Golf-FAQ.com

how to take the governor off a ezgo golf cart

by Miss Kali Eichmann Published 3 years ago Updated 2 years ago
image

Once you have the necessary tools, follow these steps to remove the governor:

  • Disconnect the negative battery terminal from the cart. This will prevent any accidental sparks from occurring.
  • Remove the screws that hold the governor’s cover in place. ...
  • Use the wire cutters to cut the zip tie that holds the wires to the governor.
  • Remove the screws that hold the governor to the battery pack.

General Instructions
  1. Detach the cable from the carburetor. The cable is about the width of a straw. ...
  2. Follow the disconnected cable up to the governor. ...
  3. Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ...
  4. Using your wrench, remove the bolt on the gas pedal shaft.

Full Answer

How do you adjust the governor on an EZGO golf cart?

The governor on a golf cart can be adjusted easily by loosening the tension on its springs using a wrench or screwdriver to get the golf cart going at a relatively faster speed. In some cases, the adjustment can be done by turning the cable nut that connects the cable to the throttle lever in the counter-clockwise direction.

Can you remove the governor on an electric golf cart?

Jan 07, 2022 · Use the wire cutters to cut the zip tie that holds the wires to the governor. Remove the screws that hold the governor to the battery pack. Having taken off your golf cart’s existing governor, you can now place a new one back into its original position and reattach it with screws.

How to bypass the governor on a Yamaha golf cart?

Aug 05, 2012 · Brief description on how to bypass the governor on Club Cars. Now you can impress and destroy your buddy's while racing down the fairways to your balls. Just...

How fast can an E-Z-GO golf cart go?

Replace the Existing Motor. If you really want your cart to go faster, consider replacing the motor with a high speed/torque upgraded electric motor. This is probably the most extreme measure you can take to remedy your speed issue, and you can expect this to cost around $1,000 with labor.

image

How do I increase the speed of my EZ Go golf cart?

One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.Jun 16, 2015

How do I increase the speed of my EZ Go TXT gas?

Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.

How do you adjust the governor on a EZ Go TXT golf cart?

How to Adjust the Governor on a Gas E-Z-Go Golf Cart
  1. Locate the governor arm mounted on top of the rear axle case underneath the cart. ...
  2. Loosen the adjusting locknut on the end of the governor spring. ...
  3. Retighten the adjusting locknut.

How do you speed up a 36 volt EZ Go golf cart?

How to Make a 36 Volt Golf Cart Faster
  1. Remove any unnecessary additions, racks or parts on your golf cart. ...
  2. Power-wash your cart. ...
  3. Check the shaft under the ignition pedal. ...
  4. Put larger tires on the cart. ...
  5. Replace any old or worn-out parts that are causing the cart to move slower than it should.

How fast is a EZ Go gas golf cart?

The fastest gasoline Club Car only goes 19 mph. And the fastest electric EZGO is the 2Five that goes 25 mph. And the fastest EZGO gasoline golf cart also only goes 19 mph.Apr 12, 2021

How do I unlock Freedom mode on EZ Go?

Toggle the forward/reverse switch from the "neutral" position to "reverse" five times in quick succession. After a few seconds, the computer controller will beep four times, indicating it has shifted into the freedom mode.

What is freedom mode on ezgo golf cart?

Flip the run-tow switch back to “tow” and then "run” to escape the diagnostic setting mode. This enables freedom mode and allows the cart to reach a maximum speed of 19 mph. Close the passenger seat cover over the computer controller.Dec 24, 2010

How do you adjust the governor on a electric golf cart?

Basically, an electric speed governor can be controlled by a tiny metal rod that's located by the clutch of your golf cart. First things first: The electric speed governor is connected to a cable. You can adjust your speed by rotating the nut in a counterclockwise rotation.Aug 29, 2019

How do you remove the speed limiter on a electric golf cart?

Part of a video titled How to remove governor on a Club Car golf cart - YouTube
0:00
0:46
You open up this box lap. Here. It looks up look inside. There's 12 cable down right here this leverMoreYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.

Why is my ezgo golf cart so slow?

Low Battery

Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
Jul 14, 2021

How fast can a 36V golf cart go?

12MPH
Standard 36V and 48V golf carts are capable of the same top-end speed (12MPH). You can, however, make your golf cart go faster by doing a couple of things: Larger Tires - You can purchase larger tires.

How to adjust EZ Go cart governor?

To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.

How to remove the black plastic cover on a golf cart?

Remove the screws from the black plastic cover at the rear of the seat. There should be five screws in most models. The engine is in the front of golf carts , underneath this panel. Take off the plastic cover and set it aside with the seats.

How to make a golf cart go faster?

Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.

How to get a cart to move faster?

1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.

How to tell if a gas pedal is a governor?

Follow the thickest cable coming from the gas pedal until your find a small spring wrapped around a metal rod. This is the governor. The spring apparatus will have two nuts, one small nut and one larger nut, holding it onto the rod.

How fast can a golf cart go?

Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.

How to change the speed of a car?

Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...

How Does a Golf Cart Governor Work

Governors play an important role in electric golf carts by limiting the speed they can travel. This is an important safety feature, as it prevents the cart from going too fast and helps ensure passengers’ safety.

How to Take the Governor off a Golf Cart

Removing the governor from a golf cart is a simple process that can be done with common tools. Here’s what you’ll need:

Frequently Asked Questions about Golf Cart Speed Governors

If you’re looking for ways to speed up your golf cart, there are a few things you can do. Start by removing the governor on top of the engine if you haven’t already. If it doesn’t have a governor, then you’ll need to open up the cart and look at the gear shaft to see if it’s turning.

How fast can a golf cart go without a speed control?

A typical electric cart without an upgraded speed control tops out around 12 mph. If you go this route, anticipate an upgrade cost around $700.

What is the maintenance on a golf cart?

This includes battery and wiring inspections, refilling battery water, washing the cart, and anything else mentioned in your specific manufacturer owner’s guide.

How to make a cart faster?

Step 1. The first option to making your cart faster is to replace the electronic speed control. This will enable more voltage to pass to the motor, producing the desired result. Unfortunately, this upgrade is not inexpensive as the unit can run anywhere from $100 to $1,000. Step 2.

How much does it cost to replace a cart motor?

This is probably the most extreme measure you can take to remedy your speed issue, and you can expect this to cost around $1,000 with labor.

Can you own a golf cart?

Owning your own personal golf cart certainly has its advantages, especially if you live in a cart-friendly community or belong to a private country club. As time goes on, the number of electric golf carts replacing gas carts continues to grow. One thing that electric cart owners find themselves wondering, however, is how do you make an electric golf cart faster?

Can you drive a golf cart faster?

It should be noted that the golf cart you are trying to make faster may not be designed to do so. Weigh the options carefully and exercise caution whenever driving a golf cart at any speed. Remember that golf carts are not equipped with seat belts, air bags and other safety equipment that you find in automobiles.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9