Open the seat of your cart to access the engine underneath. Push the governor toward the carburetor to remove this speed restriction. The governor is a T-shaped metal rod that you will find fastened with a rubber band or duct tape toward the cylinders of the carburetor.
Full Answer
How to fix my Yamaha golf cart that won’t turn off?
Also check the connection of the black and blue wires at the front of your cart’s engine. If you find that the wires are just disconnected, you only need to reconnect them to get your golf cart to shut off properly. Your Yamaha golf cart has a sticking accelerator switch.
How can I speed up my Yamaha gas golf cart?
You can speed up your Yamaha gas golf cart with a number of simple tweaks. Power clean your cart using a hose, water and soap. Be sure to remove any excess dirt and grime from the wheels and wheel wells to allow your cart to operate at its most efficient. Remove any unnecessary accessories from the cart to lighten the cart's weight.
How do you start a golf cart without driving it?
Your golf cart’s motor can be warmed up and kept ready-to-run without having to drive it. To start your cart in neutral or maintenance mode, follow these steps: Reach to the backside of the Forward/ Reverse switch of your golf cart. You’ll find a yellow cam with spring on the rear. Pull the cam out and rotate it to 180 degrees.
Why does my Yamaha G16 golf cart keep running?
You might have loose wiring in the engine of your Yamaha G16 golf cart if it keeps running. You can check by following the following steps.
How do I make my Yamaha golf cart idle?
0:523:44How to get your club car to idle - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe black wires gonna be on the bottom half down here you can't see it but just disconnect it onceMoreThe black wires gonna be on the bottom half down here you can't see it but just disconnect it once you disconnect that you're gonna have to get your flat-head screwdriver and turn up the idle.
How do you keep a Yamaha golf cart running?
Yamaha G16 golf cart won't stay runningCheck for a malfunctioning fuel line, fuel pump, or pickup tube in the carburetor, or if there is a problem with the gas tank. ... Check the battery posts and cables. ... Check the brushes on the stator. ... Check the fuel compression when the cart is in forward, reverse, and neutral modes.
How do you bypass a golf cart ignition?
This process includes these steps:Turn off the ignition switch to minimize your risk of electrocution. ... Locate the wires for your cart's ignition switch. ... Use wire snips to cut these wires away from their connectors. ... Touch the engines together carefully to bypass the ignition switch and send power to your engine.More items...
How do you bypass the electric solenoid on a golf cart?
To bypass the solenoid of your golf cart, simply connect both the large side wires of terminals of the solenoid. And after making the connection, attempt to start the cart. If you fail to start, this is an indication that there is no problem with your solenoid.
How do you take the governor off a Yamaha golf cart?
General InstructionsDetach the cable from the carburetor. The cable is about the width of a straw. ... Follow the disconnected cable up to the governor. ... Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ... Using your wrench, remove the bolt on the gas pedal shaft.
How do you adjust the governor on a Yamaha golf cart?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How do you hotwire a Yamaha golf cart?
InstructionsEnsure that power to the cart is turned on.Locate the two wires connected to the cart's ignition. ... Cut the wires and strip the ends.Touch the ends of the wires together to force the engine to turn over without turning the ignition.Secure the wires together with electrical tape.
How do you start a golf cart with a screwdriver?
Insert the tip of your screwdriver in the ignition switch's slot. Move the screwdriver up and down gently but firmly until you can turn the tool around the same way you would turn a key. This should fire up the cart.
Are Yamaha golf cart keys universal?
Most Yamaha golf cart keys are universal for gas and electric models. Most of our Yamaha golf cart key switches include the OEM key. A lot of our other keys come in packages of 25 and cannot be broken up.
How do you bypass a solenoid?
5:037:29Solenoid Bypass - YouTubeYouTubeStart of suggested clipEnd of suggested clipAll you have to do to bypass the solenoid. And make the starter turn is basically connect this hardMoreAll you have to do to bypass the solenoid. And make the starter turn is basically connect this hard copper wire to this point on the battery. Then you're not doing anything with the solenoid.
How do you jump a solenoid?
0:271:17How to Jump the Solenoid on your ATV or GoKart - YouTubeYouTubeStart of suggested clipEnd of suggested clipWhat we have to do is we have to move the coverings over the two bolts. This is black is negativeMoreWhat we have to do is we have to move the coverings over the two bolts. This is black is negative red is positive.
Where is the solenoid located on a Yamaha golf cart?
0:095:38Replace Solenoid in Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipCart um your solenoid could be located in a bunch of different places but almost always underneathMoreCart um your solenoid could be located in a bunch of different places but almost always underneath the seat.
What causes a golf cart to keep running?
Yamaha golf carts can keep running and not stop for many reasons. It's usually loose wiring, a sticking accelerator stop switch, a sticking solenoid or issues with the engine stop relay or the voltage regulator.
How do you make soup in a gas golf cart?
How to Make Your Gas-Powdered Golf Cart Faster [Updated, 2022]1 Use A Better Golf Cart Battery.2 Increase Torque.3 Upgrade the Golf Cart Motor.4 Install a Torque Converter.5 Install a Higher-Performance Clutch.6 Tweak The Governor.7 Install A Cold Air Intake.8 Get Bigger Golf Cart Tires.More items...•
Why does my Yamaha Golf Cart go slow?
The main reason why a Yamaha golf cart runs slow is because of low battery charge, dirty battery terminals, or a loose spark plug. A Yamaha golf carts slow speed can be traced to other reasons as well: A battery with a low charge.
How do you adjust the carburetor on a Yamaha golf cart?
How to Adjust Yamaha Golf Cart CarburetorPull out the pilot adjustment screw. ... Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
How to get a golf cart moving?
To get the golf cart moving, first disengage the parking brake. Place your feet on the accelerator and apply minimal force. Increase the acceleration gradually as the vehicle begins to move . The wider pedal next to the accelerator is the brake.
How fast can a golf cart go?
Although golf carts don’t usually go too fast (up to 35 MPH, it’s advised you put on the seatbelt if the vehicle comes with one. Golf carts, like most vehicles, are operated using a key. Insert the key in the cart’s keyhole and turn it to the right to start it.
How to know if your golf cart is rusting?
If you find rust on the wires, make sure to wear gloves before you wipe the rust off. Once you’re done placing the wires in their correct positions, test drive the cart to check if it runs.
What happens if you don't engage the switch on a golf cart?
If you do not engage the switch, your batteries will drain at a faster rate owing to the charge used by the controller. Solution 2: In the event of complete discharge of your batteries, your golf cart charger might not be able to recharge them.
Why does my golf cart stop?
Such uneven and jumpy tracks can mess up your ignition wires and displace them. This can cause your cart to stop in the middle of a run. This is a good place to first look when your golf cart dies suddenly.
Why won't my golf cart start up?
Golf carts that run on gas refuse to start up if you idle them away for long periods. Gas becomes unstable when you store it away for long. Once the last trip of the golf cart before winter is done, mix fuel stabilizer to the gas tank to stabilize the gas while the vehicle idles away.
What is worse than hopping on a golf cart on a Sunday morning?
Nothing is worse than hopping on your golf cart on a Sunday morning all excited for a round of golf, only to find your golf cart not starting! If you’re a golf cart owner, there will come a point where you find you and your cart stuck on the golf course. There will come a day where you lose your golf cart key; yet still want to start your golf cart.
How do you fix a Yamaha golf cart that keeps running?
It’s usually loose wiring, a sticking accelerator stop switch, a sticking solenoid or issues with the engine stop relay or the voltage regulator.
Why won’t your Yamaha golf cart shut off?
The reason why a Yamaha golf cart does not shut off can be because of loose wires or a faulty voltage regulator.
Why is my gold cart sticking?
There’s probably a sticking solenoid problem with your gold cart if there’s a noticeable lag between when you push the pedal and when your cart starts to crank. You can check and test for this problem using a voltmeter or test light. If you have a faulty solenoid, you need to replace it.
How to check if a Yamaha G9 has a sticky accelerator stop switch?
How to check if your Yamaha G9 golf cart has a sticky accelerator stop switch. Remove the floor mats from your Yamaha G9 golf cart. Take out the exposed floor plate and then unplug the stop switch. Next, open the wiring harness clip.
Why does my Yamaha G16 keep running?
Your Yamaha G16 golf cart can keeps running because of a accelerator switch that keeps sticking.
How to check if a G9 golf cart has a sticky solenoid?
How to check if your Yamaha G9 golf cart has a sticky solenoid. Unplug all the cables from the two large terminals. Wrap the cable ends in electrical tape and make sure to keep them separated. Put the cart direction switch in the neutral position with the key off.
How to tell if a cart has a sticking solenoid?
Go and check if there’s any lag between the time you push the pedal in and the time the cart starts to crank. If there’s any lag, you might have a sticking solenoid.