How to Lower a Golf Cart
- Step One: Lift the Cart Smoothly Place your golf cart on a hydraulic lift and put it as high up as you can, while still...
- Step Two: Remove the Tires and Axles
Full Answer
How do you lower the top of a golf cart?
Make measurements to locate golf cart top lowering brackets. Drill holes to attach brackets (best to do one by one) Cut roof strut at angle to accommodate lowering process and movement ( Note – need to make sure angle is cut in right direction) Repeat process on all four corners of golf cart.
How do you toe-in and toe-out a golf cart?
To toe-in, turn it towards the Club Car’s front end and toe-out, turn it towards the back end of the Club Car. After the tires are aligned correctly, lower the cart to the ground and double-check the symmetry.
How do you align golf cart tires?
To toe-in, turn it towards the Club Car’s front end and toe-out, turn it towards the back end of the Club Car. After the tires are aligned correctly, lower the cart to the ground and double-check the symmetry. When the golf cart wheels have spun forward, examine the toe-in one more time and adjust as required if the symmetry is uneven.
How to level out a leaning golf cart?
Try swapping out the springs from both the sides. Changing the springs will level out your cart and solve this problem. If you find that your golf cart is leaning towards the right, the issue is coming from the suspension system or the springs under the driver’s side.
How do you lower a raised golf cart?
3:125:56How to Install E-Z-GO TXT Lowering Kit - YouTubeYouTubeStart of suggested clipEnd of suggested clipWith the rear axle fully supported on both sides. We can begin removing the u bolts holding the leafMoreWith the rear axle fully supported on both sides. We can begin removing the u bolts holding the leaf springs to the axle. One side of the.
How do you drop a golf cart?
0:422:44How To Drop Off A Cart Path | Approach Shots | Golf DigestYouTubeStart of suggested clipEnd of suggested clipIn this area. Here that's one club length from my nearest point of relief. And no closer to the holeMoreIn this area. Here that's one club length from my nearest point of relief. And no closer to the hole. So I would hold my arm out shoulder length and just let the ball drop.
How do you slow down a Club Car golf cart?
Keep the Run/Tow switch to the 'Run' position. Now push the car manually. In a Club Car golf cart in which the speed sensor is working fine, it will slow the cart down.
Can you adjust the speed on a Club Car golf cart?
0:131:31Club Car Precedent Speed Increase SUPER EASY!!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. AndMoreIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. And if you turn it that way or clockwise it speeds things up. Very.
How do you get a free drop in golf?
(... Continued) and relief is allowed under Rule 16.3a, the player may take free relief by dropping. (... Continued) the original ball or another ball in this relief area....Reference Point: The spot right behind where the ball is embedded. ... Size of Relief Area Measured from Reference Point: One club-length.More items...
How do you find the nearest point of relief?
0:202:26Rules of Golf :: Nearest Point of Relief - YouTubeYouTubeStart of suggested clipEnd of suggested clipI can see it is going to be the reference on the left I can pick up my tee on this side. And it willMoreI can see it is going to be the reference on the left I can pick up my tee on this side. And it will be this side of the path where I take my drop.
How do I change the speed on my Club Car?
1:1811:46Club Car precedent speed code 5 - YouTubeYouTubeStart of suggested clipEnd of suggested clipOkay it says programming is very easy. And it should take about 45 seconds first decide which speedMoreOkay it says programming is very easy. And it should take about 45 seconds first decide which speed you want to use.
What makes a golf cart slow down?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
How do you remove the speed limiter on a Club Car?
0:040:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this leverMoreYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.
What controls the speed on a Club Car?
The basic function of a speed controller is, as the name implies, to control and manage the cart's speed. If your golf cart is working on a Brushless DC or AC motor, you will not be going anywhere without a speed controller.
How do you adjust the governor on a Club Car?
Steps to Adjust EZ-GO Golf Cart GovernorStep 1 - First, lift the seat of your engine to reveal seat cousins. ... Step 2 - Remove the seat cushions over your motor. ... Step 3 - Remove the black plastic cover to expose the motor. ... Step 4 - Loosen the smaller one and tighten the larger one to increase your cart's speed.More items...•
What does a controller do on a Club Car golf cart?
The Club Car controller measures the batteries' current and voltage to adjust the golf cart's speed. It monitors the state of the motor and generates a signal to match the alternating currents.
Do you get a free drop from a cart path?
The good news for you is there's no penalty for taking a drop from the cart path. USGA Rules note that a golfer is entitled to free relief from a cart path if the ball comes to rest upon the path or the golfer's swing or stance is inhibited by the path.
What is the new drop rule in golf?
The New Rule: The new rule states that a player's only requirement is that the ball must be at knee height when dropping and must not touch any part of a player's body or equipment before hitting the ground.
How do you drop from a lateral hazard?
0:060:56Golf's New Rules (2019): Procedure for Taking Lateral Relief - YouTubeYouTubeStart of suggested clipEnd of suggested clipIn the 2019 rules club lengths are the length of the longest Club in your bag except. Your putterMoreIn the 2019 rules club lengths are the length of the longest Club in your bag except. Your putter and then drop a ball in that. Area. Your drop ball must land in and come to rest in the relief.
Does a drop count as a stroke?
The penalty stroke assessed is not the stroke made on the new ball; it is counted in addition to any and all swings made at the ball. For instance, hitting a ball into a water hazard, dropping a new ball at the position from which the last one was hit, then hitting the new ball counts as three strokes, not two.
Videos
Here are a few videos for the DIY-ers out there looking to save a few bucks and who don’t care so much about the finished look just need to be able to lower the golf cart top to make it fit somewhere. Checkout this YouTube video to learn more.
Easy to follow
Pete got a member of his office staff to try the kit – here’s what they said:
Added extras
If you are looking for a affordable solution to add some music to your golf cart? Checkout Pete’s new golf cart top mounting Bluetooth stereo systems. Models specifically for the Club Car Onward and Precedent, Ezgo Rxv and the Yamaha Drive. Pete’s Golf Carts has all the cool accessories for your golf cart.
Why do golf carts need camber?
The camber is the angle of the wheels of a golf cart The camber is extremely important for maintaining the balance of the tyres on a golf cart. Golf cart owners need a good camber adjustment to ensure a smooth jerk-free ride. The golf cart’s wheels get wearied away over time due to regular rides over rough terrain, potholes and other uneven ground, ...
What size arm lift kit for Yamaha golf cart?
One can opt for a 6’ double A arm to avoid such a problem. A rollover or crashing golf cart: A six inch A arm lift kit that suits the Yamaha Drive model can cause reduced control over your golf cart if you don’t adjust the camber of its front wheels properly.
Why is my Yamaha G9 camber bad?
Worn out or incorrect struts are a key cause of camber problems in a Yamaha G9 golf cart. Often, this, combined with excessive positive camber can wear away your tires very easily. The positive camber can be a result of worn out shocks.
How to make a cart out of a car?
Begin by jacking up your car’s front wheels. Move out each of the wheels and make a pattern along the middle, covering the circumference. Now put them on the ground with the tires facing front. Drive the cart forward by approximately five feet with the tires in normal running position.
Why do my wheels have negative camber?
Consider replacing the struts and you will have a fine camber again. Negative camber can also be the result of wide tires or loose king pins. Don’t forget to check out the toe-in of your cart.
How to check camber on G1?
A good option to check the camber on a G1 is to check the toe-in. You can easily do that by watching it roll over a flat surface. If you detect an off toeing in, it will definitely reflect on the camber. You can put in a four stroke axle to take care of the problem. That should help.
How to jack up a car with a heim joint?
Use the parking brakes to jack up your car. Then loosen the lower heim joint by loosening the nut of the lower control arm. You must adjust the nuts to bring them closer to or farther from the frame of the car if the camber is out or in respectively. Lower the car and check the camber. Repeat the steps if needed.
How to loosen lug nuts on club car?
You must do this on all of the bushings to make the process easier later on. Jack up the Club Car from the back. Use a ¾-inch socket to loosen the lug nuts on the back tire.
How to align club car front end?
The best way of aligning the Club Car front end is to first adjust the placement of the camber, followed by the alignment of the wheel and tire, by toeing them in or out as per required .
What to do if camber does not budge?
If the camber still does not budge, redo the procedure on both joints and keep adjusting the position as required. After the front end of the driver’s side is completed, redo the whole procedure for the front tire on the passenger side of the Club Car.
Why does my golf cart wobble?
If the front-end of your golf cart wobbles while driving, it could be due to faulty and/or non-branded tires, incorrect tire alignment or a faulty engine. Faulty and/or non-branded tires. Incorrect alignment of the tires. Faulty engine.
How to use a 12mm wrench on a ball joint?
Unfasten the jam nuts on the ball joints using a 19 mm wrench. Use the 12mm wrench on each side of the tie rod and turn it outward to toe-out or inward to toe-in. Both sides must be turned the same number of times. Once done, retighten the jam nuts.
What causes a club car to crash?
Front Leaf Spring Bushings: Worn-out bushings in the front leaf spring can cause the Club Car to crash while in motion and could also cause camber and tire issues. Replacing all the above parts will fix the front end problems and also improve overall control, camber and tire of your Club Car.
How to fix a club car that is wobbling?
Steps to fix the wobble: Align the tires properly. Examine the height of the tires and ensure that the placement of both tires is even. Pull out the tires and clean them if there is any dirt jabbed in them. You must also consider inspecting the engine of your Club Car , along with the steering wheel.
How to change the speed of a golf cart?
Locate the spring on the differential or carburetor that helps in changing the cart speed by adjusting its tension. Increase the length of the cable that is fitted on to the body of the throttle and clutch of the two-stroke engine.
How to ride a golf cart at full speed?
Ride the cart at full speed over a course of known length. This will ensure that the governor controls the speed of the cart within factory specifications. Fasten the black plastic cover and put the seat back in place. Take care when tightening the nut. The more you tighten, the faster your cart will go.
How to start a golf cart with a gas pedal?
Locate the gas pedal that is fitted to the governor and remove the connection. Re-route the gas pedal to the carburetor. Remove the bolt present on the shaft of the gas pedal. Slide the shaft upwards so that the gas pedal has more play. Tighten the bolt and start the golf cart.
How fast is an EZGO golf cart?
The top speed of an EZGO golf cart is usually 19.9mph and the average speed is 14mph to 15mph. With governor adjustment, the EZGO cart can go faster by 5 to 10mph.
What is a golf cart governor?
A golf cart governor is a mechanical device that helps in controlling the maximum speed of the cart when it moves on flat ground. This device prevents the engine RPMs from increasing beyond the recommended specifications.
Where is the governor arm on a golf cart?
Locate the governor arm of the golf cart. This is mounted above the rear axle housing and under the cart. Depending on the cart model, there may be a protection plate above the governor.
Can you remove a golf cart governor?
It doesn’t take much time or skill to remove a golf cart governor. With some basic mechanical expertise and general-purpose tools, you can do this yourself. The process is more or less the same in all golf carts.
Why is my golf cart leaning to one side?
Why is My Golf Car Leaning to One Side? A golf cart may be leaning to one side because of a bent spring, a cracked frame or simply from only one person riding the cart for years at a time. In most of the cases, the cart might be leaning heavily in the front or the back. This means that if you look at your cart from the front you might notice ...
What happens if a golf cart is damaged?
If any of them are damaged, the cart may lean towards one side. The shock absorbers present under the frame could be broken or damaged. You will have to lift the cart to view this. If it appears that these components are broken, simply replacing them will solve the issue.
Why does my cart lean towards the right?
Another possibility is that the cantilever on the rear side could have broken or rusted out. This can cause the cart to lean towards the right side. Also, check the springs under the driver’s seat for any damage or bent edges. If they appear bent, replace them with a new one of the same size.
How to check if a cart retainer is broken?
Check for a broken retainer on the leaning side. If the retainer is broken, the cart will not be able to balance correctly. You can swap the shock absorbers from the rear to the front or vice-versa. This will help you to figure out if the shocks are causing the lean.
How to tell if a cart spring has collapsed?
To identify if the springs have collapsed you can take a ruler and measure the springs on both sides. If one side has a longer length than the other side you will know that it has collapsed.
Can a driver's side frame be cracked?
This will help reduce the lean on the driver’s side. Another possibility is that the frame under the driver’s side could be cracked. You may have to take your cart to a service center to lift it on a high pedestal. Once this is done, they will be able to view the frame.
Does Yamaha G16 have a lean?
If your Yamaha golf cart is creating troubles after being put to good use for years, worry not. A lot of Yamaha golf cart users have complained of a slight lean in their carts after some years of usage . This is especially true of the Yamaha G16 models.