how to restore grooves in golf clubs

by Ray Gutmann Published 3 years ago Updated 2 years ago

Part of a video titled how to use your 6-head Groove Sharpener - YouTube

1:56

5:13

But you can use whatever you have to hand if you've got a bike shirt or something a bit of bike oilMoreBut you can use whatever you have to hand if you've got a bike shirt or something a bit of bike oil will do the job.

How to clean golf clubs that have grooves?

Golf Club Groove Repair Step 1. Clean the face of your clubs, including the grooves. Use warm, soapy water with a couple of tablespoons of... Step 2. Run masking tape along the ends of your grooves. This will keep your groove sharpener from damaging the face of... Step 3. Draw the groove sharpener ...

Should you buy new or re-Groove your golf clubs?

Most forged iron clubs made of mild steel, will need to be protected from rusting, which requires a layer of chrome to be deposited on the head after the grooves have been milled, rolled or stamped into the face. Some clubs are forged but made of stainless steel, which do not require chrome plating. These, as with most cast clubs can be re-grooved and do not need the additional …

How important are the grooves on a golf club?

How Often to Re-Groove. It is strongly suggested that you have your irons thoroughly cleaned and re-grooved every 3 – 4 years depending upon how much you play. Club faces should be cleaned and grinded to smooth out irregularities, remove rust, and eliminate the majority of scratches/dings prior to re-grooving.

How to sharpen a golf club?

May 03, 2020 · First, dunk a club in the water, then use the wet half of the rag to wipe the hosel, face and back. Dunk it again and fashion the brush to …

Is it legal to sharpen grooves?

The rules of golf state that grooves must be no more than 0.035 inches wide, 0.020 inches deep and 0.075 inches from any adjacent grooves. If you play competitively, using a groove sharpener could make your clubs non-conforming and illegal for competition.Mar 12, 2013

Can you fix grooves golf club?

There are few alternatives to groove sharpening. If the grooves of your club are significantly worn, and you don't wish to refurbish them with a sharpening tool, then the only real option left is to buy new clubs. It may be worth attempting groove sharpening first before making such a purchase.Jan 15, 2021

Can you restore wedge grooves?

What Is A Golf Club Groove Sharpener? It is a small tool that you stick into your wedges' grooves to “sharpen” and restore iron or wedge faces to their original integrity.Nov 18, 2020

How do you renew grooves in golf clubs?

Hold the groove sharpener like a pencil at a 45-degree angle to the face and draw it through the first groove. You don't want to use much force at first. Do the 45-degree angle approximately five times, or until you begin to see the surface of the groove begin to take on its original shine.Jun 23, 2014

Should I sharpen my iron grooves?

Your New Golf Club Groove Sharpener

The grooves on your golf club are vital to both backspin and ball control on the golf course. Sharpening the grooves may be something that you have never considered doing before - but worn down grooves will not give you the control or backspin you're looking for.

How do you clean grooves in golf irons?

Snag a club-cleaning brush. Wet half a rag in the bucket and leave the other half dry. First, dunk a club in the water, then use the wet half of the rag to wipe the hosel, face and back. Dunk it again and fashion the brush to clean out the grooves, periodically toweling to wipe away excess dirt.May 3, 2020

Why are square grooves illegal?

Square grooves were briefly banned from the PGA tour, due solely to a PGA rule that had nothing to do with the legality of the clubs themselves. Depending on which study you believe, square grooves provide no competitive advantage, or they provide slightly higher spin rates from the rough.

Do I have V or U grooves?

The deeper, sharper grooves are called "U" grooves. "V" grooves are the opposite. They are much shallower and have rounder edges. The "U" groove can move much more debris away from the contact zone.Oct 5, 2017

How long do grooves last on wedges?

You should inspect your wedges for groove wear every 60-70 rounds. Start by inspecting the overall physical condition of the wedge and groove. A visit to your local Titleist Certified Fitter to evaluate launch, spin, and roll out will ensure you are playing with the best performing wedges.Sep 6, 2019

How often should you Regroove your golf clubs?

We would recommend at least every 3-4 years. You should have your clubs cleaned and regrooved to allow you to play your best golf game.

How do you clean and sharpen golf club grooves?

0:57

5:13

Just a little bit of electrical tape so that if I slip when sharpening I went oh it's scratch theMoreJust a little bit of electrical tape so that if I slip when sharpening I went oh it's scratch the club on Julie. And then I'm going to apply a little bit of lubricant I'm using wd-40.

Can you Regroove golf irons?

Getting the wedge regrooved is an option, but it's an inexact process that's probably not worth the time. "A lot of things can happen when you regroove an old wedge," said Kyle Cronkright, the director of club fitting at the Jim McClean Golf School's Texas Golf Center (Ft. Worth) facility.Feb 28, 2015

How to clean rust off golf clubs?

A quick soak can easily loosen surface rust and allow your club to be cleaned using a brush.

Can steel wool be used on golf clubs?

Steel wool and wire brushes can be helpful in removing surface rust. However, used improperly these products can damage the surface of a golf club. Be sure to use a wire brush made of a material less strong than the material of your club. Likewise, starting off with ultra-fine steel wool will ensure you do not scratch or damage your clubs.

What is pitting corrosion?

Pitting Corrosion. Often, surface rust can lead to further corrosion. The most damaging is called pitting corrosion. This is localized corrosion that results in holes or divets in the metal surface. While it is possible to remove the rust from the surface of these divets, it is very difficult to repair them.

Does Coca Cola rust?

Coca-Cola has the ability to dissolve rust, but can also damage the club if left exposed for long periods of time. It is best to soak the club in Coca-Cola for only a few minutes at a time. Again, use a small brush to scrape clean the rust.

Re-Grooving is a Natural Add-On When Getting Your Club Faces Resurfaced, Buffed, and Polished

Club Grooves are “Lines” that are cut, pressed, or cast into the golf club face. Grooves appear on woods, hybrids, and irons. They are designed to impart backspin by grabbing the surface of the golf ball on contact.

Re-Grooving Can Help

Have you noticed that the face and grooves on your irons are getting seriously worn down? Should you re-groove or replace them? If you really like the look and feel of the irons – then it’s worth getting it done. In many cases, re-grooving probably can do as much good as buying new clubs.

The Purpose of Re-Grooving

The purpose of golf club re-grooving is to redefine the edges by removing bent over metal as they get worn and beat up during play. Restoring and re-grooving your grooves will help your short game to generate more spin and control. Deeper and sharper grooves provide more spin, and subsequently more control.

How Often to Re-Groove

It is strongly suggested that you have your irons thoroughly cleaned and re-grooved every 3 – 4 years depending upon how much you play. Club faces should be cleaned and grinded to smooth out irregularities, remove rust, and eliminate the majority of scratches/dings prior to re-grooving.

Who is Luke Kerr-Dineen?

Luke Kerr-Dineen is the Game Improvement Editor at GOLF Magazine and GOLF .com. In his role he oversees all the brand’s service journalism spanning instruction, equipment, health and fitness, across all of GOLF’s multimedia platforms.

Who is Luke Kerr?

Luke Kerr-Dineen. Luke Kerr-Dineen is the Game Improvement Editor at GOLF Magazine and GOLF.com. In his role he oversees all the brand’s service journalism spanning instruction, equipment, health and fitness, across all of GOLF’s multimedia platforms.

Who is Jonathan Wall?

Jonathan Wall is GOLF Magazine and GOLF.com’s Managing Editor for Equipment. Prior to joining the staff at the end of 2018, he spent 6 years covering equipment for the PGA Tour.

Golf-FAQ.com