- Loosen the nut attached to the governor arm with a 7/16” wrench to turn the shaft.
- Push the governor arm to the back of the cart and grasp it with your hand.
- Turn the governor shaft in the counter-clockwise direction until it cannot be turned further.
- Retighten the nut and let go off your hold on the governor arm.
- This method also helps to slow down the cart.
How do you disable the governor on a golf cart?
You may have seen others racing around in their club cars and wondered how they got up to such high speed. They did it by disabling their's cars' governor, a little device makes the cart stay below a specific speed. Here is how to do it. Get behind the driver’s side seat and look for a small plastic plate that’s held in place by two small screws.
How do you adjust the governor on a club car G16?
Wrap a zip-tie around the governor arm bolt and pull it as tight as possible. This stimulates the same effect of tightening the locknut. The following methods show you how to adjust the governor on your Club Car G16 golf cart. Turn the 10mm nut inward until you get the desired speed.
How do you adjust the governor on a golf cart clutch?
The first step in adjusting the governor is locating it. Check for a small rod near the golf cart’s clutch. If this rod is found, the governor can be adjusted by simply tightening or loosening the nut attached to the small wire connected to the rod.
What does the Governor do on a club car?
The governor helps keep your club car from overheating when the engine gets too hot. If you adjust the governor you’ll need to check the engine temperature yourself. This automatically voids your warranty.
See more
How do you turn off the governor on a Club Car golf cart?
0:000:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this leverMoreYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.
How can I speed up my Club Car golf cart?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.
Where is the governor located on a Club Car golf cart?
0:061:28Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell a golf cart's governor located is actually down in the motor. Compartment. Some of them theseMoreWell a golf cart's governor located is actually down in the motor. Compartment. Some of them these electric ones nowadays. Actually the governor isn't a true governor. It is a control speed.
Can you remove golf cart governor?
Here's another fun fact, though: you can remove or deactivate the governor from your cart engine to speed up your cart. You need to be very careful when you perform this step, though, because you may end up making a mistake that damages your engine.
How do you remove the speed limiter on a electric golf cart?
Basically, an electric speed governor can be controlled by a tiny metal rod that's located by the clutch of your golf cart. First things first: The electric speed governor is connected to a cable. You can adjust your speed by rotating the nut in a counterclockwise rotation.
How fast can a golf cart go without a governor?
What is the Average Golf Cart Speed? The average top speed of a typical golf cart without any upgrades is between 12 and 14 miles per hour. Without any sort of modification or upgrade on a golf cart, the top speed that you will be getting on a golf cart is about 14mph.
What does removing the governor do?
Removing the governor will increase the maximum rpm of the engine, but the internal parts of the Predator 212 are designed for 3600 rpm. Generally, this isn't an issue with just the governor removal, the internal parts can usually withstand 5000 rpm without breaking apart (unless you go full throttle for too long).
How do you change the speed on a club car?
0:131:31Club Car Precedent Speed Increase SUPER EASY!!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. AndMoreIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. And if you turn it that way or clockwise it speeds things up. Very.
How can I make my gas club car faster?
How to Make Your Gas-Powdered Golf Cart Faster [Updated, 2022]1 Use A Better Golf Cart Battery.2 Increase Torque.3 Upgrade the Golf Cart Motor.4 Install a Torque Converter.5 Install a Higher-Performance Clutch.6 Tweak The Governor.7 Install A Cold Air Intake.8 Get Bigger Golf Cart Tires.More items...•
How do you bypass a speed sensor on a golf cart?
The speed sensor on the EZGO golf cart can be bypassed by unplugging it from the speed controller. By disconnecting the J5 pin on the speed controller, this will cause the golf cart to creep along as the controller will go into limp mode.
How can I make my electric golf cart go faster without upgrading?
How to Make an Electric Golf Cart Faster Without UpgradesWash Your Cart Properly. ... Inspect the Batteries. ... Refill the Battery Water. ... Check the Gas Pedal and Linkage. ... Measure the Tire Pressure. ... Charge Up Your Battery Unit. ... Lighten Up Your Cart's Weight.
What is the fastest golf cart?
One group of “speed fiends” currently leading the industry in fast golf cart builds is Plum Quick Golf Cart Racing. The company currently holds two Guinness World Records and numerous other awards. One of these records is the world record for fastest golf cart. Traveling at 118.76 mph this cart can outrun most cars.
How can I make my gas club car faster?
0:131:31Club Car Precedent Speed Increase SUPER EASY!!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. AndMoreIf you turn it that way to the right or what appears to be counterclockwise. It slows it down. And if you turn it that way or clockwise it speeds things up. Very.
How can I make my electric golf cart go faster without upgrading?
How to Make an Electric Golf Cart Faster Without UpgradesWash Your Cart Properly. ... Inspect the Batteries. ... Refill the Battery Water. ... Check the Gas Pedal and Linkage. ... Measure the Tire Pressure. ... Charge Up Your Battery Unit. ... Lighten Up Your Cart's Weight.
How do I change the speed on my Club Car electric?
0:0611:46Club Car precedent speed code 5 - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd the right position is your speed mode.MoreAnd the right position is your speed mode.
Where is the speed sensor located on a Club Car golf cart?
The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.
How Does a Golf Cart Governor Work
Governors play an important role in electric golf carts by limiting the speed they can travel. This is an important safety feature, as it prevents the cart from going too fast and helps ensure passengers’ safety.
How to Take the Governor off a Golf Cart
Removing the governor from a golf cart is a simple process that can be done with common tools. Here’s what you’ll need:
Frequently Asked Questions about Golf Cart Speed Governors
If you’re looking for ways to speed up your golf cart, there are a few things you can do. Start by removing the governor on top of the engine if you haven’t already. If it doesn’t have a governor, then you’ll need to open up the cart and look at the gear shaft to see if it’s turning.
How to remove governor from golf cart?
How to Remove the Governor From a Golf Cart. You hit the links. The course is open in front of you as far as the eye can see. The only thing holding you back is the put-put-puttering of your golf cart. Golf carts are governed to go anywhere from 12 to 14 miles per hour. But if you've got a few minutes, some simple mechanical know-how and a wrench, ...
How to remove carburetor cable?
The cable is about the width of a straw. It should come off with a pull, but keep a phillips head and regular screwdriver on hand , just in case.
How fast can a golf cart go?
Golf carts are governed to go anywhere from 12 to 14 miles per hour. But if you've got a few minutes, some simple mechanical know-how and a wrench, you can double the speed of your cart and zip through your round.
How to adjust a gas pedal on a cart?
Using your wrench, remove the bolt on the gas pedal shaft. Slide the shaft up so there is more play in the gas pedal. Tighten the bolt and then start the cart. You may need to adjust the gas pedal shaft a couple of times before you have it to your liking.
Can you tamper with a golf cart?
We do not condone tampering with a golf cart that belongs to a golf course. However, if you own your own gas golf cart or a friend allows you to remove the governor from their cart, have at it.
What happens if you have problems with your club car?
If you have problems with your club car due to overheating or other engine troubles, the company often won’t pay to fix it. Writer Bio. Jennifer Eblin has been a full-time freelance writer since 2006. Her work has appeared on several websites, including Tool Box Tales and Zonder.
Can you go to a maximum speed on a golf cart?
If you have a golf cart, in particular a club car, you know that you can only reach a maximum speed before the car levels off. You may have seen others racing around in their club cars and wondered how they got up to such high speed. They did it by disabling their's cars' governor, a little device makes the cart stay below a specific speed.
Does a governor void a club car warranty?
If you have posted speed limits in your area, you will still have to adhere to those. The governor helps keep your club car from overheating when the engine gets too hot. If you adjust the governor you’ll need to check the engine temperature yourself. This automatically voids your warranty.
Does club car warranty void?
This automatically voids your warranty. If you have problems with your club car due to overheating or other engine troubles, the company often won’t pay to fix it.
Where is the governor located on a golf cart?
Check for a small rod near the golf cart's c lutch. If this rod is found, the governor can be adjusted by simply tightening or loosening the nut attached to the small wire connected to the rod. If a rod is not found, the governor is likely located inside the golf cart's engine bay on the largest wire running from the gas pedal.
Can you adjust a golf cart's governor?
Yes, it is possible to adjust the governor on a golf cart. Some golf carts use electronic governors, which are considered more difficult to adjust. It is best to consult a professional when dealing with these. The first step in adjusting the governor is locating it. Check for a small rod near the golf cart's clutch.
How to adjust governor on a golf cart?
If you find this rod, then your governor can be easily adjusted by accessing the cart’s inner workings. Simply adjust the cable coming from this metal protrusion, turning the nut counterclockwise to make the cable longer, effectively adjusting the cart’s governance to increase the overall speed. If you cannot find external controls, you’ll need to adjust the governor internally.
How to get to the engine on a golf cart?
Open up your golf cart’s access panel to get to the engine. In many cases, the panel pops open like a car hood, but in some instances you’ll need to unscrew the panel first.
Why are golf carts so popular?
In theory, golf carts make it easier for players to get across the course, saving their much-needed energy for the game. In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds. Luckily, you don’t have to stick with these standard speeds. Golf cart speed is often controlled by a device called a governor, and you can adjust the governor on a golf cart relatively easily to make the cart faster.
How to loosen tension on a governor?
Use a screwdriver— or in some cases a wrench—to loosen the tension on the governor’s springs. You have now adjusted the governor for faster speed.
Who is the writer of GolfCarCatalog.com?
GolfCarCatalog.com – “Adjusting Your Golf Cart’s Governor”. Writer Bio. Richard Kalinowski began writing professionally in 2006. He also works as a website programmer and graphic designer for several clients.
Can you adjust the speed of a golf cart?
Luckily, you don’t have to stick with these standard speeds. Golf cart speed is often controlled by a device called a governor, and you can adjust the governor on a golf cart relatively easily to make the cart faster.
