If you have a stock cable you need a 9/16 and a 1/2 in. wrench. about 1/2 way downn the cable there is a rubber boot. pull the rubber boot over the adjustment. Loosen the liock nut and adjust the cable so you have aprox 1/8 to 1/16 in. slack in the handle. Re tighten the lock nut and pull the rubber back over the adjustment.
Full Answer
What is a Harley Davidson golf cart Tiller?
The unique feature of the three-wheel Harley Davidson golf cart was the tiller steering handle. The tiller was the steering bar used instead of a steering wheel. The entire rear body lifted and hinged rearward to reveal the whole engine compartment.
How to adjust a carburetor on a golf cart?
The way to adjust the carburetor on a golf cart will depend on the model of golf cart. In most cases, you’ll need to adjust the jet pilot screw, perform a valve clearance adjustment and then clean the carburetor. The engine shows a reduced performance such as a reduction in fuel efficiency or power and sluggish acceleration.
Do they still make Harley-Davidson Golf carts?
The company is worldwide famous for its iconic motorcycle, but most are unaware of its incredible golf cart line that started in the 60s. Although they no longer produce golf carts, you may find one on the market used or have one already. First, let's look at the history of Harley Davidson golf carts.
Where is the idle circuit on a 2 cycle golf cart?
In a 2-cycle cart, this is the idle circuit and is initially set for 1-1/2 outward turns. The main jet in the carburetor diagram of a 4-cycle engine is located below the carburetor while the pilot jet is present on top of it. The needle valve and float pin are also housed under the carburetor. How to Adjust Club Car Golf Cart Carburetor
How do you adjust the air fuel mixture on a Harley Davidson?
7:129:08HOW TO TUNE A HARLEY DAVIDSON CARBURETORYouTubeStart of suggested clipEnd of suggested clipTurn normally the mixture sprues should only require two to three turns. Anything above four turnsMoreTurn normally the mixture sprues should only require two to three turns. Anything above four turns indicates.
How do you adjust a golf cart carburetor?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
What is the carburetor on a golf cart?
Your carburetor is a vital part of your Club Car engines performance. The carburetors purpose is to blend air and fuel allowing your golf carts engine to run.
How do you adjust the throttle on a gas golf cart?
Pull the spring that is present around the plastic piece located behind the shifter. Spin it until it falls back. Loosen the throttle cable present in the cable box to adjust the extent to which you can take it out of the housing. Press the accelerator so that the golf cart starts up and begins to idle.
Why does my golf cart keeps backfiring?
Engine backfiring occurs when there is an air leak within your golf cart or sometimes when there is too much fuel inside. This can cause the piston to slam against the cylinder head and cause a tapping sound. An essential component of any golf cart is the drive belt.
Where do you spray carburetor cleaner on a golf cart?
These include the jet ports, the choke plate, and the idle adjustment port. These openings are relatively easy to find and should only need a few sprayers of cleaner. Wipe them down with your brush and then dry with another cloth to keep them clean. At this point, your carburetor is clean but needs to be rebuilt using.
How do you clean the carburetor on a gas golf cart?
Spray the carburetor body inside and out with cleaner. Use the tube nozzle on the spray can to clean the jet ports, idle adjustment port and the choke plate. Use the bristle brush to clean dirt and deposits on the body. Wipe the carburetor with a dry cloth.
What is Keihin carburetor?
Keihin Fuel Systems is a large manufacturer of carburetors for racing vehicles such as dirtbikes, watercraft and motorcycles. They also manufacture other products pertaining to the vehicle's fuel system.
How do you adjust the idle on a golf cart?
0:523:44How to get your club car to idle - YouTubeYouTubeStart of suggested clipEnd of suggested clipJust slightly that's the idle screw in. It. You have to turn it up just a hair I mean it's so littleMoreJust slightly that's the idle screw in. It. You have to turn it up just a hair I mean it's so little that you probably won't even notice it.
Why do I have to choke my golf cart?
A golf cart choke is commonly used when starting a cold engine to restrict air flow while the fuel gets to the engine. Once the mixture stabilizes and the engine can run on its own without air restriction, the choke is released.
How do you adjust the carburetor on a Yamaha g2 golf cart?
How to Adjust Yamaha Golf Cart CarburetorPull out the pilot adjustment screw. ... Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
Why does my Yamaha g29 golf cart backfire?
A golf cart backfires through the carburetor because of an open throttle plate. The accelerator cable at the plate is out of adjustment and in turn, stops the plate from closing when the microswitch makes contact with the ignition.
Open Questions
Be the first to answer Feb 25, 2022 • Harley Davidson FXD Dyna Super Glide...
2006 Harley Davidson Dyna Glide. Why no rear brake or signal lights? I just lost power to rear brake and signal lights. The signal lights do work when I put turn signals on but other then that nothing. I did put on a new eagle rear light a couple months ago so I don't think it's the bulb (although I haven't checked) but, there is a white light on top of the brake light and that does come on. No power when engaging the front and rear brake either
Be the first to answer Feb 25, 2022 • Harley Davidson FXD Dyna Super Glide...
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
What type of electrical system does a Harley Davidson have?
The Harley Davidson gasoline cart has a 12-volt electrical system utilizing a combination starter motor/generator unit built into the engine crankcase, in conjunction with a control switch-box-regulator unit and a storage battery using a negative grounded system.
What are the components of a motor control system?
Components of the control system are the reversing switch, solenoid switch, adjustable field resistor or regulator, micro-switch and a key switch.
How does a generator work when engine speed exceeds starter generator speed?
When engine speed exceeds starter generator speed, the shunt field coils (G) are excited and the current generated in the armature is utilized for the ignition system and charging the battery . The generator output is limited by the adjustable resistor or regulator (9), which controls the strength of the magnetic field produced by the shunt field coils (G). The generator voltage increases with engine speed and as soon as the rated level (approximate ly 15 volts) has been reached, charges the battery and increases with engine speed to its maximum value controlled by the voltage regulator. The prescribed charging rate at governed speed is set by means of a variable resistor or is controlled by the voltage regulator.#N#On models equipped with field resistor, a diode acts to bleed off the voltage generated by the operation of the cart when coasting with solenoid contacts open (i.e.accelerator pedal released).
The CLASSIC Harley Davidson Golf Cart Model
Over the years, Harley Davidson models have come and gone, but the 'Classic' body style, with the deep, lift back body, is well known. It first appeared as a three-wheeler in 1963, and later a four-wheeled cart was made. The unique feature of the three-wheel Harley Davidson golf cart was the tiller steering handle.
How to Find the Year of Your Harley Davidson Golf Cart?
People interested in the Harley Davidson Golf cart should know how to read the VIN (Vehicle Identification Number). There are different ways, like a simple serial number arrangement or the solenoids in your electrical engine. The easiest way to know the age of your Harley Davidson golf cart is to use the serial plate.
Harley Davidson Golf Cart Today
Harley Davidson golf carts are now a classic piece of machine history and considered a worthy treasure to be purchased, and many enthusiasts take pride in restoring them. Although restoring these vintage golf carts is not always easy.
The Worth of a Harley Davidson Golf Cart
Valuing the Harley Davidson golf carts today is difficult as most carts will be in a condition of repair or disrepair. Most of them are available to buy online, at auction, on Craigslist, and some dealers sell them as well.
When did Harley Davidson golf carts have steering?
In 1963 , Harley Davidson golf carts were only available with 3 wheels and the steering was controlled by a tiller turning the front wheel. Later versions of the cart offered a steering wheel instead of a tiller.
What year was the front wheel on a Harley Davidson?
Harley Davidson Front Wheel – 1970 and Later. 1970 and later Front Wheel Assembly. The 1970 and later Harley Davidson models have a different axle and mount from the previous years. The axle is similar in appearance, but the threads at the end actually screw into the threaded hole on the fork (shown in the photo below).
How to remove a cotter pin from a car?
Raise the front wheel off the floor with a jack and place jack stands under the front floor pan frame. Remove the cotter pin on the right side (facing the vehicle) and unscrew the castellated nut. Each fork has a clamping nut that holds the axle in place.