Golf-FAQ.com

how to start reading codes on a golf cart

by Victor Wolf III Published 3 years ago Updated 2 years ago
image

How do you put a golf cart in diagnostic mode?

You can enter diagnostic mode by turning OFF the key switch and changing the direction switch from the neutral position to reverse. This must be done five times. Once the above action is done, you will hear a beep code confirming that the cart has been correctly set to diagnostics mode.

How do I find out what year my golf cart is?

Please click on your brand of golf cart below to view information specific to that manufacturer regarding where to find these numbers. Once you find the numbers, refer to the guides or give us a call at 800-328-1953 and we can help you determine the year and model of your golf cart or utility vehicle.

What are the codes for drop out fault on a golf cart?

In rare cases, a motor replacement may be needed. The IQDM controller response codes for main drop out fault are A and C.This fault is detected if there are open solenoids when the golf cart is in use. The solenoid is losing ground and is therefore not able to establish a contact.

How do you read a battery meter on a golf cart?

Connect 4’s positive terminal to the positive side or the “switched” side of the key switch to make use of the LED function of the meter. To best way to read your battery meter, is to drive your golf cart up a hill.

image

How do I put my ezgo golf cart in diagnostic mode?

You can enter diagnostic mode by turning OFF the key switch and changing the direction switch from the neutral position to reverse. This must be done five times. What is this? Once the above action is done, you will hear a beep code confirming that the cart has been correctly set to diagnostics mode.

How do you diagnose a golf cart problem?

Look for a small red button located near the main power supply. Press the button and put your cart back together before hooking it up to charge. In many cases, this will solve the problem. If it doesn't, try removing the motor and testing it with a separate, fully charged battery.

How do you reset a golf cart computer?

Easily Reset the Club Car Golf Cart OBCKey switch to off.Set forward/reverse to neutral.Put tow/run switch to tow.Disconnect the negative battery terminal from the battery pack.Put the tow/run switch to run.Put forward/reverse switch to reverse.Put key switch to on.More items...

Where is the reset button on a Club Car golf cart?

It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.

How do you test a golf cart?

0:296:18The battery voltage can be buy tested by probing with a simple voltmeter by pushing the probesMoreThe battery voltage can be buy tested by probing with a simple voltmeter by pushing the probes deeply into the lead not in not into the stainless steel put into the lead.

How do you reset the motor on a EZ Go golf cart?

Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor. Put the panel in place and secure it with the screws.

How do you reset a cart battery?

0:201:16So a very simple fix what we often tell people to use is just a paper clip. And if you stick theMoreSo a very simple fix what we often tell people to use is just a paper clip. And if you stick the paper clip in between the connection plate and the threads.

How do you bypass a computer on a club car?

2:544:33We can cut it. Real close to the OBC. And then put a ring terminal. As. I think that's a 5/16 holeMoreWe can cut it. Real close to the OBC. And then put a ring terminal. As. I think that's a 5/16 hole in it so it goes right over this tournament either way we've got to get this wire.

How do you reset the onboard computer on a Club Car Precedent?

How to reset your Club Car's OBC after a faultKey Switch to Off.Forward/Reverse to Neutral.Tow/Run Switch to Tow.Disconnect the Battery NEGATIVE (–) wire from the Battery Minus terminal on the battery pack.Put the Tow/Run to Run.Forward/Reverse Switch to Reverse.Key Switch to On.Lock the throttle pedal down.

Do all golf cart motors have a reset button?

Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.

How do you troubleshoot an electric Club Car?

2:3915:02Make sure your key switch is on step on the accelerator. You should get a light here.MoreMake sure your key switch is on step on the accelerator. You should get a light here.

What would cause a golf cart not to start?

As the main source of power to your electric golf cart, the batteries are commonly the cause for why your electric golf cart won't start. Acid-based batteries are typically used for electric golf carts and must be recharged in order to work properly.

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9