- Step 1: Line the tip of the flat-end screwdriver with the powered ignition hole.
- Step 2: Insert the screwdriver tip into the ignition.
- Step 3: Wiggle the screwdriver around to make the screwdriver fit into the keyhole.
- Step 4: Turn the screwdriver in the keyhole to turn on the golf cart, as many times as required. This might not work on...
Full Answer
How to start a golf cart with a key?
Insert the key in the cart’s keyhole and turn it to the right to start it. If you notice that the vehicle’s engine is cold, engage the choke knob by pulling it out.
Where does the key switch wire go on a golf cart?
This wire goes from the golf cart key switch assembly to your cart's starter. Visually inspect the solenoid area of the starter, where the key switch wire plugs into the cart. On some cart models, this end of the key switch wire can become dislodged during use on rough terrain.
How do you unlock the ignition switch on a golf cart?
Turn on the power to the ignition before you insert the screwdriver into it. Now insert the tip of the screwdriver into the ignition switch. When you insert a key into most golf cart’s ignition switch, the key engages with the tumblers in the hole and turn it to unlock the switch.
How do you pick the lock on an EZ GO golf cart?
The thing about that is most E-Z-GO, Club Car, and Yamaha golf carts have actual keys that turn tumblers in the keyed ignition switch. That’s why your key has ridges. To defeat that, you’re going to basically pick the lock. You’ll have to wiggle your screwdriver up and down, keeping just a little tension on the switch.
How do you test a golf cart key switch?
Testing a Club Car Ignition SwitchFind the back and red wires on the back of your battery pack.Connect the black wire to the negative terminal and the red to the positive.Keep the cart turned off while you work on it.Check the wires with a probe meter while the cart is off – only one wire should have a charge.More items...
How do you bypass a golf cart key switch?
This process includes these steps:Turn off the ignition switch to minimize your risk of electrocution. ... Locate the wires for your cart's ignition switch. ... Use wire snips to cut these wires away from their connectors. ... Touch the engines together carefully to bypass the ignition switch and send power to your engine.More items...
How do you remove an ezgo ignition switch?
Remove face nut with pliers. The face nut is the round piece that holds the ignition switch in place. Once the face nut is removed, the ignition switch will detach. Hang onto the lock nut for the new ignition switch if a new lock nut is no available.
How can I get my golf cart to work without a key?
Quick Screwdriver Method:Insert the tip of your screwdriver in the ignition switch's slot.Move the screwdriver up and down gently but firmly until you can turn the tool around the same way you would turn a key.This should fire up the cart. ... Another method would be hot-wiring which involves working the wires.
Do golf carts have universal keys?
A key will not work on all golf carts. Instead, they are limited to the vehicles manufactured by that company. For example, if you lost the keys to your E-Z-Go TXT Elite, you would not be able to use a Clubcar cart key. Therefore, in most cases, golf cart keys are universal relative to the manufacturer.
How do I hotwire a golf cart?
InstructionsEnsure that power to the cart is turned on.Locate the two wires connected to the cart's ignition. ... Cut the wires and strip the ends.Touch the ends of the wires together to force the engine to turn over without turning the ignition.Secure the wires together with electrical tape.
How do you check the igniter on a EZ Go golf cart?
Take the voltmeter's black and red probe and place it on the –ve and +ve terminal of the coil. Take the readings. It should be between 3.7-5.2 ohms. If outside the range, the coil should be replaced.
What causes a golf cart not to start?
As the main source of power to your electric golf cart, the batteries are commonly the cause for why your electric golf cart won't start. Acid-based batteries are typically used for electric golf carts and must be recharged in order to work properly.
How do you test a ignition switch?
4:076:01How to test an ignition switch - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd make sure when I ground it out and any other position besides off. So as you can see on doesMoreAnd make sure when I ground it out and any other position besides off. So as you can see on does open that connection back up as well as your starting position.
Are golf carts easy to steal?
If a person with poor intentions gets ahold of an E-Z-GO master key, there will be lots of golf carts they can steal with very little effort. If you don't have a GPS installed on your cart, then you will potentially never see it again. The good news is that you can change your key on your golf cart to a unique key.
Do golf carts use keys?
Golf carts are similar to a small car, and they start by turning a key. If the key is lost or stolen, the golf cart can be started via two different methods.
Are Yamaha golf cart keys universal?
Most Yamaha golf cart keys are universal for gas and electric models. Most of our Yamaha golf cart key switches include the OEM key. A lot of our other keys come in packages of 25 and cannot be broken up.
Why replace the key wire on a golf cart?
Replace the golf cart key switch wire if the connector to the key switch or solenoid is significantly frayed or corroded. Over time, corrosion will build up on the ends of the wire due to exposure to damp weather. Significant corrosion build-up can prevent your cart from starting consistently and ultimately result in the cart failing to start.
What direction does a golf cart transmission selector go?
Confirm that your golf cart transmission selector switch is set fully to the forward, reverse or park direction , depending on your model of golf cart. If the switch is partially set in between modes, it can result in your cart failing to start correctly.
How to get a golf cart moving?
To get the golf cart moving, first disengage the parking brake. Place your feet on the accelerator and apply minimal force. Increase the acceleration gradually as the vehicle begins to move . The wider pedal next to the accelerator is the brake.
What happens if you don't engage the switch on a golf cart?
If you do not engage the switch, your batteries will drain at a faster rate owing to the charge used by the controller. Solution 2: In the event of complete discharge of your batteries, your golf cart charger might not be able to recharge them.
What is the ignition on a golf cart?
The ignition in your golf cart is nothing but a circuit. The switch on the ignition closes the circuit which in turn gets the ignition going. By employing this method, you’re essentially jumping the circuit, hence turning it into a closed connection.
How to start a golf cart in neutral mode?
To start your cart in neutral or maintenance mode, follow these steps: Reach to the backside of the Forward/ Reverse switch of your golf cart. You’ll find a yellow cam with spring on the rear.
How to know if your golf cart is rusting?
If you find rust on the wires, make sure to wear gloves before you wipe the rust off. Once you’re done placing the wires in their correct positions, test drive the cart to check if it runs.
Why does my golf cart stop?
Such uneven and jumpy tracks can mess up your ignition wires and displace them. This can cause your cart to stop in the middle of a run. This is a good place to first look when your golf cart dies suddenly.
Why won't my golf cart start up?
Golf carts that run on gas refuse to start up if you idle them away for long periods. Gas becomes unstable when you store it away for long. Once the last trip of the golf cart before winter is done, mix fuel stabilizer to the gas tank to stabilize the gas while the vehicle idles away.
How many wires should an ignition switch have?
Also, the ignition switch should only have the two wires going to it anyway. If there are three, then don’t use the black one. If there are more than three, then a wiring diagram may help, but trial and error will eventually find the right pair.
Can you use a friend's key on a golf cart?
Use a friend’s key. Maybe your friend is with you and they have a golf cart from the same brand. Whether it’s E-Z-GO, Yamaha, or Club Car golf carts, as long as the brand is the same, the key is usually the same, too. Hopefully, you can just use their golf cart key and not have to worry about it. This is also a fun way to pull a prank, ...
Can you trick a golf cart into starting?
It will eventually become inconvenient having to figure a way to trick your golf cart into starting. Of course, if you’re already going to have to wait for a key, you might as well order a new, key specific ignition switch to make your golf cart more secure.
Can you hot wire a golf cart?
Whether you do this by simply replacing the key, installing a new ignition switch, or any other method, it’s essential that you only hot wire your golf cart for only as long as absolutely necessary, since it causes undue stress on the wires and battery. This can void your warranty and cause other issues down the line.
Is it easier to start a golf cart than a car?
Fortunately, golf carts are a lot easier to start than a traditional car. Whether you have an E-Z-GO, Yamaha, Club Car, or any other type of golf cart, the process is very similar, and this article will walk you through it. The issue with having the right key can come up, especially if you bought a used golf cart and didn’t get a second set of keys.
Can you start a golf cart without a key?
So, you need to start your golf cart without a key. There are two ways to accomplish this, one is really easy, but only works sometimes, and the other is a little complicated, but will work every time without fail if you do it right. Generally speaking, you’re gonna want to start with the first method, and only approach the second if ...
Is an ignition switch a circuit?
Your ignition is a circuit, and the ignition switch is kind of like a light switch that closes that circuit, allowing ignition to take place. By jumping, or bypassing, that switch you’re making an always closed (or hot, hence hot-wired) circuit.
How Do I Replace My Golf Cart Keys?
Replacing your golf cart keys is as simple as going to a dealer to get a new one or order a new set online. All you need is the make, model, and year of your golf cart and you can pick up replacements keys in 24 to 48 hours online or shorter if you visit a dealership near to where you live.
Are Golf Cart Keys Universal?
Golf cart keys are universal by the brand. So EZ-GO golf cart keys are universal for EZ-GO golf carts, some for other brands like Club Car, Evolution and Yamaha.
Club Car Golf Cart Keys
Replacing the keys for your Club golf cart is simple and straightforward. Most of the dealers have these keys on hand as they are universal for most of their models. Finding new keys for this popular golf cart is simply a case of calling your local dealer to arrange pick up.
Yamaha Golf Cart Keys
There are two different variations of golf cart keys when it comes to Yamaha models. One works on the G1, G2, G8, G9, and G11 models, the other works on G14, G16, G19, G22, and G29 carts. Yamaha golf carts are pretty common, and replacement keys are easy to come by.
EZ-GO Golf Cart Keys
EZ-GO golf cart key replacement is possible. The only difference is that carts manufactured after 2008 have a different key than the ones that came out before then. To replace, get in touch with your local dealer or parts shop and pick up a new set of keys with an ignition switch for extra security.
Best Place for Golf Cart Keys Near Me?
Overall, the best place to pick up genuine replacement golf cart keys near me is to purchase from an authorized dealer in your local area. They may advise you to replace the ignition switch as well so that your keys are unique to your cart – this adds an extra layer of security.
Can Lowes or Home Stores Make Golf Cart Keys?
If all other options are exhausted and you need keys made in a pinch, Lowes and Home Depot can make golf cart keys if they have the key mold in stock. All locations have the key cutting equipment, so it just depends on if they have the keys in stock.