- You can remove a motor that is not seized to the splines by sliding the same off from the splined shaft. ...
- Use a jack and lift the golf cart on the right axle side. Slide the motor off and catch it as it reaches the end of the shaft. ...
- Use a small standard screwdriver and pull out the middle pin of the fastener by about one-quarter of an inch. ...
Full Answer
How do you remove a motor from a golf cart?
Use a jack and lift the golf cart on the right axle side. Slide the motor off and catch it as it reaches the end of the shaft. Remember to set the motor down lightly on the surface. Use a small standard screwdriver and pull out the middle pin of the fastener by about one-quarter of an inch.
How do you release a club car motor that is stuck?
You can follow the steps given below to release a Club Car motor that is stuck on the input shaft. Remove the rear end from the golf cart. Remove the tires and wheels. Move the lug nuts on the studs of the passenger side of the cart backward by a few threads. Position the cart so that the rear end of the passenger side is upward.
How do junkyard golf carts get junked?
Golf carts end up at the junkyard in one of four ways: private owners, rental companies, golf courses, and/or auctions. The salvage will work through various channels to build their inventory.
Where can I buy golf cart parts?
Great deals on golf cart parts, and occasionally a whole golf cart, can be had at certain salvage and junk yards. These are places where dying or dead cars, boats, motorcycles, ATVs, and golf carts go to be stripped for parts or melted down for scrap metal.
How do you jump a golf cart engine?
4:0210:28Testing 36 volt golf cart motor with 12 volt battery - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou're going to take the negative. And put it on the a1. Again i'm going to take the jumper cableMoreYou're going to take the negative. And put it on the a1. Again i'm going to take the jumper cable from a2 to s1 you're going to take the positive cable from the jumper.
How do you know if your golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
Can you upgrade a golf cart motor?
0:2613:52How To Upgrade Your Golf Cart Motor - Install, Torque, and Speed TestYouTubeStart of suggested clipEnd of suggested clipThat I heard about these motors is that when you upgrade to 48 volts. And you put more amperageMoreThat I heard about these motors is that when you upgrade to 48 volts. And you put more amperage through them with the new controller. You can actually burn out the motor pretty.
Can you put a gas engine in an electric golf cart?
An electric cart has a completely different rear axle than a gas cart and they are nowhere near compatible. The electric motor is directly connected to the axle and there is a single set of internal gears without a mechanical method of switching between Forward & Reverse.
How long does a golf cart motor last?
Golf Cart Motor Just like solenoids (mentioned above), your golf cart motor works HARD. When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+).
What are the 4 terminals on a golf cart motor?
If you're unsure if it is working, it is simple to test. There are four terminals on a solenoid: usually two large and two small. The small terminals are connected to the battery, and the large terminals are connected to the motor. Disconnect all wires from the two large terminals.
How many horsepower is a 48 volt golf cart?
10.1 HPClub Car Series GolfCar Motor 22mph at 48 Volts 10.1 HP USA Made - plus20% torque.
How can I speed up my golf cart?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.
Can you convert a 36V golf cart to a 48V?
It all depends on your battery bank used with this 36V to 48V conversion. can only be accomplished through installing a 48V motor capable of higher torque, or installing a 48V controller with a higher current limit (amperage).
What kind of motor is in a gas powered golf cart?
DETAILS: Gas powered golf carts use regular unleaded gasoline. The average gas powered carts have 10 to 12 horsepower. These engines operate similar to that of a car which means that their maintenance will be similar to that of a car.
How do you convert a golf cart to a lithium battery?
3:3318:48How To Convert Your Golf Cart To A Lithium Battery..........And ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou get your converter your inverter or whatever to go from 48 volts to 12.. Then we can run likeMoreYou get your converter your inverter or whatever to go from 48 volts to 12.. Then we can run like your underglow kit you can run your headlight. And you're not running on a 48 volt setup.
How do I convert my golf cart to gas?
0:1513:54Electric to Gas Conversion | 420cc Street Legal Golf Cart Build Pt. 2YouTubeStart of suggested clipEnd of suggested clipLet's get into it so to start things off we're gonna install the 40 series torque converter on theMoreLet's get into it so to start things off we're gonna install the 40 series torque converter on the 420 that we're gonna put in the chassis.
How do I know if my motor controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
What happens when an electric motor burns out?
When a motor burns out, a short circuit occurs in the windings and the motor ceases to turn. You can test for a short circuit by checking the resistance of the windings with an ohmmeter; a reading of 0 ohms (Ω) indicates a short.
How do you test a golf cart motor controller?
How to Test a Club Car Golf Cart Speed Controller? The simplest test to ascertain your golf cart controller's performance is to to watch whether it runs when the batteries are fully charged with a slight push of the pedal. If you hear a distinct clicking noise, then your golf cart is running correctly.
What would cause an electric golf cart not to move?
Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
How Do Junkyards Work?
Junkyards purchase wrecked vehicles that are not worth the cost to repair and then sell any car parts from the vehicle that are still functional. T...
What Tools Should I Bring to the Junkyard?
Having the right tools on hand is critical when picking parts. Here are my top tool picks for pulling parts: Wrenches Ratchets Sockets SAE and Metr...
Why do Junkyards Charge Entrance Fees?
Some self-service junkyards charge an entrance fee (normally less then $10) to walk around. This is to help cover maintenance and administrative co...
Can you Negotiate with a Junkyard?
For standard parts like doors, alternators, fenders, engines, transmissions, mirrors etc junkyards have fixed listed prices that are non-negotiable...
How Much do Junkyards Pay for Cars?
There are many factors that determine the price, but most commonly you will get between $250 and $500. The prices fluctuate based on the scrap meta...
How do golf carts end up in junkyards?
Golf carts end up at the junkyard in one of four ways: private owners, rental companies, golf courses, and/or auctions . The salvage will work through various channels to build their inventory. An example is when a rental company or golf course has a cart that is beyond repair they may sell it to a salvage. Sometimes they will enter the lot via ...
What are the drawbacks of cheap golf cart parts?
Quality of the parts is always the kicker. Golf carts are made to do work, carry weight, and drive on terrain, these golf carts likely have lived a pretty full life. You have no idea what kind of stress this battery or motor has been under.
What happens when you pull salvage parts?
This allows them to ensure they get the most profit from the junked cart. Once everything is prepped, it heads to the lot to be scavenged for parts. This is when people come and pull salvage parts or order them online. Once all the valuable parts are out of it, what remains will get sold off for scrap metal.
How to remove a winding from a motor?
2. Cut off the items which are attached on the motor. 3. Loosen the screws on the steel case and then remove the case. 4. Use a pair of wire cutters or chop saw to cut off one side of the copper winding, and then pry the winding out by using a screw driver on the other end. 5.
How to avoid electric shock when motor fails?
In this regard, we have two methods to introduce for you. 1. Make sure the motor has not been used for at least one hour to avoid electric shock. 2. Cut off the items which are attached on the motor.
What percentage of copper is in AC motor?
The copper content in a scrap motor varies according to the types of motor. Averagely, an AC motor contains 7-9 percent of copper. If you are a motor recycler or manufacturer, you can start to consider buying motor stator recycling ...
Can you scrap copper winding?
If you have rich resources of scrap motor, you might consider a fast way to scrap the copper winding. Good news is that, there are machines special designed for recycling copper winding in the motor stator.
Why is recycling electric motors important?
Recycling electric motors is imperative because of their wide industrial and commercial use. Examples of devices we use that makes use of an electric motor include: Machine tools, etc. Electric motors generate mechanical energy (force) through the interaction of its windings and its magnetic field.
What metal is used in electric motors?
The more copper the more valuable an electric motor is to a recycler. Second most valuable common nonferrous metal found in electric motors is Aluminum.
Why are electric motors less desirable?
Smaller electric motors — usually small electronics transformers in radio controlled cars, for instance — exist are less desirable due to their relative low copper or aluminum content. As a result, recyclers classify motors larger than a basketball, but less than 2,000 pounds as large motors.
What is the exterior of a motor?
However, the exterior of most motors comprised of steel with a strong shell which protects the more fragile wiring and parts within. Additionally, some motors contain aluminum instead of copper.
Is an electric motor recyclable?
Also, the electric motor is 100% recyclable since a majority of its components are metallic. Furthermore, most industries use electric motors to produce the majority of today’s devices. Therefore, when they are damaged and do not undergo recycling they could cause landfill.
Do electric motors have copper windings?
As a result, some electric motors don’t have enough copper windings. The process of recycling electric motors should be direct and straightforward: First, the recyclers collect many electric motors as possible to increase the possibility of getting enough copper.
