Assemble air bags Mount frame brackets Attach bags to frame & axle Attach heat shield to muffler Install air lines & test for leaks The only tools you will need for this installation include:
Full Answer
How do you install air bags on a jeep?
1 Remove jounce bumpers 2 Assemble air bags 3 Mount frame brackets 4 Attach bags to frame & axle 5 Attach heat shield to muffler 6 Install air lines & test for leaks
Do you need to drill to install airbag Springs?
There’s no drilling (and few tools) required to install an air bag suspension system. We didn’t know much about air bag springs when we started full-time RVing, but we quickly learned how beneficial they could be after upgrading to a slightly larger fifth wheel.
How do you install air bag suspension on a fifth wheel?
How to install air bag suspension on a fifth wheel tow vehicle. Remove jounce bumpers. Assemble air bags. Mount frame brackets. Attach bags to frame & axle. Attach heat shield to muffler. Install air lines & test for leaks.
Can I use information from this web site to install my airbags?
If you use any of information from this web-site to install your airbags you do so at your own risk. Improperly installing airbags can cause accidental deployments and therefore serious bodily injury. Your first responsibility prior to starting the installation process is to disconnect the terminals from the battery.
Which air bags kit is best for my truck and fifth wheel hitch?
The first question we had when researching which air suspension springs are best for our truck was, “ Will air bags fit my Dodge Ram 2500 with a Superglide fifth wheel hitch installed? ”
How to install air bag suspension on a fifth wheel tow vehicle
We found that the AIR LIFT 57295 LoadLifter 5000 Series Rear Air Spring Kit is exactly what it proclaims to be—a “no drill” kit that can easily be installed within a couple hours. Installing the Air Lift 5000 suspension kit can be done by one person in just a couple hours with only a few tools.
Love RVing? You'll Love RV LIFE Pro
It’s the wanderlust, the freedom of the open road. It’s not the destination, but the journey. It’s exploring the world. You don’t need a house because when you travel, you’re home. That’s RV LIFE.
What is the airbag control module?
The control module is the main computer for the airbags. It records and stores all the crash data for the SRS system.
What to do if airbag connectors melted?
If airbag connectors have melted you need to cut the wires leading to the coil and replace with a new clock spring.
How many ohms does an airbag need?
Never use the probs on your meter to directly test the terminals or connectors on any airbag. The airbag requires only 2 - 3 oh ms for deployment and touching the airbag terminals with your meter may provide enough current to activate the airbag.
Can you store airbags on vinyl?
However, if the airbag is set vinyl side down an accidental deployment will cause it to become a dangerous flying projectile. Therefore, "best practice" would be to store the airbag down on the floor vinyl side up inside a 4-mil anti-static plastic bag until you are ready to re-install it in your vehicle.
Should I store my airbag in an antistatic bag?
You should store it inside an anti-static bag and lay it down vinyl side up. It is important to lay it down vinyl side up because if it does accidentally deploy the energy of the airbag will only cause the airbag to open and no harm is done.
