How do you make a golf ball for a flower?
Use sharpie to draw a circle around the golf ball. This will be the middle golf ball of the flower and the line will help make sure you glue the "petal golf balls" on evenly Use hot glue to attach the petal golf balls on the line of the middle golf ball. Be sure to make them evenly spaced.
How do you cut fake golf balls for plants?
--wire cutters (or scissors. For cutting fake leaf stems) Use sharpie to draw a circle around the golf ball. This will be the middle golf ball of the flower and the line will help make sure you glue the "petal golf balls" on evenly Use hot glue to attach the petal golf balls on the line of the middle golf ball.
How do you paint petal golf balls?
Paint the middle golf ball! Place that brush in the cup of water so the paint doesn't dry on the brush and ruin it. If you are going to use the same brush for the petal golf balls, wash your brush! Once the middle golf ball is dry, paint the petal golf balls.
How do you paint a ladybug on a golf ball?
Paint the golf balls for the ladybugs red. You may need to do this in 2 rounds. One to paint the majority of the golf balls and the second round to paint the part that you couldn't reach before because of the paper plate. Paint a black circle on your golf ball. This will be the ladybugs face.
How to paint a golf ball?
Paint the middle golf ball! Place that brush in the cup of water so the paint doesn't dry on the brush and ruin it. If you are going to use the same brush for the petal golf balls, wash your brush! Once the middle golf ball is dry, paint the petal golf balls.
How to make a bee with wings?
Hot glue the eyes onto your bee.#N#Make a small "U" shaped pipe cleaner in the size you want the wings to be. Make two of these. Make a small bend on each of the ends of both pipe cleaners. This is where we will put the hot glue to attach the pipe cleaners to the bees.#N#Put a dab of hot glue on the bends onto both ends of one of the pipe cleaner.#N#Attach this pipe cleaner to the place you want one of the wings.#N#Next put glue on each ends of the second pipe cleaner.#N#Attach this pipe cleaner to the other side of the bee.#N#Once the wings are firmly attached to the bee you can bend the wings to make them be at any angle!#N#Be sure to not burn yourself please!
Step 2: Connections
cut 2 pieces off of the 2" pipe about 2" long pipe to use to connect the water vavle and the Y to the reducers
Step 3: Fillin' Station
Attach the quick connect to the gas valve. use teflon tape or pipe dope to get a good seal. thread that into one of the reducers and that into the strait end of the Y. thread the preasure gauge into the other reducer and put that into the other branch ot the Y. using one of your 2" pieces attach the Y to one of the 2" to 4" reducers.
Step 4: The Business End
Glue the 2" pipe in one end of the water valve and glue the remaining 2" piece on the other end. on that piece glue the 2" to 4" reducer and then the 4" pipe
Step 5: IT LIVES!!!!!
Glue the two pieces together and then put extra glue on the out side of all your connections just to be sure. be sure to let it dry for a few hours. we shot ours while it was still wet and my friend almost broke his thumb when the end came off.
Step 6: Ready, Fire, Aim
there's really no way to aim so you just gotta point and shoot. MAKE SURE to not shoot it at anyone or any thing that is alive. it will drive a golf ball through a 1/2" of sheet rock. a wash rag is needed to keep a seal around the golfball.
