How do you line up cam gears on an EZGO golf cart?
At the top of the motor you will see a knotch, and on the cam gear you will see a hole, line those up, make sure the crank keyway is straight up, and put it all back together. What should compression be on a ezgo golf cart?
How do I know if my EZGO coil is bad?
Take the voltmeter’s black and red probe and place it on the –ve and +ve terminal of the coil. Take the readings. It should be between 3.7-5.2 ohms. If outside the range, the coil should be replaced. Pulser coils can be fried, and the only way to start a EZGO golf cart is by replacing the coil.
Where is the pulser coil on a EZGO lawn mower?
EZGO pulser coil location The location of the pulser coil is under the cart’s seat and is near the engine. It is better to use a user manual to locate the coil so that it can be tested or replaced. If there is no spark, there is always a requirement to check if the coil is working fine.
How do I set the time on my EZ Go golf cart?
0:091:50EZGO 350cc eh35c Timing engine - YouTubeYouTubeStart of suggested clipEnd of suggested clipSee this is how you time the engine take this dot. Make sure it's lined up with this groove. ThisMoreSee this is how you time the engine take this dot. Make sure it's lined up with this groove. This little notch here come down to this this little gear here.
How do you set valve timing without timing marks?
2:139:13How to set 16 valve timing without timing marks. (Fire 1, Rock 4)YouTubeStart of suggested clipEnd of suggested clipPerson will move down as it moves down the cam will turn opening your valves on the exhaust upMorePerson will move down as it moves down the cam will turn opening your valves on the exhaust up stroke cycle.
How do you adjust the carburetor on a ezgo txt?
2 Cycle engine: The adjustment screw is on the side of the carburetor and is parallel to the ground. You can identify it by the lock nut at the base of the screw. Loosen this and turn the screw all the way into a soft seat, then back it out one and a half (1-1/2) turns.
How much oil does a EZ Go golf cart take?
The typical engine oil which is used in most of the EZGO carts is 10W-30 and 10W-40. The oil capacity of an EZGO cart is around 6 cups.
How do you tell if timing is off on an engine?
2:124:21How To Tell If Your Engine Timing Is Off - YouTubeYouTubeStart of suggested clipEnd of suggested clipLight is producing your check engine light is producing. And if it pulls a timing code then you knowMoreLight is producing your check engine light is producing. And if it pulls a timing code then you know your timing is off or there's a problem with the timing.
How do you set initial timing?
6:099:14How to Set Initial Ignition Timing - YouTubeYouTubeStart of suggested clipEnd of suggested clipWhen moving the distributor housing to adjust the timing you're going to want to move it in veryMoreWhen moving the distributor housing to adjust the timing you're going to want to move it in very small increments. Because even a quarter inch is gonna give you several degrees change in your timing.
What causes golf cart hesitation?
In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.
Why does my ezgo backfire?
The golf cart backfires through the carburetor because of an open throttle plate. The accelerator cable at the scale is out of adjustment and, in turn, stops the vessel from closing when the microswitch makes contact with the ignition.
How do you adjust a carburetor on a golf cart?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
Can I use synthetic oil in my EZGO golf cart?
Yes! We are pleased to tell you that it is indeed possible for you to use synthetic oil in your gas golf cart.
What oil is recommended in an EZGO golf cart?
10W-30 grade engine oil.
How often should you change the oil in a golf cart?
If your golf cart is used often, you'll want to check on it more than that. You'll need to replace your engine oil and filter semi-annually, generally once it hits around 125 rounds or 600 miles of usage. For new engines, your initial oil change should be after 8 hours of run time.
What is the purpose of a golf cart pulser coil?
The purpose of the Pulser coil is to give ignition signals to the engine and ignition system. The resistance categorizes pulser coils.
How to remove coil from flywheel?
To remove the coil, the flywheel needs to be detached. Use a balance styled puller and attach the same to the threaded holes. Now add some pressure and let the puller do its job by removing the flywheel.
Is the Ping G25 adjustable?
Is the Ping G25 driver adjustable? The Ping G25 driver is adjustable. It’s possible to do four adjustments using the hosel adapter of the driver apart from the stated loft setting and...