Golf-FAQ.com

how to remove governor on electric ezgo golf cart

by Keely Dare Published 3 years ago Updated 2 years ago
image

Using your wrench, remove the bolt on the gas pedal shaft. Slide the shaft up so there is more play in the gas pedal. Tighten the bolt and then start the cart. You may need to adjust the gas pedal shaft a couple of times before you have it to your liking. Removing the Governor From E-Z-Go Carts

Part of a video titled Golf Tips & Etiquette : Where Is a Golf Cart Governor Located?
0:06
1:28
We're going to talk about where is a golf carts governor located. Well a golf carts governor locatedMoreWe're going to talk about where is a golf carts governor located. Well a golf carts governor located is actually down in the motor compartment some of them there's electric ones nowadays.

Full Answer

How do you bypass the governor on an EZGO golf cart?

Step One – Sit down in the driver’s-side seat and look for a plastic plate on the console that is held in place by two small screws – check the size of these screws and the type – almost always a Philips for the Club Car – and use the appropriate screwdriver to remove them from the panel.

Is there a governor on an electric golf cart?

Feb 11, 2022 · Instructions for use in general. Remove the cable from the carburetor and set it aside. There is approximately as much cable as there is between two straws. Follow the cable that has been disconnected all the way up to the governor. Make a connection between the gas pedal cable and the governor, and then route it to the carburetor.

How do you remove the governor on a golf cart?

Jan 07, 2022 · Remove the screws that hold the governor’s cover in place. There are three screws in total – two Phillips head screws and one flathead screw. Use the wire cutters to cut the zip tie that holds the wires to the governor. Remove the screws that hold the governor to the battery pack. You Can Now Put a New Governor on or Remove One from Your ...

Can you adjust the governor on an EZ GO spark plug?

Jun 14, 2020 · Subsequently, one may also ask, how do you take the governor off a Yamaha electric golf cart? Difficulty: Moderately Easy. Find the small cable that runs from the carburetor to the governor. Remove the cable from the carburetor. Follow the cable from the carburetor to the governor. The governor sits on the top middle of the engine.

image

How do I take the governor off my EZ Go golf cart?

General Instructions
  1. Detach the cable from the carburetor. The cable is about the width of a straw. ...
  2. Follow the disconnected cable up to the governor. ...
  3. Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ...
  4. Using your wrench, remove the bolt on the gas pedal shaft.

Do ezgo electric golf carts have a governor?

Considering electric golf carts don't have governors like gas powered carts, the old-school method of simply removing the governor is not an option.

How can I make my electric EZ Go golf cart faster?

6 Ways You Can Make a Golf Cart Faster
  1. Add More Torque to Your Golf Cart.
  2. Upgrade Your Golf Cart's Motor.
  3. Improve the High-Speed Controller of the Cart.
  4. Add Better Golf Cart Tires.
  5. Use a Higher Powered Golf Cart Battery.
  6. Watch the Weight in Your Golf Cart.
May 18, 2021

Is there a speed governor on an electric golf cart?

Basically, an electric speed governor can be controlled by a tiny metal rod that's located by the clutch of your golf cart. First things first: The electric speed governor is connected to a cable. You can adjust your speed by rotating the nut in a counterclockwise rotation.Aug 29, 2019

How can I make my golf cart governor faster?

If you find this rod, then your governor can be easily adjusted by accessing the cart's inner workings. Simply adjust the cable coming from this metal protrusion, turning the nut counterclockwise to make the cable longer, effectively adjusting the cart's governance to increase the overall speed.

How do you adjust the governor on a EZ GO TXT gas golf cart?

How to Adjust the Governor on a Gas E-Z-Go Golf Cart
  1. Locate the governor arm mounted on top of the rear axle case underneath the cart. ...
  2. Loosen the adjusting locknut on the end of the governor spring. ...
  3. Retighten the adjusting locknut.

How do you speed up a 36 volt EZ Go golf cart?

How to Make a 36 Volt Golf Cart Faster
  1. Remove any unnecessary additions, racks or parts on your golf cart. ...
  2. Power-wash your cart. ...
  3. Check the shaft under the ignition pedal. ...
  4. Put larger tires on the cart. ...
  5. Replace any old or worn-out parts that are causing the cart to move slower than it should.

How do I speed up my EZ Go TXT?

One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.Jun 16, 2015

Is 30 mph fast for a golf cart?

Depending on how far you want to go on a full charge, you might want a 40mph or a 30mph golf cart. At top speed, most golf carts do around 14mph. However, with the advent of street legal golf carts and modifications, it is possible to go 35mph and above.Oct 4, 2021

How Does a Golf Cart Governor Work

Governors play an important role in electric golf carts by limiting the speed they can travel. This is an important safety feature, as it prevents the cart from going too fast and helps ensure passengers’ safety.

How to Take the Governor off a Golf Cart

Removing the governor from a golf cart is a simple process that can be done with common tools. Here’s what you’ll need:

Frequently Asked Questions about Golf Cart Speed Governors

If you’re looking for ways to speed up your golf cart, there are a few things you can do. Start by removing the governor on top of the engine if you haven’t already. If it doesn’t have a governor, then you’ll need to open up the cart and look at the gear shaft to see if it’s turning.

How to find the governor on a golf cart?

Locate the golf cart's governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor. Use a screwdriver—or in some cases a wrench—to loosen the tension on the governor's springs.

Where is the governor on a carburetor?

Follow the cable from the carburetor to the governor. The governor sits on the top middle of the engine.

Can you increase the speed of a gas golf cart?

For a gas-powered cart, a minor speed adjustment may be made with a simple modification of the speed governor. If more speed enhancement is needed, a more powerful engine can be installed.

Is there a governor on an electric golf cart?

The bad news is there is no governor on an electric golf cart, but the good news is there are several options to quench your need for speed. Click to see full answer.

How fast can a golf cart go without a speed control?

A typical electric cart without an upgraded speed control tops out around 12 mph. If you go this route, anticipate an upgrade cost around $700.

What is the maintenance on a golf cart?

This includes battery and wiring inspections, refilling battery water, washing the cart, and anything else mentioned in your specific manufacturer owner’s guide.

How to make a cart faster?

Step 1. The first option to making your cart faster is to replace the electronic speed control. This will enable more voltage to pass to the motor, producing the desired result. Unfortunately, this upgrade is not inexpensive as the unit can run anywhere from $100 to $1,000. Step 2.

How much does it cost to replace a cart motor?

This is probably the most extreme measure you can take to remedy your speed issue, and you can expect this to cost around $1,000 with labor.

Can you own a golf cart?

Owning your own personal golf cart certainly has its advantages, especially if you live in a cart-friendly community or belong to a private country club. As time goes on, the number of electric golf carts replacing gas carts continues to grow. One thing that electric cart owners find themselves wondering, however, is how do you make an electric golf cart faster?

Can you drive a golf cart faster?

It should be noted that the golf cart you are trying to make faster may not be designed to do so. Weigh the options carefully and exercise caution whenever driving a golf cart at any speed. Remember that golf carts are not equipped with seat belts, air bags and other safety equipment that you find in automobiles.

How to remove governor from golf cart?

How to Remove the Governor From a Golf Cart. You hit the links. The course is open in front of you as far as the eye can see. The only thing holding you back is the put-put-puttering of your golf cart. Golf carts are governed to go anywhere from 12 to 14 miles per hour. But if you've got a few minutes, some simple mechanical know-how and a wrench, ...

How to remove carburetor cable?

The cable is about the width of a straw. It should come off with a pull, but keep a phillips head and regular screwdriver on hand , just in case.

How fast can a golf cart go?

Golf carts are governed to go anywhere from 12 to 14 miles per hour. But if you've got a few minutes, some simple mechanical know-how and a wrench, you can double the speed of your cart and zip through your round.

How to adjust a gas pedal on a cart?

Using your wrench, remove the bolt on the gas pedal shaft. Slide the shaft up so there is more play in the gas pedal. Tighten the bolt and then start the cart. You may need to adjust the gas pedal shaft a couple of times before you have it to your liking.

Can you tamper with a golf cart?

We do not condone tampering with a golf cart that belongs to a golf course. However, if you own your own gas golf cart or a friend allows you to remove the governor from their cart, have at it.

How to adjust EZ Go cart governor?

To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.

How to remove the black plastic cover on a golf cart?

Remove the screws from the black plastic cover at the rear of the seat. There should be five screws in most models. The engine is in the front of golf carts , underneath this panel. Take off the plastic cover and set it aside with the seats.

How to make a golf cart go faster?

Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.

How to get a cart to move faster?

1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.

How to tell if a gas pedal is a governor?

Follow the thickest cable coming from the gas pedal until your find a small spring wrapped around a metal rod. This is the governor. The spring apparatus will have two nuts, one small nut and one larger nut, holding it onto the rod.

How fast can a golf cart go?

Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.

How to change the speed of a car?

Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9