Open the seat of your cart to access the engine underneath. Push the governor toward the carburetor to remove this speed restriction. The governor is a T-shaped metal rod that you will find fastened with a rubber band or duct tape toward the cylinders of the carburetor.
Full Answer
How can I speed up my Yamaha gas golf cart?
You can speed up your Yamaha gas golf cart with a number of simple tweaks. Power clean your cart using a hose, water and soap. Be sure to remove any excess dirt and grime from the wheels and wheel wells to allow your cart to operate at its most efficient. Remove any unnecessary accessories from the cart to lighten the cart's weight.
Why won't my Yamaha golf cart start?
Yamaha carts run on electricity generated by an acid-based rechargeable battery and most problems can be traced to this source. If your cart is sluggish or won't start, the battery may need to be charged. If it is charged, but still not working properly, make sure the battery terminal connections are clean and secure.
What kind of engine does a Yamaha golf cart have?
Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard. link to How Does A Golf Cart Work? - Complete Guide To Understanding It (2021)
Why should I learn to troubleshoot my Yamaha cart?
Learning to troubleshoot your cart will help you recognize any potential problems before they become serious issues or safety hazards. Yamaha carts run on electricity generated by an acid-based rechargeable battery and most problems can be traced to this source.
How do I make my Yamaha golf cart idle?
0:523:44How to get your club car to idle - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe black wires gonna be on the bottom half down here you can't see it but just disconnect it onceMoreThe black wires gonna be on the bottom half down here you can't see it but just disconnect it once you disconnect that you're gonna have to get your flat-head screwdriver and turn up the idle.
How do you keep a Yamaha gas golf cart running?
Yamaha G9 golf cart won't stay runningCheck for dirt or dust accumulation in the air filter and if so, clean it. ... Inspect the airbox and check if it has come off loose. ... Check for cracks or leaks in the plastic carb spacer. ... Make sure that the gas is not adulterated with ethanol or water and doesn't have condensation.
How do you bypass the ignition switch on a electric golf cart?
This process includes these steps:Turn off the ignition switch to minimize your risk of electrocution. ... Locate the wires for your cart's ignition switch. ... Use wire snips to cut these wires away from their connectors. ... Touch the engines together carefully to bypass the ignition switch and send power to your engine.More items...
What happens if you push a golf cart in run mode?
First of all, leaving your cart in run mode during storage will cause your battery to slowly drain, as your cart's computer and its regenerative braking system will be active, causing a slow drain that will leave your battery dead after a long-term storage situation.
How does a gas golf cart start and stop?
In a gasoline-powered golf cart, the engine starts when you step on the gas pedal, and it shuts off when you take your foot off the gas. That feature helps save gas, cuts down on emissions and helps keep the course quiet, too.
How do you make a Yamaha gas golf cart go faster?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How do you hotwire a Yamaha golf cart?
InstructionsEnsure that power to the cart is turned on.Locate the two wires connected to the cart's ignition. ... Cut the wires and strip the ends.Touch the ends of the wires together to force the engine to turn over without turning the ignition.Secure the wires together with electrical tape.
Can you start a golf cart with a screwdriver?
Quick Screwdriver Method: Insert the tip of your screwdriver in the ignition switch's slot. Move the screwdriver up and down gently but firmly until you can turn the tool around the same way you would turn a key. This should fire up the cart.
What happens when golf cart solenoid goes bad?
What Happens To Your Golf Cart When The Solenoid Goes Bad? The large contacts in a gas golf cart may refuse to release, causing the starter to run even after turning off the ignition.
What is the tow run switch on Yamaha golf cart?
TOW / RUN switches are basically kill switches designed to disable the golf cart. there are several reasons for this switch. Usually, a TOW / RUN switch is only used on electric golf carts, specifically those with a separately excited electrical system with regenerative braking.
Where is the tow run switch on a Yamaha golf cart?
The tow run switches are typically found inside the battery compartment of the cart in plain sight.
Can you push a golf cart in neutral?
Golf cart models that are equipped without a handle-style brake have an unlock procedure that is listed on the bottom of the controller cover. Or try to use the Tow-Run switch in tow, then key in neutral. If the batteries are completely dead, then removing the brake is the only option.
How does a gas golf cart work?
0:081:16How Does a Golf Cart Work? - YouTubeYouTubeStart of suggested clipEnd of suggested clipFour wheels on the cart gas feed brake emergency brake on and off switch just like with the keyMoreFour wheels on the cart gas feed brake emergency brake on and off switch just like with the key reverse and forward buttons. So literally. You drive it just as you would drive an automobile.
Where is the solenoid located on a Yamaha golf cart?
0:095:38Replace Solenoid in Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipCart um your solenoid could be located in a bunch of different places but almost always underneathMoreCart um your solenoid could be located in a bunch of different places but almost always underneath the seat.
Why won't my gas golf cart shut off?
Troubleshooting. Switch the car to neutral before turning the key off. The problem with shut down may have occurred from the kill circuit, which is controlled by the top microswitch. You may have to replace the microswitches or solve the problem by tightening up the circuit.
Why My Yamaha Golf Cart Solenoid Clicks but Won’t Move?
The main cause of a Yamaha golf cart clicking but not moving, is a faulty controller or solenoid.
Why is my G29 not moving?
Some experts think that faulty batteries are the main reason for G29 Yamaha golf carts not moving when started. With the batteries, there can be multiple issues. Keeping them charged to the full is important.
Why is my solenoid not clicking?
The reason why the solenoid is not clicking could be that it is faulty or has no grounding. Experts recommend checking all wiring and cable connections to rule out this possibility. Batteries on your G16 Yamaha golf carts should raise sufficient power to reach the solenoid and the starter/generator.
Why is my Yamaha golf cart not clicking?
Check the controller if you find that your Yamaha golf cart’s solenoid is not clicking after you have installed a new set of batteries. This can happen and you must first check the controller.
How to check solenoid on a G9 golf cart?
The solenoid can be checked using an old screwdriver to jump the terminals. Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced. You must be careful while doing this crude test; there could be sparks when the two terminals touch.
What is a Project X HZRDUS shaft?
What is the Project X HZRDUS Black Fairway Wood shaft? Project X HZRDUS Black Fairway Wood shaft is a low spin golf shaft design. It comes with enhanced firmness over the entire length of the shaft....
What does absence of spin mean on Yamaha golf cart?
The absence of a spin in this test could mean your Yamaha golf cart’s battery pack is failing.
Why won’t your Yamaha golf cart shut off?
The reason why a Yamaha golf cart does not shut off can be because of loose wires or a faulty voltage regulator.
How do you fix a Yamaha golf cart that keeps running?
It’s usually loose wiring, a sticking accelerator stop switch, a sticking solenoid or issues with the engine stop relay or the voltage regulator.
Why is my gold cart sticking?
There’s probably a sticking solenoid problem with your gold cart if there’s a noticeable lag between when you push the pedal and when your cart starts to crank. You can check and test for this problem using a voltmeter or test light. If you have a faulty solenoid, you need to replace it.
How to check if a Yamaha G9 has a sticky accelerator stop switch?
How to check if your Yamaha G9 golf cart has a sticky accelerator stop switch. Remove the floor mats from your Yamaha G9 golf cart. Take out the exposed floor plate and then unplug the stop switch. Next, open the wiring harness clip.
Why does my Yamaha G16 keep running?
Your Yamaha G16 golf cart can keeps running because of a accelerator switch that keeps sticking.
How to check if a G9 golf cart has a sticky solenoid?
How to check if your Yamaha G9 golf cart has a sticky solenoid. Unplug all the cables from the two large terminals. Wrap the cable ends in electrical tape and make sure to keep them separated. Put the cart direction switch in the neutral position with the key off.
How to tell if a cart has a sticking solenoid?
Go and check if there’s any lag between the time you push the pedal in and the time the cart starts to crank. If there’s any lag, you might have a sticking solenoid.
How to remove spark plug from engine?
Locate the spark plug (s) on the top of the engine and remove the cable, exposing the top of the plug. Use a spark plug socket (13/16″) and ratchet to remove the spark plug and inspect the ceramic insulator.
What is an air filter?
The air filter is cylindrical with a foam prefilter sleeve that fits over the paper element. The air filter element is oil-impregnated, and attempting to use an air hose to blow out the impurities will result in reducing the oil. This makes the filter less efficient and should be avoided. The foam cover should capture the majority ...
How to remove fuel filter from car?
The fuel tank is located on the driver’s side of the vehicle and the filter can be removed with a pair of pliers. Squeeze the spring clip and slide it further up the rubber fuel line, then pull the filter free. Note the direction of flow to prevent installing the filter backward.
How to extend the life of a paper element?
By periodically washing out the foam element cover , the life of the paper element can be extended significantly. Clean it with a solvent or dishwashing soap and squeeze out the excess. Do not apply oil to this pre-filter…it will increase the air resistance and choke out the engine.
How many times can a Yamaha engine be rebuilt?
Yamaha engines are durable and because of the simple design, they can be successfully rebuilt 3 or 4 times . Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard.
How to remove gas filler hatch?
Put the vehicle in neutral and open the seat cowling pulling up on the lever in the gas filler hatch. Remove the 5 screws from the front and rear of the cowling and lift out.
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
How to remove speed restriction on a golf cart?
Open the seat of your cart to access the engine underneath. Push the governor toward the carburetor to remove this speed restriction. The governor is a T-shaped metal rod that you will find fastened with a rubber band or duct tape toward the cylinders of the carburetor.
How to speed up a Yamaha golf cart?
You can speed up your Yamaha gas golf cart with a number of simple tweaks. Power clean your cart using a hose, water and soap. Be sure to remove any excess dirt and grime from the wheels and wheel wells to allow your cart to operate at its most efficient. Remove any unnecessary accessories from the cart to lighten the cart's weight.
How fast can a Yamaha golf cart go?
While these vehicles are often restricted to around 10 to 15 miles per hour by factory standards and settings, you can speed up your cart in a variety of ways to have it moving as fast as 20 to 25 miles per hour.
Where is Matthew Fortuna?
Matthew Fortuna is a full-time freelance writer with a journalism degree from Wayne State University, living in the Detroit metropolitan area. He has written about a wide range of topics across varying publications, including Demand Studios, wiseGEEK.com and Suite101.com, among others.
Why is my golf cart not clicking?
This insulated wire channels the electric current from the battery that powers the cart. If you press on the cart's accelerator and do not hear a clicking sound, the solenoid wires may need tightening.
What does a Yamaha cart run on?
Yamaha carts run on electricity generated by an acid-based rechargeable battery and most problems can be traced to this source. If your cart is sluggish or won't start, the battery may need to be charged. If it is charged, but still not working properly, make sure the battery terminal connections are clean and secure.
Do Yamaha golf carts need maintenance?
Yamaha golf carts, like any other machine, will occasionally require troubleshooting and maintenance to ensure that they are functioning properly. Learning to troubleshoot your cart will help you recognize any potential problems before they become serious issues or safety hazards.