How do I take the hub off my EZ Go golf cart?
0:202:18How To Quickly Replace A Stripped Golf Cart Hub - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo what you're going to want to do is you want to remove the cotter pin this case I used use pryMoreSo what you're going to want to do is you want to remove the cotter pin this case I used use pry some pliers. And a flat tip screwdriver. And you're going to loosen the castle.
How do you remove an axle shaft on a EZ Go golf cart?
1:592:59How to Remove an E-Z-GO TXT Front and Rear Axle - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe first step is to remove the rear pin from the brake cable once this is done remove the c-clipMoreThe first step is to remove the rear pin from the brake cable once this is done remove the c-clip and slide the brake cable from the assembly.
How do you grease a golf cart wheel bearing?
0:307:15How To Grease Wheel Bearings - 2 Easy Methods - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd just put some grease in the palm of your non-dominant. Hand now take the bearing and you'reMoreAnd just put some grease in the palm of your non-dominant. Hand now take the bearing and you're gonna press it in. So when you get these wheel bearings you need to grease these.
How do you take apart a wheel bearing?
1:238:51Wheel Bearing Removal Trick - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe'll get the classic pointed. Bit. There she goes pop that on there. Grab yourself a half inch boltMoreWe'll get the classic pointed. Bit. There she goes pop that on there. Grab yourself a half inch bolt from your bolt bend. And nuts.
Why do golf carts wobble?
Check whether the tire is properly seated and also check for proper wheel alignment. Sometimes if the wheel alignment is not proper, it could make the cart wobble. The lug nuts and hubs in the wheel could also cause this problem. If one of the hubs is missing or bent at an odd angle, the cart could wobble.
How much does it cost to replace a rear axle?
The rear axle is usually more expensive to repair or replace. It can cost anywhere from $450 to over $1,000 for the rear axle, but most people pay between $600 – $900.
How do you change a wheel bearing on a golf cart?
5:0511:47How to replace a golf cart wheel axle bearing. Yamaha G29 - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd then your bearing will press off this way and then you press on the new one that way and this isMoreAnd then your bearing will press off this way and then you press on the new one that way and this is what it looks like. And that's it that's with the new bearing.
Where are the grease fittings on EZ Go golf cart?
Grease fittings are located on the front and rear of the golf cart, near each wheel bearing.
Do sealed bearings need grease?
FOR STARTERS, note that most sealed bearings come pre-greased from the factory with a 25%-35% grease fill. This is all the grease the bearings will ever need, because the relubrication interval (explained below) is longer than the expected life of the bearing.
How do you get a bearing out without a puller?
1:533:08How to easily remove a tight bearing without a press or special toolYouTubeStart of suggested clipEnd of suggested clipWhen I put it in the oven. And I poured a well on the the pinion nut and the bearing. So that shrunkMoreWhen I put it in the oven. And I poured a well on the the pinion nut and the bearing. So that shrunk it just enough so that there was enough clearance to knock it out easily.
How do you remove a wheel bearing without a tool?
4:5810:14How to replace a pressed in wheel bearing without a press. - YouTubeYouTubeStart of suggested clipEnd of suggested clipOff of the ball joint made sure that this wheel speed sensor was disconnected. And i just put itMoreOff of the ball joint made sure that this wheel speed sensor was disconnected. And i just put it here so what i'm gonna have to do now is put it on two blocks.
What tools do I need to remove a wheel bearing?
What Tools Do I Need To Replace A Wheel Bearing?A set of needle-nosed pliers.ratchet wrench with various sized sockets.flat-head screwdriver.jack.star wrench for loosening nuts on the wheel.