is my EZGO making noises from the rear end? The main reason a EZGO cart can start making noises in the rear end is because of loose bolts, or because the input shaft splines are dirty and need to be greased. Check the input shaft splines of the motor as over time they need to be cleaned or greased.
Why does my golf cart make a noise?
The common reason behind any sounds occurring from the rear end of a golf cart is damaged Motor bearings. But it is also for a coach to make noises after a certain period of usage. Well, when a cart gets old, it requires extra care anyway, so let’s get started.
How to check if your cart needs fluid oil?
Check if your cart needs fluid oil. Ensure the belt is not worn out; if it is, then replacing it could stop the noises. Check if the clutch shaft is alright. If it is damaged, then it will become loose whenever the clutch will open and start making noises.
Is a golf cart dangerous?
A golf cart making weird noises is a very common issue. Sometimes, these noises reach such a high pitch that it becomes beyond annoying. If the cart is making whining noises, then it’s not that dangerous.
Is a noisy steering wheel common?
A noisy steering wheel is not at all something only you are facing; it’s pretty common. Here is a step by step trouble mentioned below; see if it would work: