
Keep a jack at a suitable lifting point in front of the vehicle and lift it until the wheels are off the ground. Position the jack stands behind the wheels of the cart under the frame. Lower the golf cart and allow it to rest on the stands.
Full Answer
How do you lower the top of a golf cart?
Make measurements to locate golf cart top lowering brackets. Drill holes to attach brackets (best to do one by one) Cut roof strut at angle to accommodate lowering process and movement ( Note – need to make sure angle is cut in right direction) Repeat process on all four corners of golf cart.
How to align club car golf cart front end?
How to align Club Car golf cart front end? The best way of aligning the Club Car front end is to first adjust the placement of the camber, followed by the alignment of the wheel and tire, by toeing them in or out as per required. Position the straight and leveled edge of the camber on the ground.
How do you toe-in and toe-out a golf cart?
To toe-in, turn it towards the Club Car’s front end and toe-out, turn it towards the back end of the Club Car. After the tires are aligned correctly, lower the cart to the ground and double-check the symmetry.
Why is my golf car leaning to one side?
Why is My Golf Car Leaning to One Side? A golf cart may be leaning to one side because of a bent spring, a cracked frame or simply from only one person riding the cart for years at a time. In most of the cases, the cart might be leaning heavily in the front or the back.

How do I remove the front of my EZ Go golf cart?
1:285:35How to Install an E-Z-GO TXT Body and Cowl - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis will expose two rivets that you need to drill. We can pull down on the front and should popMoreThis will expose two rivets that you need to drill. We can pull down on the front and should pop right. Off.
How do you disassemble a golf cart?
1:209:35EZGO TXT Body Removal | How to Remove Golf Cart Body | Episode 1YouTubeStart of suggested clipEnd of suggested clipSo now what we're going to do is we're going to take the front bracing off this is what held theMoreSo now what we're going to do is we're going to take the front bracing off this is what held the green shield and the front of the top assembly. On this particular car this is half inch bolts.
How do you change the body on a golf cart?
7:2313:38How to Remove & Install Club Car Precedent Golf Cart Body - YouTubeYouTubeStart of suggested clipEnd of suggested clipIn order to replace the rear body we need to take the seat off and remove it away from the golf cartMoreIn order to replace the rear body we need to take the seat off and remove it away from the golf cart lift up pull up and remove.
How do you remove the front body of a Club Car Precedent?
0:146:41Body Remove / Install for 04+ Club Car Precedent golf cart carts carYouTubeStart of suggested clipEnd of suggested clipSo we're going to remove the windshield. So we get the front cowl off uh which is super easy justMoreSo we're going to remove the windshield. So we get the front cowl off uh which is super easy just got to remove the two bolts on each side you got one over here one on the other side.
How do you take the body off a Club Car DS?
2:537:18VLOG #10 Club Car DS body removal - YouTubeYouTubeStart of suggested clipEnd of suggested clipBody is to use a number three phillips on the forward reverse handle remove those bolts and pull theMoreBody is to use a number three phillips on the forward reverse handle remove those bolts and pull the handle. Out. Then the charger receptacle use the number two phillips.
How do you remove an axle shaft on a EZ Go golf cart?
1:592:59How to Remove an E-Z-GO TXT Front and Rear Axle - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe first step is to remove the rear pin from the brake cable once this is done remove the c-clipMoreThe first step is to remove the rear pin from the brake cable once this is done remove the c-clip and slide the brake cable from the assembly.
How do you prepare a golf cart body for painting?
Sand down the body of the cart with fine-grit sandpaper. Rub down the area in a circular motion with firm pressure. This will help the paint stick to the golf cart's nonporous surface. Make sure to sand away any old paint to avoid it tinting your fresh coats.
What is a cowl on a golf cart?
Cowls are the forward portion of any golf cart where your instruments are mounted and if it were an automobile where the hood might be located.
How do you restore a golf cart body?
2:205:52GOLF CART RESTORATION FOR UNDER $40!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis is super simple to start take your squirt bottle and wet the area you'll be working on maybeMoreThis is super simple to start take your squirt bottle and wet the area you'll be working on maybe even a little spray on the trackpad.
How do you remove the gas tank from a Club Car golf cart?
Locate the knob at the bottom of the tank and unscrew it. Remove the engine and seat from the golf cart. Take out the fuel filter inside the tank. Pull the tank out of the cart.
How do you remove a motor from a club car?
Club Car Precedent motor removal It can be done via the access panel present in the bagwell without hitting the shaft. Use a jack and lift the golf cart on the right axle side. Slide the motor off and catch it as it reaches the end of the shaft. Remember to set the motor down lightly on the surface.
How do you install snubber on a club car?
2:454:341984 - PRESENT CLUB CAR TRANSMISSION MOUNT ...YouTubeStart of suggested clipEnd of suggested clipSlide the new snubber onto the bracket just like that. And we'll reinstall. All right let's just goMoreSlide the new snubber onto the bracket just like that. And we'll reinstall. All right let's just go ahead and install the. Nuts. Just like that. And we'll get those torqued. Down. Play any time.
How do you remove the gas tank from a EZ Go golf cart?
Locate the knob at the bottom of the tank and unscrew it. Remove the engine and seat from the golf cart. Take out the fuel filter inside the tank. Pull the tank out of the cart.
How do you remove a golf cart axle?
How do I remove the rear axle on a Club Car golf cart?Remove the rear wheel of the golf cart.Take off the brake drum from its place.Insert a 90-degree snap ring pliers through the holes in the hub and remove the snap ring.Slide the axle out of its position.
How do you remove an EZ Go electric motor?
1:175:58EZGO RXV Golf Cart Motor Removal & Installation How-To - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst we'll put it in the tote. Now to disconnect all the connectors going to the motor your three.MoreFirst we'll put it in the tote. Now to disconnect all the connectors going to the motor your three. Total. Now to remove the three main drive cables located at the bottom of the controller.
How do you remove the ezgo Rxv dash?
0:249:25ez-go Rxv Dash install - YouTubeYouTubeStart of suggested clipEnd of suggested clipI've gone ahead and loosen this one up and I'm ready to just go ahead and pull it. Off. Once you'veMoreI've gone ahead and loosen this one up and I'm ready to just go ahead and pull it. Off. Once you've loosened these nuts on the backside. It pops right off.
Videos
Here are a few videos for the DIY-ers out there looking to save a few bucks and who don’t care so much about the finished look just need to be able to lower the golf cart top to make it fit somewhere. Checkout this YouTube video to learn more.
Easy to follow
Pete got a member of his office staff to try the kit – here’s what they said:
Added extras
If you are looking for a affordable solution to add some music to your golf cart? Checkout Pete’s new golf cart top mounting Bluetooth stereo systems. Models specifically for the Club Car Onward and Precedent, Ezgo Rxv and the Yamaha Drive. Pete’s Golf Carts has all the cool accessories for your golf cart.
How to align club car front end?
The best way of aligning the Club Car front end is to first adjust the placement of the camber, followed by the alignment of the wheel and tire, by toeing them in or out as per required .
How to loosen lug nuts on club car?
You must do this on all of the bushings to make the process easier later on. Jack up the Club Car from the back. Use a ¾-inch socket to loosen the lug nuts on the back tire.
What to do if camber does not budge?
If the camber still does not budge, redo the procedure on both joints and keep adjusting the position as required. After the front end of the driver’s side is completed, redo the whole procedure for the front tire on the passenger side of the Club Car.
Why does my golf cart wobble?
If the front-end of your golf cart wobbles while driving, it could be due to faulty and/or non-branded tires, incorrect tire alignment or a faulty engine. Faulty and/or non-branded tires. Incorrect alignment of the tires. Faulty engine.
How to measure tire distance?
Measure the tire distance. Measure the distance from the center point of the tire on the driver’s side to that on the passenger’s side. This should be measured from the front and backside of the front tires. The distance should roughly be around 34-3/8 inches.
What causes a club car to crash?
Front Leaf Spring Bushings: Worn-out bushings in the front leaf spring can cause the Club Car to crash while in motion and could also cause camber and tire issues. Replacing all the above parts will fix the front end problems and also improve overall control, camber and tire of your Club Car.
How to fix a club car that is wobbling?
Steps to fix the wobble: Align the tires properly. Examine the height of the tires and ensure that the placement of both tires is even. Pull out the tires and clean them if there is any dirt jabbed in them. You must also consider inspecting the engine of your Club Car , along with the steering wheel.
Why is my golf cart leaning to one side?
Why is My Golf Car Leaning to One Side? A golf cart may be leaning to one side because of a bent spring, a cracked frame or simply from only one person riding the cart for years at a time. In most of the cases, the cart might be leaning heavily in the front or the back. This means that if you look at your cart from the front you might notice ...
What happens if a golf cart is damaged?
If any of them are damaged, the cart may lean towards one side. The shock absorbers present under the frame could be broken or damaged. You will have to lift the cart to view this. If it appears that these components are broken, simply replacing them will solve the issue.
Why does my cart lean towards the right?
Another possibility is that the cantilever on the rear side could have broken or rusted out. This can cause the cart to lean towards the right side. Also, check the springs under the driver’s seat for any damage or bent edges. If they appear bent, replace them with a new one of the same size.
How to check if a cart retainer is broken?
Check for a broken retainer on the leaning side. If the retainer is broken, the cart will not be able to balance correctly. You can swap the shock absorbers from the rear to the front or vice-versa. This will help you to figure out if the shocks are causing the lean.
How to tell if a cart spring has collapsed?
To identify if the springs have collapsed you can take a ruler and measure the springs on both sides. If one side has a longer length than the other side you will know that it has collapsed.
Can a driver's side frame be cracked?
This will help reduce the lean on the driver’s side. Another possibility is that the frame under the driver’s side could be cracked. You may have to take your cart to a service center to lift it on a high pedestal. Once this is done, they will be able to view the frame.
Does Yamaha G16 have a lean?
If your Yamaha golf cart is creating troubles after being put to good use for years, worry not. A lot of Yamaha golf cart users have complained of a slight lean in their carts after some years of usage . This is especially true of the Yamaha G16 models.
