Set drive select lever exactly between Forward and Reverse. Pull the drive belt away from the secondary sheave. Move the secondary sheave clockwise for the drive belt to roll out of the setup.
Full Answer
How fast do Yamaha golf carts go?
Yamaha Golf Carts, on average, offer speeds of around 15mph. Many users wish to get a bit more from their golf carts by increasing the speed by another 4-5mph. The speed of a Yamaha golf cart can be increased by increasing the torque produced by the golf cart.
How do you fix a Yamaha G1 golf cart that is slow?
A slow Yamaha G1 golf cart can be fixed by simply cleaning the battery terminals, spark plug terminals, and motor terminals. If the battery terminals are greasy, the current from the battery will be low and in turn, the acceleration will be lower than what it should be.
What kind of engine does a Yamaha golf cart have?
Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard. link to How Does A Golf Cart Work? - Complete Guide To Understanding It (2021)
What causes a Yamaha golf cart to run and then stop?
A Yamaha golf cart can run and then stop because of loose spark plugs, a problem with the fuel supply, or problems with the transmission of torque. To check if there is a problem with the fuel supply, spray starting fluid on the carburetor as soon as the cart stops during a run.
How do you align a Yamaha golf cart?
0:121:05Yamaha G-29 Golf Cart alignment steps - YouTubeYouTubeStart of suggested clipEnd of suggested clipSure you tighten it when you're done but loosen. This adjust this in or out according to what youMoreSure you tighten it when you're done but loosen. This adjust this in or out according to what you need for your toe-in or toe-out. For you 22 on here tighten your 17 millimeter back up. And that's it.
How do you adjust the carburetor on a Yamaha golf cart?
How to Adjust Yamaha Golf Cart CarburetorPull out the pilot adjustment screw. ... Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
Why does my Yamaha Golf Cart backfire?
The golf cart backfires through the carburetor because of an open throttle plate. The accelerator cable at the scale is out of adjustment and, in turn, stops the vessel from closing when the microswitch makes contact with the ignition.
How do you adjust the governor on a Yamaha golf cart?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
What causes golf cart hesitation?
In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.
What engine is in a Yamaha golf cart?
At 357cc and 11.4 horsepower, it is Yamaha's most fuel-efficient carburetor engine. The PowerTech AC enables muscular hill climbing and a smooth ride. At 48 volts, its output is 5.0kw (6.7hp) for up to 60 minutes before recharging.
How do I stop my Yamaha golf cart from backfiring?
One simple way to stop the golf cart from backfiring is to use good quality fuel. Once this is done, ensure that the throttle plate is closed by adjusting the accelerator cable at the plate.
How fast can a Yamaha golf cart go?
Most electric golf carts are faster than gasoline golf carts. Although, new gasoline and electric golf cart versions of Yamaha all have the same top speed. The top speed of both versions of Yamaha golf carts is 19 mph (31 kph).
What causes a gas golf cart to surge?
A golf cart can be surging due to insufficient fuel levels, damaged motor brushes or a vacuum leak. The brushes in the motor are damaged or worn out. The MCOR is malfunctioning or a mismatch between the motor and controller results in torque bumps.
How fast can a golf cart go without a governor?
A typical electric cart without an upgraded speed control tops out around 12 mph.
Where is the governor Located on a Yamaha golf cart?
1:003:57How to Adjust Governor on Yamaha G29 Drive Gas Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo on your car you take the rear inspection panel off right underneath it here. You will have aMoreSo on your car you take the rear inspection panel off right underneath it here. You will have a spring actuated governor this is actually what speeds you up and slows you down.
How can I increase the speed of my golf cart?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
How many times can a Yamaha engine be rebuilt?
Yamaha engines are durable and because of the simple design, they can be successfully rebuilt 3 or 4 times . Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard.
How to remove gas filler hatch?
Put the vehicle in neutral and open the seat cowling pulling up on the lever in the gas filler hatch. Remove the 5 screws from the front and rear of the cowling and lift out.
Does the G21 have a filter?
The G2, G9, G11, and the G21 model Fuel tank has a screw-in filter that is difficult to reach. It is advisable to remove the 2-4 bolts holding the tank in and pull the tank out to drain and replace the filter. Please note that on ALL models using the screw-in filter the tank will need to be drained.
When should the cams be fitted?
The cams should be fitted next on the 'compression' stroke meaing the all valves should be closed when the cams are seated (no valves being pressed by cams) generally at this point the cam lobs face away from the valves , next stroke down (ignition of fuel) valves should be closed with the exhaust cam moving round ready to rock on to the exhaust valve as the piston rises to the top again (4th stroke exhaust) as the exhaust valve lobe rocks off the intake cam lobe should be starting to rock on opening the intake valve on the down stroke of the pistion.
How often does the crank shaft turn?
The Crank shaft turns twice for every one turn of the camshaft so you could have positioned it halfway through the 4 stroke cycle so you are not at tdc on number 1.
How to turn crank pulley?
Using a socket and ratchet, By Hand turn the CRANK Pulley CLOCKWISE One full rotation. This should bring the timing marks into the right position.
Can you store a 2 stroke engine for the winter?
I find with two stroke engines the carb gets all gummed up if you store it for the winter. A good carb cleaning usually does the trick
How fast does a Yamaha golf cart go?
How to Make a Yamaha Golf Cart Go Faster. Yamaha Golf Carts, on average, offer speeds of around 15mph. Many users wish to get a bit more from their golf carts by increasing the speed by another 4-5mph.
How can the speed of a Yamaha golf cart be increased?
The speed of a Yamaha golf cart can be increased by increasing the torque produced by the golf cart.
Why does My Yamaha Golf Cart Run Slow?
The main reason why a Yamaha golf cart runs slow is because of low battery charge, dirty battery terminals, or a loose spark plug.
How to fix a slow Yamaha G2?
A slow Yamaha G2 golf cart can be fixed by replacing the spark plug and damaged wires.
Why is my Yamaha golf cart so slow to start rolling?
If the spark plug is loose or dirty , a Yamaha golf cart will be slow to start rolling as the torque delivered will be lower than the expected value. Cleaning and maintaining the spark plug gap can help fix this issue. The electrode color for the spark plug is expected to be tan.
Why does my Yamaha G1 cart sluggish?
The motor terminals need cleaning too, if the motor terminals are greasy or loose, the power received by the motor will be low, which lowers the speed of the cart. Keeping them tight and clean can help fix the sluggish speed of your Yamaha G1.
How to check battery voltage on Yamaha golf cart?
The pack voltage of the batteries installed on your Yamaha golf cart can be checked by connecting a voltmeter to the positive and negative terminals of the battery. When going uphill, brakes and bearings tend to drag the cart back if they have not been lubricated properly.
